1 X L1 M1 M2 Y

Q: PLEASE ANSWER IT NOW, I NEED THE ANSWER Find the total external armature current of a dc machine…

A: Specification of DC machine is given as No. of Armature slot  = 120,ConductorSlot=6,Diameter of…

Q: A 160 resistor, an 830 inductive reactance, and a 20 capacitive reactance are in series. A 120V 60Hz…

A: In this question,  We need to determine the current in the circuit.  We know As per ohms law,…

Q: A 220 V three phase motor takes 21,437 W at 0.71 lagging power factor. What is the ine curent?…

A: For 3 phase,P3ϕ=3 VL IL  cosϕ IL =P3ϕ3 VL cosϕ For 1 phase,P1ϕ= VL IL  cosϕ IL =P1ϕ VL cosϕ

Q: Complete the following text with words Pt100 sensors are a specific type of _____(1) detector. The…

A: RTDs, also known as resistance temperature detectors, are a family of sensors whose resistance…

Q: Consider a hardware timer supplied by a synchronous clock source with a frequency of 250 kHz. How…

A: Given: Frequency of synchronous clock, f=250 kHz. Number of counts, n=150.

Q: Solve the average power and dc voltage. What will be the average power if we take the 5-ohm bulb…

A:

Q: Q4: (answer in phasor form) V = 10 cos 4t 552 www 0.1 F a) for the circuit shown bellow v=....... +…

A: impedance of capacitor Xc = 1j wc ohms .  if Z1 and Z2 are connected in series with voltage source…

Q: Write a function using the block diagram shown below: X y X y' o I f

A:

Q: 05. If a latching current for the circuit shown in figure is 2 mA. Obtain the value of minimum width…

A: Given circuit: Latching current for the circuit, IL=2 mA.

Q: Given the equation for Charge q (t) = aebt + 20 calculate the value of Current in Amps at t = 0.08…

A:

Q: Find the steady-state -state magnitude gain excitation of the following circuit : If Nin = с 7 10…

A: Laplace transform is used to convert time domain signal in to frequency domain. Transfer function is…

Q: Given the function displayed below, create a block diagram.  a. F = A B + C b. F = X Y + X’ Y + Y’…

A: This is a basic problem of logic gate function. The solution is given in the next step.

Q: For a certain 12 V zener diode, a 10 mA change in zener current produces a 0.05 V change in zener…

A:

Q: Q1] for the following circuit choose the correct answer Assume that the circuit. operates at @= 50…

A:

Q: If the power of an elementary electric dipole is 100 kW, what should be the numerical value of the…

A: According to the question, if power of an elementary electric dipole antenna is 100 kW. Then we need…

Q: Sketch the following signals: (a) x₁(t) = t(u(t + 2) - u(t− 2)) (b) x₂(t) = x₁(t - 6k) Σ=-1 (c)…

A:

Q: 4.20 A 25-KVA, 2200/220-V, single-phase transformer has an equivalent series impedance of Zel = 3.5+…

A:

Q: The voltage across a 5-kΩ resistor is 16 V. Find the current through the resistor.

A: We need to find out the current through the resistor , we will it find out by using of ohm's law .

Q: A 20 kVA machine has a full load copper loss of 400 W, an iron loss of 150 W, and a mechanical loss…

A:

Q: Show that for a 0 (Hint: Change of variables) 8(at)dt = 1 |a|

A:

Q: Boron gas is used to dope the silicon wafer to a dopant concentration of 1016 / cm³. After letting…

A: given semiconductor questions

Q: ADM system is designed to operate at 3 times the Nyquist rate for a signal with a 3 kHz bandwidth.…

A: Given,The system is designed to operate at 3 times the Nyquist rate.Bandwisth , BW=3 kHzStep-size,…

Q: Construct a gate circuit using AND, OR, and NOT gates that corresponds one to one with the following…

A: In this question we need to construct a logic gate using AND , OR and NOT gates for the given…

Q: PLEASE ANSWER IT IMMEDIATELY A 10 kW 220 V compound generator (Short Shunt) is operated at no load…

A: Given that: Output power, Pout=10 kW Terminal voltage, Vt=220 V Stray loss, Pstray=705 W Shunt…

Q: Your turn: Determine V3 employing voltage division 102 M 4Ω

A: Given data, Circuit diagram is given as,

Q: Determine the average power supplied to the circuit in Fig. 17.26 if i(t) = 2 + 10 cos(t + 10°) + 6…

A: The above problem is from circuits. The problem can be solved by using superposition theorem.

