Water Shortage Of Clean And Drinking Water

Hydraulic fracturing is also known as “fracking” is a technique which involves drilling down, then horizontally as far as 10,000 feet below the surface to release natural gasses stored in the sedimentary rock known as Shale. The channel is then encased with concrete or occasionally steel to allow millions of gallons of water to be injected into the wellbore. Most water used in fracking comes from surface water sources such as rivers, lakes, or other accessible bodies of water nearby. Not only is there water being funneled into the wellbore, but also a mixture of sand and other chemicals. When the high-pressure mixture is injected underground it fractures the Shale around the wellbore and creates fissures. The fissures are then held open with

The extraction of natural gas requires a borehole which is dug down to the deep shale formation. After the hole is dug, a steel pipe is inserted into the borehole where it is encased with cement on the outer perimeter of the pipe. A perforation gun is lowered into the cement-encased piping. Using an explosive, the perforation gun perforates the casing and puts initial fractures into the shale at targeted locations. The shale is fractured further by inserting fracking fluids, which consists of 98% water and sand, plus 2% proprietary fluids. The fracking fluids are pushed down into the wellbore and pressurized to 3000 psi causing the initial fracture to spread in the shale, along the shale natural fracture lines. The sand in the fracking fluids keeps the created fractures open which allows the gas from the shale pores to flow into the casing and then to the surface, where it is collected.

Once the well reaches the right depth, it turns right or left and becomes horizontal. This is called the kick off point. The horizontal section can span anywhere from 1,000 to 6,000 feet. The drill is removed but the surrounding steel casing remains. These steel casings are meant to protect the groundwater and the surrounding area from any potential leakage during the fracking process. Down at the horizontal section of the well, little holes are punctured through the steel in thousands of spots. Then, a water solution is pumped at a extremely high pressure down the well. This causes tons of cracks and fissures in the rock. Additives and sand in the water mixture hold the cracks open, allowing oil to escape and be brought up to the surface.

In the process of fracking, the first step is to drill a hole deep into the earth vertically and then to drill horizontally and put in a steel pipe. According to EnergyFromShale.org, water, sand and other chemicals are fed down a thin pipe, or surface casing at high pressure to create cracks in the ground to release any trapped oil. A ton of water is used in this process. EnergyFromshale.com states that almost one-hundred percent of the materials used is water and part sand. According to dangersoffracking.com, one to eight million gallons of water are used for just one fracture per day. It is also stated that forty thousand gallons of chemicals are used to help the flow of the water. That is an immense amount of materials

Hydraulic Fracturing, also known as fracking, is directly linked to having effects on the environment and the overall public health. The debate on whether or not fracking is too harsh on the environment has been going on ever since the United States has increased its use of this process to obtain more natural resources. Hydraulic fracturing is also directly correlated to having effects on drinking water. The process of fracking includes the injection of water containing other chemicals into the ground to extract natural resources that would otherwise be more difficult to obtain (Hydraulic Fracturing Overview, 2012). Although the process of fracking has resulted in an increase of natural resources, such as natural gas and oil, public health and environmental concerns have arisen. This topic has been the discussion of many people and whether or not there should be some form of government regulation in place, as it is nonexistent to this day. With that said, hydraulic fracturing in the United States has more negative effects on drinking water and the environment over time and should not be used as a means to obtain natural resources.

This paper explores the hydraulic fracturing process, exactly what it is, what the fracturing process does to the earth and the surrounding environment in addition, to the consequences. Hydraulic fracturing is fracturing of rock by pressurization. This process by which oil and natural gas can be forced from the earth. The hydraulic fracturing process takes millions of gallons of clean water, sand, chemicals and pumps them underground at high pressure to break apart rock to release gas and or oil. My research has led me to the discovery that there are as many proponents for fracking as that are those that oppose the process. One thing

Hydraulic fracturing in combination with advancement in directional drilling has made it possible to economically extract oil and gas from unconventional resources. The growth in U.S. oil and gas exploration and production made possible by the increase in use of hydraulic fracturing, has raised concerns about its potential to impact human health and the environment. Concerns have been raised by the public about the effects of hydraulic fracturing on quality and quantity of drinking water resources. The hydraulic fracturing water cycle includes five main activities: the withdrawal of ground or surface water needed for hydraulic fracturing fluids; the mixing of water, chemicals, and proppant on the well pad to create the hydraulic fracturing fluid; the injection of hydraulic fracturing fluids into the well to fracture the formation, the return of injected fluid and water produced from the formation to the surface; and the reuse, treatment and disposal of wastewater generated at the well pad, including produced water (U.S. EPA, 2015). With the water cycle being so massive and prolonged, the presence of potential negative impacts is greatly increased.

