The Oscilloscope

2.) Attach the Crocodile clips from the PSU to the ammeter and motor as shown above in the labelled diagram, making sure the voltmeters clips are attached to the motor.

Data Tables and Observation: Fill out the data sheet (below) for the experiment and submit with this form. Recording data carefully

Each laboratory experiment must be read and carefully studied before coming to the laboratory. This must be done to ensure that each student is thoroughly familiar with the principles, procedures, calculations, and anything else with the exercises may be involved.

1. View the three scenarios listed below. You must observe and analyze these as part of the lab.

This document is not meant to be a substitute for a formal laboratory report. The Lab Report Assistant is simply a summary of the experiment’s questions, diagrams if needed, and data tables that should be addressed in a formal lab report. The intent is to facilitate students’ writing of lab reports by providing this information in an editable file which can be sent to an instructor.

To conduct your laboratory exercises, use the Laboratory Manual located under Course Content. Read the introduction and the directions for each exercise/experiment carefully before completing the exercises/experiments and answering the questions.

The Analog Gauge was used to display element for symbol values within a defined value range. As in figure 3.8 I used it to display the speed of the vehicle. I then assigned the minimum and maximum values for it, so as to define its range.

First, obtain a SpectroVis Plus device and connect with its corresponding LabQuest2 device. You need to calibrate by turning on the machine, allow the inner lamp to start heating up, and prepping a blank in the process. Obtain a dry cuvette, fill it with distilled water, and place into the SpectroVis plus device. Before doing so, be sure to wipe the outside of the cuvette with a Kimwipe to clean off any fingerprints that might be present. Fingerprints will skew with the calibration. Once the device notifies you that calibration is complete, click okay and prep for the next part of the lab.

With an amp clamp amps appear on the vertical axis. The scope obtains this type of reading from the magnitude of AC and additionally the phase and waveform can also be

BEFORE CONDUCTING THE EXPERIMENT - You should already have submitted to your teacher an EXCELLENT Investigation Design that included:

Abstract: This experiment introduced the student to lab techniques and measurements. It started with measuring length. An example of this would be the length of a nickel, which is 2cm. The next part of the experiment was measuring temperature. I found that water boils around 95ºC at 6600ft. Ice also has a significant effect on the temperature of water from the tap. Ice dropped the temperature about 15ºC. Volumetric measurements were the basis of the 3rd part of the experiment. It was displayed during this experiment that a pipet holds about 4mL and that there are approximately 27 drops/mL from a short stem pipet. Part 4 introduced the student to measuring

In Week Three through Week Eight, you conduct scientific experiments in an online lab environment. The content of the labs vary with each week but the structure remains the same. This week, review your Week Three lab instructions and assignment to become acquainted with the essential elements of each lab. You are not required to complete the actual lab this week, but rather to locate various pieces of information about the labs to help prepare for completion of the labs in Week Three through Week Eight.

· I set up the apparatus as shown in the diagram. I then placed a

Describe what you did in the experiment, and include methods and materials used. Do not

This is a case study that looks in detail at the properties, process and application of capacitance micrometers. The fundamentals and designs of capacitance micrometers are analyzed in detail in order to assess their viable use within industry. Suitable comparisons with alternatives to capacitance micrometry measuring techniques are made while looking at the benefits and drawbacks of each with respect to different applications. This case study proves that capacitance sensing is an robust technology to use due both its variety of uses that can be used in a wide range of extreme industrial environments and applications.