Visual Comparison Between Bacterial And Fungal Amylase

Amylase experiment # 2 was done to see how the pH affected the efficacy of the enzyme. First we collected all of the materials that were necessary to make this experiment. We needed five clean test tubes, the following standard solutions, 1% Starch Solution pH 3,1% Starch Solution pH 5,1% Starch Solution pH 7,1% Starch Solution pH 9,1% Starch Solution pH 11

How pH Affects the Break Down of Starch by the Enzyme Amylase Hypothesis: The optimum pH for the reaction of starch with amylase is pH 7. PH values lower or higher than this value will result in a slower rate of reaction. Amylase works in the range pH 3 to pH 11.

The purpose of this experiment was to determine (1) the reaction rate of an amylase enzyme in starch and (2) the environmental factors that can affect the enzymatic activity. The hypothesis, in relation to the enzymatic activity by variables such as the substrate concentrations, temperature, PH and chemical interactions on the rate of reaction, stated

Hydrolysis of starch for fungal amylase Aspergillus Oryzae and bacterial amylase Bacillus Licheniformis at different temperatures.

During these experimental procedures, the implication of multiple different temperatures on fungal and bacterial amylase was studied. In order to conduct this experiment, there were four different temperatures used. The four temperatures used were the following: 0 degrees Celsius, 25 degrees Celsius, 55 degrees Celsius, and 80 degrees Celsius - Each temperature for one fungal and one bacterial amylase. Drops of iodine were then placed in order to measure the effectiveness of the enzyme. This method is produced as the starch test. The enzyme was tested over the course of ten minutes to determine if starch hydrolysis stemmed. An effective enzyme would indicate a color variation between blue/black to a more yellowish color towards the end of the time intervals, whereas a not so effective enzyme would produce little to no change in color variation. According to the experiment, both the fungal amylase and bacterial amylase exhibited a optimal temperature. This was discovered by observing during which temperature and time period produced a yellow-like color the quickest. Amylase shared a similar optimal temperature of 55 degrees Celsius. Most of the amylases underwent changes at different points, but some enzymes displayed no effectiveness at all. Both amylases displayed this inactivity at 0 degrees Celsius. At 80 Celsius both the enzymes became denatured due to the high temperatures. In culmination, both fungal and bacterial amylase presented a array of change during it’s

To calculate the amylase activity in the germinating barley (2g), we needed to know the amount of 0.5% starch used in the reaction tube (5mg) and the time taken to reach the achromic point, to get the average amount of starch hydrolysed / min to reach achromic point for 1mL of Diluted Amylase Extract(DAE), thus, we could get average amount of starch hydrolysed / min to reach achromic point for 25mL of DAE, which was same as the average amount of starch hydrolysed / min to reach achromic point for 5mL of amylase, therefore, we got the average amount of starch hydrolysed / min to reach achromic point for the total volume of the filtrated, non-diluted amylase extract, with knowing the weight of barley grains/germinant used to make the extract, we could calculate the amylase activity as mg starch hydrolysed/min/g barley tissue.

2-1: Which tubes showed that starch or cellulose was still present? Tubes ___4__, ____5__, __6___

This experiment consisted of setting up a control group of starch in various temperature and then placing both fungal amylases and bacterial amylases in a mixture of starch and placing the solution of amylase and starch in various temperatures of water. After a certain amount of time- different amount of time needs to be used in order to have reliable results- iodine is added in a well on spot plates, then two drops of the mixture of amylase-starch is added from each temperature used, by adding iodine into the plates the mixture will show how much starch was hydrolyzed, this is used to calculate the amount of

For this experiment, we have to prepare our phosphorylase which extracted from a potato. We prepared by weighed about 250 grams of peeled potato and cut it into cubes. The extracts then blended with 100mL of 0.1M NaF. After filtered the contents into a clean 250mL centrifuge bottle, we centrifuged it for 3 minutes. Then, separated the supernatant into a centrifuge bottle, which is our phosphorylase preparation. The enzyme assay used in this experiment today is the iodine test. As the iodine reacts with starch, it will form a brown, blue or black precipitate due to the iodine ions forcing into a linear arrangement. The endpoint of the enzyme reaction indicates the presence of starch by using the iodine test to determine. The faster the endpoint is reached, the less active the phosphorylase is.