According to an article in The New York Times, hydraulic fracturing is best described as the technique used to drill down into the earth using a high pressure water mixture to fracture the rocks and extract the natural gas and oil. Approximately one million wells have been fracked since the 1940’s, most of these are vertical wells that drill into porous sandstone or limestone. New technology has allowed for horizontal drilling to capture gas from shale rock. Water, sand and other chemicals are injected into the rock at a high pressure to create the fractures that release the gas. The chemicals added to the water dissolve minerals, kill bacteria that may plug up the well and

Water is a privilege. Living in the 21first century America, many individuals including myself have forgotten this. Many families all over the world are forced to walk miles for water just to find that it isn't even clean. Water shortage is a problem all over the world, but especially in poor countries like Africa. Because individuals all over the world have to get their water, my class did a water walk to understand their pains, but I would change it by making it longer, carrying more water, and having harsher conditions.

The process of hydraulic fracturing – shooting water, sand, and chemicals at high pressure into underground wells to release natural gas – is a divisive issue: Some say it dumps chemicals into ground water supplies, others argue it causes earthquakes, and still others think it can revolutionize America’s energy industry.

The first step in hydraulic fracturing is drilling the actual well and then inserting a steel pipe into the wellbore. The steel pipe is pierced so that the fluid that is pushed through can penetrate into the target zones where the oil or gas is located ("Hydraulic Fracturing 101," n.d.). These kinds of wells can be drilled thousands of feet below

Before starting the process of fracking the drilling site must be suitable. The site must be four to six acres, cleared from large equipment, and have plastic lines placed for drilling waste . In addition, their must be a water impoundment with about 4 million gallons of water that is collected and stored in order to be pumped into the well. This water is transferred by tanks, trucks, or plastic-lined ponds . Hydraulic fracturing processes begins by drilling a vertical well. The drilling goes through aquifers and dozens of geological layers before it reaches desired location of shale rocked believed to contain natural gas. The drill begins drilling horizontally and a production casing is then inserted into the borehole which is surrounded by cement to case it. Next, a perforating gun is fired to make the shale rock more penetrable. A mixture of water, sand, and various undisclosed chemicals are then pumped in at high pressure in order to fracture/break the shale for the gas to escape. After the fissures in the shale rock occur the natural gas is released through the fissures and is taken up the well to the surface. Last, the water byproduct, also referred to as flow back water or produced water is released and travels back to the surface. The gas that is collected is then processed, refined, and shipped to distributors

Hydraulic fracturing or “fracking” is a process that fractures rock formations in the earth’s surface in order to release hydrocarbons. When these hydrocarbons are released, they flow more freely through the rocks and up to the wellbore, were oil and gas are extracted to (Suchy, 2012). Not all rock formations require a hydraulic fracturing operation to be done because the fluids move freely through rocks that have been naturally fractured. Shale gas reservoirs on the other hand are not permeable and have very few natural fractures; therefore the trapped gas and oil must be extracted by fracking only.

Fracturing is functioned to create fractures in rock formation that increase the volume of oil or natural gas that can be extracted through flow stimulation (EPA, 2018). The fracking method however, should not be largely used because the process requires large quantities of pumping fluids at high pressure into the rock formation, includes fracturing fluids that contain harmful chemicals, demands injection of waste into underground for disposal, needs extraction of natural gas through long vertical pipes and gives no available public baseline data.

As the worlds population grows, it is forced by circumstances that it has created to face the limitations of the worlds resources. Most people in the US have always been fortunate enough to have enough of whatever they wanted. When something they like breaks or wears out, they throw it away or buy a new one, and they often don’t even make an attempt to repair an item. They neglect basic maintenance until they damage their belongings beyond repair, and expect that they’ll always have enough. But some things are beyond their control, beyond there power or financial ability to replace or repair. The world’s drinking water supply is one of these without concern, without attention, without preventative maintenance and reclamation and