0.5 Problem 1 Consider the following closed-loop system with Gp(s) : s+0.5 R(s) E(s) C(s) 1- e-Ts G,(5) T Find the time constant t for the sampled system with T = 2s and for the analog system with the sampler and zero-order hold removed.

Q: For the following transfer functions, find single-term controller (i.e., single pole, or zero in the…

A:

Q: unity feedback system has a forward transfer function given below. Find the value of K to yield a…

A:

Q: The conventional sampling theorem states a signal x(t) must be sampled at a rate greater than its…

A: The conventional sampling theorem states a signal r(t) must be sampled at a rate greater than its…

Q: 1.Find the impulse response of the equivalent system (i.e,, find h[n]) such that y[n]=x[n]∗y[n]holds…

A:

Q: A second order pressure transducer has an undamped natural frequency of 300 rad/s, damping ratio of…

A: The sensitivities are K1  = 10-6 V/N/m2K2 =5 mm/mV =5000mm/VAmplitude A=1000 N/m2so, Amplitude of…

Q: 4.28 The imperfect second-order PLL is defined as a PLL with the loop filter s+a F(s) = + da in…

A:

Q: Exercise 1: Determine the roots locus of a control system with the following open-loop transfer…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: Q1. A causal discrete-time system is characterized by the difference equation: Уn] %3D у[п - 2] +…

A: The time domain signals can be continuous or discrete. The time domain signals can be periodic as…

Q: b. A second order system settles to a final position in a time of 1.4 seconds in response to a unit…

A: Solution of question (b): Given information about a second order system is the system settles to…

Q: Q3. Given x = Ax, y = x with 1.5 A = Is this system internally stable? Now, consider the following…

A: to check the system stability. as per instruction we must solve the first question only

Q: Exercise 1: Determine the roots locus of a control system with the following open-loop transfer…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: The transfer function of G(s)=(s^2+s+4)/s(s-1)(s+1) is in a closed loop unit negative feedback…

A: The block diagram of the above system can be drawn as below,

Q: The transfer function of a continuous causal DZD system is unstable, SGSÇ as given below. 1 H(s) =…

A: As given, system transfer function                     Hs=1s-3   Feedback System :

Q: 250 Open-loop transfer function of a drug delivery system can be represented by H(s) = s2 +26s+25 a.…

A: Given: Open loop transfer function H(s)=250s2+26s+25 a)  Substitute λ for s in the equation…

Q: Q2: Determine the stability of the closed loop system whose open loop transfer function is; K(s – 1)…

A: Given:    They have mention the open loop transfer function   G(S) H(S)    Nyquist stability…

Q: A system transfer function can sometimes be experimentally determined by injecting white noise n(t)…

A:

Q: Q5. A regulating system controls a process which has a transfer function s+ 10 Gp(s) = s (s + 15) A…

A:

Q: a) Find the input/output difference equation and the impulse response, h(n) of the system. b)…

A:

Q: Q . (a)  If a sinusoidal signal is given as: F(t)=sin a t + sin b t , where a= 5 Hz and b=0.9a…

A: (a) Given: According to Nyquist criterion, the sampling frequency of the signal should be greater…

Q: 19 - A unit step function is applied to the input of a system with negative unit feedback, whose…

A:

Q: Refer to the system shown in figure below Ideal LTI Sampler Assume that, h(t) = 4 sinc(4 t) and the…

A:

Q: PROBLEM: Given a unity feedback system that has the forward transfer function K(s + 2) (s2 – 4s +…

A:

Q: A closed-loop control system is shown in Fig. Q2. (a). Determine the transfer function T(s) =…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: A signal r(t) is band limited to 5kHz; it is sampled at a very high rate of 100kHz using ideal…

A:

Q: The transfer function of G(s)= s^2 +s +4/s(s-1)(s+1) is in a closed loop unit negative feedback…

