Types Of Folds

    C.grains of sand-sized particles.     D.gypsum.   Answer Key: A   Feedback: The correct answer is A. silica.     Question 19 of 33 3.03/ 3.0303 Points Which of the following is a diagnostic feature of Specimen #16?

In site one there was a high proportion of very unspherical rocks. According to this the hypothesis is right, in site two there is a lot more smother rocks medium sized and in site 3 there are very small pebbles which are very smooth and spherical. The pebbles get smoother and rounder while it goes downstream. Due to us only taking about 10 rocks our result may have been not right as there were some pebbles which were largely over sized. Most of the other load is dissolved by solution such as limestone and chalk

Shale becomes more predominate at near the top of the formation (Thompson 1970b). Thompson noted that this formation is largely composed of micrite, pelmicrite, and pelsparite, with a significant portion of dolomite also present (1970b). Indications of paleosol formation, sub-vertical burrows, and, in the clay-rich layers, abundant hematite flakes are common of Juniata sediments (Davies 2010 and Thompson 1970b). Each of the three genetic units in this formation, however, have unique lithologic compositions and sedimentary structures (Figure 2).

With our observation of the Shawangunk formation, we see a sedimentary rock formation containing a range of grain size. Such sizes range from pebbles (3cm-5cm), fine-grain sand, and medium-grain sand. There is some grading towards the bottom left of the outcrop known as a reverse grading with some small cross beds present (Figure 2). The grading occurs towards a slight part of the outcrop where we see the grading beginning as fine grain sediments and working up to coarser grain. With moderate sorting we see variations of degree of sorting per bed. As the degree of sorting varies as does the sphericity. The sediment bedding is well seen ranging in sizes of +/--20 cm to 40 cm. This outcrop has thick beds as one can see the basic units with cracks in between each (Figure 3). With mostly tabular beds consisting of sub-angular, and sub-rounded sediments, this outcrop also consists of some ventricular beds (Figure 4). When looking at figure 4, we have a small space of a ventricular bed present. This is because the bed comes in, pinches thicker bedding,

There are coarsening-upward sequences preserved, with flooding surfaces represented by low-relief erosional contact of trough-cross-stratification (runnel) upon low-angle planar bedding (swash zone).

The Lynne deposit lies within the early Proterozoic Penokean fold belt of the southern province of the Precambrian Shield. The fold belt is divided into two major terranes in Wisconsin (Sims 1989). The first is the northern Penokean terrane, which contains major oxide facies iron formations and granitic intrusions (DeMatties 1989). The second major terrane, separated from the Penokean terrane by the Niagara fault zone, is the Wisconsin magmatic terrane, characterized by a volcanic island arc-basin assemblage (Sims 1989). This southern terrane lacks major oxide facies iron formations, but contains abundant tonalite-granite intrusions (DeMatties 1989). The Wisconsin magmatic terrane is further subdivided into the northern Pembine-Wausau terrane and the southern Marshfield terrane, which are separated by the Eau Pleine shear zone, a north-dipping subduction zone (Sims 1989).

Next, we can see that the rock displays a subtle porphyritic texture with plagioclase comprising the phenocrysts. The overall texture of the surrounding groundmass is granoblastic equigranular. Under thin section we also see a weakly defined foliation evidenced in the preferential alignment of actinolite grains and to a lesser extent chlorite grains. Undulose extinction is also observed in quartz indicating the rock was subject to deformation. The normalized quartz, alkali-feldspar, and plagioclase (QAP) values of this rock indicate that it is classified as a grano-diorite according to the IUGS QAPF classification system which is consistent with the hand sample interpretation.

Holmes, Garnett, Bureau of Plant Industry United States, and Bureau of Chemistry and Soils United States. Soil Survey of The Yuma Area, Arizona-California. N.p.: Govt. print. off., 1905

One of the major things noticeable from the cross section is that quite a few of the rock layers are over turned, where the older rock layers are above the newer rock layers. This is seen in the contact between the Quartz Monzonite of Papoose Flat and the Campito Formation which is also a disconformity. Next there is some fault zones separating the Camptio, Poleta, and Harkless formations. We then see some more overturned layers with the contacts between Saline Spring Valley Formation (lower and upper members) above the Mule Spring Formation along with some inferred folding. With a normal fault separating the inferred folding event, we see where the overturning occurs. In between the Cambrian layers we see Tertiary Basalt nonconformities also being folded, thus with that we know that the folding event was more recent than the formation of the Basalt. Next there is a large Basalt field with a spot of the Harkless formation. Again we see over tuning as the Basalt field ends there are the Devonian and Mississippian rock Layers on top of the basalt. Separating these overturned layers from the Harkless Formation and the Saline valley Formation (upper member), which are not overturned, is a thrust fault. From this information, there was a major stress event sometime after the Tertiary period causing the rock layers to fold and overturn. And from this stress event and from the folding, normal and thrust faults are formed. Finally we see that there were alluvial and landslide deposits from the Quaternary after the folding, faulting, and over

The latest rocks in this region were formed in Pleistocene time as imperfectly consolidated gravel of river terraces and alluvial deposits of the

These are soils consisting predominantly of unaltered mineral material that have no surface/sub-surface horizon attributed to soil forming processes (unless buried under a 730cm thick deposit from the Holocene) (Avery, 1980;). These soils do not normally have continuous vegetation cover (Avery, 1980). They occur in very recently formed soil and may have a superficial organic or organo-mineral layer less than 5cm thick. Sometimes they have a buried horizon below 30cm of depth. (Thompson, 2007; Jarvis, 1984).

At Laurel Hill Duke Forest there is a large granodiorite cliff adjacent to a river on one side. This cliff is not smooth and has several parallel fractures instead of one steep slope. Observations of this cliff were taken in order to gather data and find possible explanations for why this cliff is where it is located and why the river adjacent to it follows a V-shaped path. One observation was that the range of the strikes and dips of the fractures facing river were all near parallel ranging from strike of 170-190 degrees and dips ranging from 70-90 degrees. There were other fractures oriented differently on other sides of the outcrop. Also, the surface of the outcrop was highly weathered in some parts where the rock type was not distinguishable without using a rock hammer and had moss growing over it.

The objective of the trip to Blount Springs, Alabama was to observe and gather data on the geological structure of the area. Blount Springs is located in the northern part of Alabama just 33 miles north of Birmingham, and lies on the southernmost part of the Appalachian fold belt. The field work began on the morning of Saturday April, 7th at 8:50am. The weather was cloudy with temperatures in the mid 40’s, and the area was wet from rain the previous night. Our materials included a map of the area, list of formations, a Brunton compass, and a Rite in the Rain field book. The procedure of the field work involved 12 stops at outcrops to gather data, one stop was omitted from the original plans. This data gathered included bedding and joint orientations

Orovado soils are well drained and formed in Alluvium derived from mixed rock sources and in volcanic

In Figure 2 the Southeast Transect is located in the south end of Marlatt Park, near the South Parking Circle. The transect starts west at elevation of 1280 feet and progresses to the east ending at an elevation of 1260 feet . Compared to the high starting points in the previous transects, the overall elevation is lower and the topography is more gentle. The transect starts in a relatively flat area and slopes gently to the east in the first few plots, where limestone is present. The slope increases in Plot 3 were the parent material changes to shale.The transect crosses the east creek and can be seen in Table 3. The soil types vary from Florence in Plots 1 and 2, Benfield in Plots 2 to 6, and 9, and Wymore-Kennebec complex in Plots 7 and 8.