Week 4 B IP Subnetting Lab Essay

2463 WordsNov 16, 201410 Pages
Introduction Assignment Develop a subnetting plan and implement it in the lab. Configure RIP as a routing protocol. Conditions NYEDGE1 is the hub router. The two remote office routers NYEDGE2 and NYWAN1 connect to NYEDGE1 through serial connections. Each router has a locally attached Ethernet network. The serial line data rates and DTE/DCE settings have already been configured on all three routers. You only need to assign the IP address to the interfaces. Notes The routers are connected directly to each other in this lab and do not actually connect through any leased line services. Diagram Gi0/0 Ethernet NYWAN1 Serial0/1/0 Serial0/0/1 DCE NYEDGE1 Serial0/0/0 Serial0/0/0 DCE Gi0/0 Ethernet Task Index   Task 1 - Create a subnet…show more content…
You are not encouraged to use this subnetwork because it specifies the wire address. Nor should you use the last subnet, 192.50.6.224, because it is considered the major network broadcast address. Therefore you can only use subnets 32, 64, 96, 128, 160 and 192. With this design requirement, you only need to use five of the six usable subnetworks, leaving one for any additional segments in the future. Likewise, for each subnet, you cannot use the first and last address. For example, subnet 192.50.1.32 extends all the way to 192.50.1.63. But you cannot use these two IP addresses (.32 and .63) because they are the wire and the broadcast addresses for this subnetwork. But you can use any of the 30 IP addresses in between. Task 3 - Configure the interfaces in each router Step 1: Configure Gi0/0, s0/0/0, and S0/0/1 for NYEDGE1. Action: ip address <ip address> < subnet mask> Result: NYEDGE1>enable NYEDGE1#config t Enter configuration commands, one per line. End with CNTL/Z. NYEDGE1(config)#int g0/0 NYEDGE1(config-if)#ip address 192.50.6.33 255.255.255.224 NYEDGE1(config-if)#no shut NYEDGE1(config-if)# NYEDGE1(config-if)#int s0/0/0 NYEDGE1(config-if)#ip address 192.50.6.65 255.255.255.224 NYEDGE1(config-if)#no shut NYEDGE1(config-if)# NYEDGE1(config-if)#int s0/0/1 NYEDGE1(config-if)#ip address 192.50.6.129 255.255.255.224 NYEDGE1(config-if)#no shut NYEDGE1(config-if)# NYEDGE1(config-if)#end Explanation: Subnet 192.50.6.32 is assigned to g0/0. Subnet 192.50.6.128 is

    More about Week 4 B IP Subnetting Lab Essay

      Open Document