A: Given: For a unity feedback system, forward path gain Gs=s2+s+4ss-1s+1, Compensator gain=K. The…

Q: (b) Consider a linear, position-invariant image degradation system with impulse response…

A: The equation for the output g(x,y) is given as  gx,y=hx,y⊛fx,y+η(x,y)gx,y= Outputhx,y=Impulse…

Q: a) Convert the analog voltage E(t) = 5 sin(2nt) mV into a discrete time signal and show your answer…

A: According to the question, we need to draw the discrete-time signal of the analog signal Et=5 sin2πt…

Q: A continuous analog signal x(t) is sampled with a sampling rate of 600 Hz. The sampled signal is a…

A:

Q: 2. Determine the range of sampling interval T, that will make the closed loop system shown below…

A: Steps: Find G(s) and then G(z) Then Using G(z) ,find T(Z) Find pole of T(z) Then range of T for the…

Q: R = 170KQ. If Vomax = 10V, determine the minimum slew rate SR (in V/us) for the first op amp such…

A: First find the gain of the second op amp and then apply the basic of slew rate that is change in…

Q: Consider an unknown causal discrete-tima LTI system h(n) as shown in Figure 1(a). If an input x[n]…

A:

Q: 11 - A unit step function is applied to the input of a system with negative unit feedback, whose…

A:

Q: a) Sketch the root locus for the system having open-loop transfer function: K G(s) ·H(s) = s[(s +…

A:

Q: Q1. A causal discrete-time system is characterized by the difference equation: y[n] = y[n – 2]+ x[n]…

A:

Q: A closed-loop control system is shown in Fig. Q2. (a). Determine the transfer function T(s) =…

A:

Q: Q1. A causal discrete-time system is characterized by the difference equation: y[n] = y[n – 2] +x[n]…

A: This question is from "signals and systems". Under which we are going to find out "transfer…

Q: Determine the transfer function and system equation of the following: (a) Gain Factor of 2; Zeros at…

A:

Q: a) Find the input/output difference equation and the impulse response, h(n) of the system. b)…

A:

Q: Consider a system described by the following differential equation: ÿ – 2ý + y = 2u where y and u…

A:

Q: Find the single-variable impulse-response function of each system described in Question 1, which is…

A:

Q: (s+10) s2+5s+6 - Rts)- Gs) HG) Fig. Q3. Closed-loop system with non-unity feedback (a) Compute the…

A:

Q: The transfer function of a continuous causal LZD system is given below is BIB0 undecided. 1 H(s) S-3…

A:

Q: A linear-time invariant system is schematized by the signal-flow diagram represented in Figure 1. Hz…

A: Given signal flow diagram shown

Q: For the system described by its open loop transfer function: G(s) = k* s+0.5 / s2+2s+5  Construct…

A:

Q: 1. The purely imaginary poles generate the following components in time domain:     Decaying…

A: From the Basic Laplace transform pairs for sinusoidal signals we can manipulate the poles on…

Q: My Figure 1 The system shown in Figure 1 simulates two masses. The mass of the engine and the car…

A: In this circuit, we need to draw the free body diagram and differential equation.  If all initial…

Q: Q5. A regulating system controls a process which has a transfer function 8+10 G,(s) = s (s+ 15)…

A:

Digital to Analog Converters

Digital to analog converters are commonly known as DAC, digital analog converter, D2A, or Digital-to-Analog converters. DACs are one of the important devices used in the electronics and electrical domain. DACs are the systems that convert a digital signal into an analog signal, whereas an analog to digital converter or ADC performs the opposite function. Digital signals are those signals that can represent the information or data as a set of discrete values. At a particular instant of time, a digital signal can only take a particular value of data. A digital signal is characterized by two unique values; zeros and ones, or true and false, represented by the Boolean domain. These are also known as binary signals or logic signals. Unlike digital signals, an analog signal is represented by continuous values, where at any time instant, the analog signal is represented by a real number.