The effects of temperature on fungal amylase Aspergillus oryzae, and bacterial amylase, Bacillus licheniformis ability to break down starch into maltose was studied. The study determined the optimal temperature the Aspergillus oryzae and Bacillus licheniformis was able to break down the fastest. The starch catalysis was monitored by an Iodine test, a substance that turns blue-black in the presence of starch. Amylase catabolizes starch polymers into smaller subunits. Most organisms use the saccharide as a food source and to store energy (Lab Manual, 51). The test tubes were labeled with a different temperature (0°C, 25°C, 55°C, 85°C). Each test tube was placed in its respective water baths for five minutes. After the equilibration process, starch was placed in the first row of the first row of the spot plate. Iodine was then added to the row revealing a blue black color. The starch was then added to the amylase. After every two minute section a pipette was used to transfer the starch-amylase solution to place three drops of the solution into the spot plate row under the corresponding temperature. Iodine drops was placed in the row. Color changes were noted and recorded. The results showed Aspergillus oryzae was found to have an optimal temperature between 25°C and 55°C and Bacillus licheniformis was found to have an

Abstract This experiment aimed to record the effect of an increasing sodium chloride (NaCl) concentration on the ability of amylase breaking down starch. It was carried out by using increasing NaCl concentrations from 0.10 to 0.50, mixing amylase and starch and adding the salt before Pasteur pipetting two droplets into iodine on a spotting tile until colour change was observed. Results show that an increasing NaCl concentration increases enzyme reaction rate. Introduction Amylase, an enzyme, breaks down starch into glucose.

Hypothesis: If we decrease the level of pH in the enzyme Amylase, it will not be able to denature the carbohydrates in the potato starch solution after 10 drops because enzymes are very sensitive to pH levels and lowering it too much will compromise its ability to break them down.

In this lab our group observed the role of pancreatic amylase in the digestion of starch and the optimum temperature and pH that affects this enzyme. Enzymes are located inside of cells that increase the rate of a chemical reaction (Cooper, 2000). Most enzymes function in a narrow range of pH between 5 through 9 (Won-Park, Zipp, 2000). The temperature for which enzymes can function is limited as well ranging from 0 degrees Celsius (melting point) to 100 degrees Celsius (boiling point)(Won-Park, Zipp, 2000). When the temperature varies in range it can affect the enzyme either by affecting the constant of the reaction rate or by thermal denturization of the particular enzyme (Won-Park, Zipp, 2000). In this lab in particular the enzyme, which was of concern, was pancreatic amylase. This type of amylase comes from and is secreted from the pancreas to digest starch to break it down into a more simple form called maltose. Maltose is a disaccharide composed of two monosaccharides of glucose. The presence of glucose in our experiment can be identified by Benedicts solution, which shows that the reducing of sugars has taken place. If positive the solution will turn into a murky reddish color, where if it is negative it will stay clear in our reaction. We can also test if no reduction of sugars takes place by an iodine test. If starch is present the test will show a dark black color (Ophardt, 2003).

Amylase is an enzyme that is in human’s saliva as well as the pancreas. Enzymes are biological catalysts that speed up a chemical reaction. They break down complex molecules into simple ones. In this case, amylase converts starches (complex molecule) into simple sugars. That is why foods like potatoes for example, may taste sweet to us, because they contain starch. The optimum pH for pancreatic amylase is the pH of 7. In the experiment I have used buffer solutions with the pHs of 2.8, 4 and 6.5. I have also used iodine and starch. Normally, iodine is orange-yellow, however when you add starch to it, the solution will turn blue-black.

In this lab we looked at the role of pancreatic amylase in the digestion of starch and the effect that temperature and pH has on this enzyme. Enzyme’s work as catalysts that increase the rate of chemical reactions within cells (Cooper, 2000). In order to do this, enzymes must show two essential properties: these two fundamental properties of enzymes include increasing the rate of chemical reactions without being eternally altered by the reaction and accelerating the reaction rate with keeping the reactants and products in chemical equilibrium (Cooper, 2000). Enzymatic catalysis is necessary for life. Most biochemical reactions would not occur under the mild temperatures and pressures