Thin Layer Chromatography and Column Chromatography

Adsorption chromatography occurs when “one substance form[s] some sort of bonds to the surface of another one”, creating intermolecular forces between the two substances (Chemguide). For thin layer chromatography, the components of the mixture are adsorbed onto the stationary phase that covers the plate (Chemguide). The more polar a substance is, the more strongly adsorbed it is (Chemguide) and the strong intermolecular forces then result in a slower rate of migration with respect to the moving phase. As the solvent touches the TLC plate, the solute (mixture) is allowed to move up the TLC plate

A glass jar was obtained and filled with 0.5 cm of the solvent consisting of hexane, ethanol, and ethylacetate. The lid was put on so it could become saturated with vapor.

(a) (3 pts.) This video discusses 3 different types of chromatography. List each one mentioned, and describe their differences in as much detail as possible (your points earned will be proportional to the level of detail in your discussion). Which one was used in this lab demonstration?

1. Paper Chromatography is a method used for the separation of colors which are also referred to as colored chemicals/substances or pigments. This method is used for experiments, to identify coloring agents and to separate out a compound into its various components.

Thin Layer Chromatography (TLC) works in relation to the polarity of chemicals. A plate is first covered with aluminum foil or silica etc. and has solutions of varying polarities placed upon the aluminum foil or silica. When placed in a in a puddle of solvent that moves up the plate, the different inks i.e. the solution will move up the place based on their Rf values. Adherence increases with increasing polarity, so the less polar compounds will be carried farther by the solvent. Eventually the dyes will separate into their compontnets, which can be visibly seen. This is then used to determine who the ink of the unsigned note belonged to along with the pen that it belonged

Chromatography is a fairly simple process. First, you put a dot of ink(or in our case, the M&M food dye) near the bottom of some chromotography paper (also known as filter paper), and then hang the paper vertically with its lower edge (the one closest to the spot of dye) dipped in a solvent (In our case, the sodium chloride solution). Capillary action forces the solvent to travel up the paper, where it meets and dissolves the ink. The dissolved ink (which is the mobile phase) slowly travels up the paper (the stationary phase) and separates out into its different elements. Another way of describing it is to think of the liquid as an adhesive-like liquids, some of which stick more to the solid and can travel more slowly than others. This is

3. The spectrophotometer was set at 420nm. Distilled water was also used as the ‘blank’.

In 1941 Martin and Synge, described the discovery of liquid-liquid partition chromatography and also laid the foundation of Gas liquid chromatography and High performance liquid chromatography. They also introduced the concept of the Height Equivalent to the Theoretical Plate, which has since been adopted as the measure of Chromatographic efficiency.

On a thin chromatography plate, five spots were placed ( as shown in table 2) and the plate was developed using chloroform/methanol. This was later visualized with dragendorff’s reagent under the UV light. All separated components were observed, identified and recorded.

Lab 8: Investigation 5 Lab question: How do you separate molecules that are attracted to one another? Procedure: Place a small amount of solvent in separate beakers. Then place the mixture on chromatography paper and put the paper in each beaker. Controls:

In this experiment, the technique of thin layer chromatography is used to identify the identity of unknown. To aid in seeing the spots from the thin layer chromatography, UV light and iodine adsorption is used.

Incorporation of assay controls included setting up a spectrophotomer and running the chart recorder with a full-scale deflection before the start of the assay. The set recorder had a corresponding value of 1 for the change in the absorbance. Therefore, prior testing was done to observe whether a change occurred in the readings. This helped to indicate that the results were valid, as they could have been affected by a fault during the setting up of the spectrophotometer. On the other hand this was considered as one of the controls for the experiment. Nevertheless, a new cuvette had to be used for each assay.

Chromatography is a separation technique in which the mixture to be separated is dissolved in a solvent and the resulting solution, often called the mobile phase, is then passed through or over another material, the stationary phase. The separation of the original mixture depends on how strongly each component is attracted to the stationary phase. Substances that are attracted strongly to the stationary phase will be retarded and not move alone with the mobile phase. Weakly attracted substances will move more rapidly with the mobile phase.

Gel-Filtration Chromatography is a commonly used method used in order purify a protein from a mixture, by means of separations. Different biomolecules differ in size, or their molecular weight. In the gel matrix inside the chromatography column, there are gel beads which are porous to allow certain sized molecules to enter. The molecules that are able to enter the pores of the gel, are held in stationary phase and will elute from the column later on, these are usually smaller, to medium sized molecules. Larger molecules that are not able to fit in the pores will elute out of the column first, they are involved in mobile phase where they just go straight through the column without interacting with the gel beads. Smaller molecules will have a higher elution volume, while the larger molecules will have a lower elution volume. The volume to elute the protein is inversely proportional to the molecules size.

AIM : Thin-Layer Chromatography can show many different characteristics of a mixture. It is recognized for isolation , separation ,identification, and anaylsis of the mixture’s components. The purpose of this experiment is to separate carbohydrates into its pure components such as mixtures of monosacrides by TLC. TLC is used to identify sugars in normal and pancreatic disease urine, the procedure is easy and reproducible .