1-30. The Newtonian fluid is confined between the plate and a fixed surface. If its velocity profile is defined by u = (8y-0.3y²) mm/s, where y is in mm, determine the force P that must be applied to the plate to cause this motion. The plate has a surface area of 15(10³) mm² in contact with the fluid. Take μ = 0.482 N.s/m². 4 mm Prob. 1-30

1-30. The Newtonian fluid is confined between the plate and a fixed surface. If its velocity profile is defined by u = (8y-0.3y²) mm/s, where y is in mm, determine the force P that must be applied to the plate to cause this motion. The plate has a surface area of 15(10³) mm² in contact with the fluid. Take μ = 0.482 N.s/m². 4 mm Prob. 1-30

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter8: Centroids And Distributed Loads

Section: Chapter Questions

Problem 8.114P: Determine the resultant force acting on the elbow of the thin-walled pipe when the pipe carries a...

See similar textbooks

Similar questions

The gauge pressure of the air at A within the closed tank is 200 kPa. The tank has a width of 1.90 m . ρw = 1000 kg/m3. Determine the resultant force acting on the plate BC and CD caused by the water.
Which of the following quantities have the dimensions of adistance? (a) vt, (b) 12at2, (c) 2at, (d) v2>a
If air within the tank is at an absolute pressure of 680 kPa and a temperature of 70°C, determine the weight of the air inside the tank. The tank has an interior volume of 1.35 m³
A tank contains a liquid of relative density 0.80. The height of the tank is 4, and the width of the tank is 2m. The tank is subjected to the acceleration of 5m/s^2 along a 30o inclined plane in the upward direction. Under this condition, there is no loss of liquid. determine the slope of free surface determine the pressure at point A and point B
Determine the resultant force acting on the elbow of the thin-walled pipe when the pipe carries a uniform internal pressure p0.
Determine the mass of air that has entered the rigid tank if it has a volume of 0.75 m3 and initially contains air whose density is 1.18 kg/m3. The tank is connected to a high-pressure supply line through a valve. The valve is opened, and air is allowed to enter the tank until the density in the tank rises to 4.95 kg/m3. Express your answer in 2 decimal places and in kg.
Determine the viscosity of the oil whose density is 920 kg / m ^ 3, which lies between the flat plates shown in the figure, if the top plate is moving at a speed of 1.8 m / s and has a density of 1500 kg / m ^ 3.
A tire having a volume of 3 ft3 contains air at a gage pressure of 26 psi and a temperature of 70°F. Determine the density (slugs/ft3) of the air contained in the tire. For air, R = 1.716 x 103 ft-lb/slug-°R.
8 -What is the relative density of the fluid with a density of 1030 kg/m³?a)1.12 B)1.03 NS)10.3 D)0.103 E)0.85
Determine the equivalent mass of the system:
If a cup of cream having a density of 1005 kg/m^3 is turned into 3 cups of whipped cream, determine the specific weight of the whipped cream in N/m^3.
The truck carries an open rectangular container that is 3.5 m wide, 3.0 m deep and 5.0 m long, contains oil of density 869 kg/m3 to a depth of 2.0 m. If it has a constant acceleration of 6.7 m/s2. Determine the total force(in kN) acting at the rear wall of the container.