0.10 m/s 6 m/s FRx

Q: A pipe carrying oil of specific gravity 0.877 changes in size from 150 mm at section 1 and 450 mm at…

A: Given data Specific gravity(SG) = 0.877 Diameter at section 1 = 150 mm Diameter at section 2 = 450…

Q: A fan running at 1480 rpm takes in 6 m^3/min of air at inlet conditions of P_1=950 mbar and T_1=15^0…

A: Given, Speed,  N=1480 rpm Volume rate, Q=6m3/min Inlet pressure, P1=950 m bar Inlet Temperature,…

Q: A jet of water moving with a velocity of 20 m/s impinges on a curved vane, which is moving with a…

A:

Q: 2. A closed conical tank is full of water with a pressure of 10. kPa at the top. An orifice on the…

A:

Q: The water in a divergent duct has an incompressible flow. If the inlet velocity and area are 10 ft/s…

A:

Q: A centrifugal pump is required to pump water to an open water tank situated 4 km away from the…

A:

Q: Water at 20°C is pumped at a constant rate of 9 m3/h from a large reservoir resting on the floor to…

A:

Q: Water flows from a nozzle with a speed of V = 10m/s %3D and is collected in a container that moves…

A: Velocity of stream wrt. ground = V = +10 Velocity of container wrt. ground = Vcv = -2 ( opposite…

Q: A reducing elbow is used to deflect and accelerate the flow of water from a horizontal pipe to 30 °…

A: Given: The pipe angle, θ = 30° The mass flow rate, m = 14 kg/s The cross-section area at inlet, A1 =…

Q: the diameter of a pipe in section 1 is 9 cm. if the velocity of water flowing through the line at…

A: Given data:

Q: A boat moved by jet propulsion discharges water through a jet of area 0.02 m2; the water being drawn…

A:

Q: A tank with openings 1, 2, and 3 is moving to left at a speed of 25 km/h. Knowing that D1 = D2 = 20…

A: Consider the diagram shown below with the velocities of flow. The velocity of the tank is The…

Q: A reducing elbow is used to deflect water flow at a rate of 30 kg/s in a horizontal pipe upward by…

A: This problem is related to fluid mechanics. Fluid mechanics is the subject of mechanical engineering…

Q: Which of the following head is neglected in ideal Bernoulli's Energy equation   1. Head loss due…

A: Bernoulli's equation is nothing but another version of conservation of energy

Q: p = 1000 kg/m³. Figure 2 shows water is pumped from tank A to tank B. The water flows through a pipe…

A: Given:d=15 cm =0.15 ml=564 mL=2096 mρ=1000 Kg/m3

Q: A large, enclosed (pressurized) cylindrical tank 3 meters high contains 2.8 meters of oil (s.g. =…

A:

Q: The cart in the figure below is accelerated along a level track by a jet of water that strikes the…

A:

Q: Water enters a centrifugal pump axially at atmos- pheric pressure at a rate of 0.12 m3/s and at a…

A:

Q: A 90° elbow shown in Figure 5 (a) is to direct water flow upward at a rate of 50 kg/s. The water is…

A:

Q: Exhaust gas from a tailless helicopter turbojet engine flows through the three 0.95-ft-diameter…

A: Given data: d=0.95 ftQ=480 ft3/s Need to determine the angular velocity of the rotor.

Q: A 20 mm diameter pipe forks, one branch being 10 mm in diameter and the other 15 mm in diameter. If…

A:

Q: : The figure show a pump drawing water from a reservoir at point 1 and discharging it into another…

A:

Q: A tap discharges water evenly in a jet at a velocity of 2.6 m/s at the tap outlet, the diameter of…

A:

Q: If the velocity of water is 8m/s and the pressure is 140 kPa on the discharge side of a pump,  What…

A: Given data: At discharge side of the pump: Velocity of water, vd=8 m/s and pressure, Pd=140 kPa. At…

Q: Vz = 5 m/s Az = 0.9 m² Water A = 0.3 m² V = 15 m/s A water jet enters horizontal section of the…

A:

Q: Q5. Two tanks A and B of surface areas 600 m2 and 300 m2 are connected by an orifice of 0.18 m2 in…

A:

Q: Water enters the impeller of a centrifugal pump radially at a rate of 45 cfm (cubic feet per minute)…

A: Assumptions: The flow is steady in the mean. Irreversible losses are negligible. Take the density of…

Q: Determine the magnitude and direction of the resultant force exerted on this double nozzle by water…

A: force a force is any influence that, when unopposed, will change the motion of an object. A force…

Q: A 60-kg ice skater is standing on ice with ice skates (negligible friction). She is holding a…

A: The density of water is The mass flow rate of the water at the nozzle exit can be determined as,

Q: In a Francis turbine, the pressure gage in the turbine casing reads 394 kpa. The elevation above…

A:

Q: 3. In the figure shown, oil with specific gravity of 0.80 flows down at the rate of 15 m³/s. The…

A:

Q: A jet of water having a velocity of 30 m/s strikes a series of radial curved vanes mounted on a…

A:

Q: a water pipe is used to pump water through a nozzle that has a radius 3.5 cm at the rate 300 L/s .…

A: Given data as per questionRadius of the nozzle =3.5cmFlow rate =300 litrs/s= 0.3 m3/sRadius of the…

Q: The lawn sprinkler shown in the figure rotates in the horizontal plane. A water flow of 15 L/min of…

A: Find the torque and angular speed of the sprinkle. Given data :- Flow rate in = 15 L /min

Q: Q2: Water flows through a tube with a diameter of A (mm), and ends with a nozzle in the form of a…

A: According to Newton's second law of motion, the rate of change of linear momentum in x-direction of…

Q: is 11.75 m/s. The hose makes a 180° turn before the water is discharged. Disregard the weight of the…

A:

Q: A pump delivers 25 L/s of water with a head of 35 m and runs at a speed of 2950 rpm for 8 hours per…

A: Given Data Shaft power=11.5 kW Efficiency of motor=84% Cost of electricity=15 cents per kWh

Q: Water enters a centrifugal pump axially at atmospheric pressure at a rate of 0.09 m3/s and at a…

A: Given: The rate of the water enters the centrifugal pump is Q=0.09 m3/s. The velocity of the water…

Q: garden hose attached with a nozzle is used to fill a 20 Liters bucket. The inner diameter of the…

A:

Q: A 2-in water jet with a velocity of 130 fps strikes a single vane moving in the same direction of…

A: Given: Jet diameter, d = 2 in = 2in1 ft12 in = 16ft Jet Velocity, V=130 fps Vane velocity, u=50 fps…

Q: Water enters vertically and steadily at a rate of 10 L/s into the sprinkler shown. Both water jets…

A: Consider the diagram shown below for the sprinkler. The volume flow rate of the water from the…

Q: Determine the magnitude and direction of the resultant force exerted on this double nozzle by water…

A: Fluid Mechanics: It is a branch of physics in which concerns with mechanics of fluids & forces…

Q: A jet issued of water at the rate of  200 L/s and a velocity of 36 m/s strikes a blade moving  in…

A: Let a jet of water strikes a moving blade at the centre of the plate which is moving with a uniform…

Q: Q3. Water enters a tank of diameter DT steadily at a mass flow rate of min. An orifice at the bottom…

A: Drawing the figure as shown below -   In sections 1 & 2 the tank is open to atmosphere and…

Q: Water flows through a constricted pipe at a uniform rate. At one point, the diameter of the pipe is…

A:

Q: A water jet strikes a moving plate at velocity of 10 m/s as the plate moves at a velocity of 2 m/s.…

A: