Photosynthesis Lab Report

Have you ever really wondered how different variables can affect how plants go through photosynthesis? Well, in this experiment, the purpose was to see how various environmental conditions can affect the overall photosynthetic capacity of a specific plant. The factors, light, darkness, cold, and heat were applied to see how the different components would affect the photosynthesis on spinach plants. Each group was given a different factor to test. Out group was given the light factor. The hypothesis for this experiment is that when adding light as a factor, the light will affect the overall plant photosynthesis.

Introduction: Photosynthesis can be defined as a solar powered process that removes atmospheric carbon dioxide and transforms it into oxygen and carbohydrates (Harris-Haller 2014). Photosynthesis can be considered to be the most important biochemical process on Earth because it helps plants to grow its roots, leaves, and fruits, and plants serve as autotrophs which are crucial to the food chain on earth. Several factors determine the process of photosynthesis. Light is one these factors and is the main subject of this experiment. The intensity of light is a property of light that is important for photosynthesis to occur. Brighter light causes more light to touch the surface of the plant which increases the rate of photosynthesis (Speer 1997). This is why there is a tendency of higher rates of photosynthesis in climates with a lot of sunlight than areas that primarily do not get as much sunlight. Light wavelength is also a property of

The purpose of this lab is to observe the effect of white, green, and dark light on a photosynthetic plant using a volumeter and followed by the calculation of the net oxygen production using different wavelengths color of white and green light, and also the calculation of oxygen consumption under a dark environment, and finally the calculation of the gross oxygen production.

The purpose of this experiment was to investigate the effects of light intensity on the rate of photosynthesis in a Moneywort plant. By observing the plant in distilled water mixed with sodium bicarbonate, different light bulbs were targeted onto the plant. The measurement of the amount of bubbles present on the plant during the trial of the experiment enabled us to identify the comparisons between the activity of the light and the process of photosynthesis.

-Measuring the pH of a solution (such as in the lab we had) could also help determine the rate of photosynthesis. You would need a much more specific pH meter, but generally, if pH goes down, the level of CO2 is higher, meaning more cellular respiration. Higher pH means there’s less CO2, so more photosynthesis.

The rate of photosynthesis is affected by environmental factors like light intensity, light wavelength, and temperature. This experiment will test the

Photosynthesis is a vital process that requires to utilize energy for plants. This experiment was done to evaluate the effects of carbon availability on photosynthetic activity. The aquatic plant Elodea densa was placed into sodium bicarbonate solutions of five concentrations ranging from 0.1% to 1.0%, in five independent trials (excluding the negative control treatment of water). The temperature and light intensity was constant. The results indicated a directly proportional relationship between the availability of carbon dioxide and the rate of photosynthesis of Elodea Densa, as photosynthesis continued to increase with increasing amounts of bicarbonate. The most O2 amount of oxygen produced was with the 0.7% NaHCO3 concentration and least with the control of water. The null hypothesis that stated carbon concentration does not affect rate of photosynthesis of the aquatic plant was rejected. The predicted hypothesis that an increase in bicarbonate concentrations results in an increase in the photosynthetic rate was accepted. In conclusion, there is a significant increase in photosynthetic activity as the concentration of NaHCO3 increases.

Photosynthesis is a food making process for algae and plants. The photosynthesis process rate varies from different wavelengths and intensities of light. This lab will evaluate the optimal wavelengths and degrees of intensity during photosynthesis when chloroplast is exposed to light. The mixtures of DCPIP with water, PO4 buffer, and chloroplast will be prepared in a number of cuvettes. The cuvettes were tested individually at different wavelengths and intensities to find the optimal rate of photosynthesis by using a spectrophotometer, measuring the greatest change in absorbance. From this experiment, two data charts and four graphs were obtained. The hypothesis was set from graphs obtained in this lab, and the optimal reaction

The hypothesis that red light would produce more dissolved oxygen was not supported by the results of the experiment. Without having more accurate data it is impossible to say which color light induced its plant to produce the most oxygen. The reason for not having more accurate data is because of the way of testing the dissolved oxygen. By testing with the dissolved oxygen tabs the data could not have been very specific and specific data is important for a good experiment. The way of getting much more accurate data is by testing with the Winkler's method. This way of testing for dissolved oxygen amounts would have not been possible to execute because of the amount of water and the size of tanks used. To test with the Winkler’s method it is necessary to test 200 mL at a time. If this way of testing for

This experiment demonstrates the effects of pH on the rate of photosynthesis by examining the behavior of leaf disks in different pH solutions under light. In this experiment, we used five different pH levels: pH 5, pH 6, pH 7, pH 8 and pH 9. These solutions were created using a combination of hydrochloric acid and sodium hydroxide. Spinancia olcerea or spinach, leaves were used in the experiment to examine the effects of pH on the rate of photosynthesis. The rate of photosynthesis was measured by counting the number of leaf disks that rose to the surface of the solution after each minute. In acidic solutions, the rate of photosynthesis increased while in basic solutions, the rate of photosynthesis decreased.

Photosynthesis is essential to all living organism such as animals and plants. Photosynthesis is a process used by plants and other autotrophs to capture light energy and use it to power chemical reaction that converts carbon dioxide and water into oxygen, carbohydrates and water. (Textbook: Principles of Biology). The reactants and the products of photosynthesis are:

Some flaws in the experiment method are humans errors they can potentially make the experiment invalid. Not every experiment

However, the photosynthetic process can be affected by different environmental factors. In the following experiment, we tested the effects that the light intensity, light wavelength and pigment had on photosynthesis. The action spectrum of photosynthesis shows which wavelength of light is the most effective using only one line. The absorption spectrum plots how much light is absorbed at different wavelengths by one or more different pigment types. Organisms have different optimal functional ranges, so it is for our benefit to discover the conditions that this process works best. If the environmental conditions of light intensity, light wavelength and pigment type are changed, then the rate of photosynthesis will increase with average light intensity and under the wavelengths of white light which will correspond to the absorption spectrum of the pigments. The null hypothesis to this would be; if the environmental conditions light intensity, light wavelength and pigment type are changed, then the rate of photosynthesis will decrease with average light intensity and under the white light which will correspond to the absorption spectrum of the pigments.

This lab was called photosynthesis: understanding photosynthesis. It is a highly complex process that needs to be broken down in many steps to understand how it works. This lab covers the big components in photosynthesis including carbon dioxide intake, light consumption, and varying pigmentation.

The Effect of Light Intensity and Temperature on the Rate of Photosynthesis Aim The aim of my experiment is to determine whether intensity of light and temperature would affect the rate of photosynthesis in a plant. To do this, I will place a piece of pondweed in varying light intensities and temperatures, and observe the amount of oxygen being given off. I am using pondweed because of its unusual quality of giving off bubbles of gas from a cut end, when placed in water. Introduction Photosynthesis occurs only in the presence of light, and takes place in the chloroplasts of green plant cells.