What Is Mapinfo Software?

Familiarize yourself with the cursor and how it prints out the longitude and latitude of the active map location.

Association: Each station must initially associate with an AP before it can send information through a WLAN. The association maps a station to the distribution system via an AP. For this purpose, a station must establish an association with an AP within a particular BSS. The AP can then communicate this information to other APs within the ESS to facilitate routing and delivery of addressed

Wireless network infrastructure has become just another connection method for corporate and home users alike. This rapid acceptance can be attributed from:

Each site slated for secure indoor wireless had a site survey done. The site survey method was top-down with the roof as the starting point. As with most site surveys the locations for equipment was identified and the cabling pathways were determined. In addition, a wireless survey was performed to identify possible sources of interference and find best install sites for AP’s. This was performed using wireless analysis tools to get the best installation places.

Let’s get started, the project chosen will be the construction of a monopole telecommunication cell tower reaching 150 feet tall. A geotechnical engineer will determine the exact location of the tower after soil samples are taken to determine the location of the caisson and slab foundation of the tower. Following the location determination and the staking of the tower, a shaft will need to be drilled in the ground for the caisson that will later have a steel plate bolted to the tower foundation securing the tower from falling over. The shaft is drilled using a crane mounted drill unit; the hole is drilled through soil or rock to the desired depth which is usually one third to half the height of the tower depending on the soil samples. Steel casings will be used to maintain the sides of the drilling excavation to prevent a cave in.

This scenario is an example of using an access point, which a lot of people currently use to be able to access the internet via WiFi,

Answer: - Coordinate system is actually a reference system which represents the geographic locations, images, GPS (Geographic Positioning System) locations present in a common geographical framework. Hence these coordinate systems allows the geographic datasets to use the common locations for the purpose of integration.

In large installations, the roaming functionality provided by multiple access points enables wireless users to move freely throughout the facility while maintaining uninterrupted access to the network” (Cisco).

The other option I might look into in this scenario is the possibility of perhaps there are too many access points and perhaps a combination of removing and relocating access point could end up giving you the same amount of coverage and or signal strength while being able to remove some possible unnecessary access points

AP 2 would be the best placement in order to reach the entire home becauswe it is centrally located. AP 3 would be the least desireable since it would probably not reach Bedroom A.

RF power can be measured in two ways: on the linear scale, by the number of watts that are being transmitted; and on a relative scale, by the number of decibels (dBs) instead of watts.

* Answer each of the following questions using the sequence and data from the iLab instructions. Answer all questions in full college-level sentences.

My explore pt is GPS, gps is now very useful in our daily life, it is used to navigate, and in our modern life there are several types of GPS that be applied in many different ways like meteorological satellite, and of cause navigation satellite and so on

This report fulfills the specific requirement for documentation as specified in FIT 5083 Assignment 1. In this technical report, we will identify the various steps and techniques used in deployment of wireless network. Initially, what is networking or network infrastructure? Networking mean to connect two or more devices and configure them in such a way that they can communicate with each other. In networking, network infrastructure means to connect the software and hardware part rather than actual connection between two devices. Now days, wireless network connections are highly on demand because it’s easy to access and it does not require any cabling structure.

A wireless computer can "roam" from one access point to another, with the software and hardware maintaining a steady network connection by monitoring the signal strength from in-range access points and locking on to the one with the best quality. Usually this is completely transparent to the user; they are not aware that a different access point is being used from area to area. Some access point configurations require security authentication when swapping access points, usually in the form of a password dialog box.