Q: B- For the ECL logic gate in Fig. 4. Assume VBE = 0.7 V. 1). Determine RE and Re₂ such that I = 2 mA…

A:

Q: Find the rank of the followng matrix For z1, find the rank of matrix A. A = 1 2 1 1 00 Find z such…

A:

Q: If we have Const Pie = 3.14, what is the value of this expression: Pie = Pie +1 Pie = 3.14 Pie =…

A:

Q: For a certain 12 V zener diode, a 10 mA change in zener current produces a 0.05 V change in zener…

A: Given data, Zener voltage Vz=12 V Change in Zener voltage △V=0.0.5 V Change in current △I=10 mA=…

Q: 3. Determine the current i, through the 20-12 resistor. 3A 1 1252 www 45 (22 2012 www 362

A: We need to find out the current through given resistor in given circuit , we will find out by using…

Q: Complete a total table for this capacitor circuit.. (to 3 decimal places) Label all JUNCTIONS 12.0…

A:

Q: A music signal has frequency components from 15 Hz to 30 kHz. If this signal could be used to…

A: Frequency components of music signal = 15 Hz - 30 kHz Carrier frequency fc = 1.2 MHz We have to…

Q: 16V +1 www ΖΩ iL | m 4H

A: Given data, Circuit diagram is given as,

Q: 4. The total capacitance for this circuit is C₁ SF C₂ 10 F C₁ 10 F

A: Given data, Circuit diagram is given as,

Q: Simplify the following expression by applying one of the theorems. State the theorem used. (b) (AB'…

A: The given Boolean expression is, AB'+CDB'E+CD.

Q: Prior to the formation of the depletion region, electrons were injected to the P type silicon from…

A:

Q: For a certain 12 V zener diode, a 10 mA change in zener current produces a 0.05 V change in zener…

A: Given: For a certain zener diode, rated zener voltage, Vz=12 V. Change in zener current, ∆Iz=10 mA.…

Q: Problem 9: Find the Thevenin equivalent circuit for the following circuit with respect to the…

A: Solution !!

Q: How does availability change when mean time between failures (MTTR) gets closer to zero? Is it…

A: MTTR(Mean Time To Repair):- The term "mean time to repair" (MTTR) describes how long it takes to fix…

Q: The current in an inductive circuit is given by 0.3 sin (200t - 40°) A. Write the equation for the…

A: L = 40 × 10-3 H; i = 0.1 sin (200t – 40º) XL = ωL = 200 × 40 × 10-3 = 8 Ω Vm = Im XL = 0.3 × 8 = 2.4…

Q: 4. If Req= 6 ohms, determine R. Rea Tn – — || Ղ R - Տոռ 4 – կռ - 3. - 5n

A: Given

Q: 3. A 10ohms resistor and an unknown inductance is connected in series. The series combination is…

A:

Q: 2. An aging battery generating 200e-5t volts is connected in series with a 20 ohm resistor, and a…

A:

Q: A 10 GHz plane wave travelling in free space has amplitude of 15 V/m. The propagation coefficient ß…

A: Given, Frequency, f = 10 GHz. Free space amplitude, A=15 Vm.

Q: For a certain 12 V zener diode, a 10 mA change in zener current produces a 0.05 V change in zener…

A: We need to find out zener impedance for given current and voltage .

Q: 3. Determine the current i, through the 20-12 resistor. 3 A 1252 www 45023 2002: www 3602

A: Given data, Circuit diagram is given as,

Q: Using one node in the network to hold all the application software done in client-server network O…

A:

Q: Question 47 If a resistor is dissipating 1/4 W, it can supply 1/4 W to the load. True False

A: False. Because, never a resistance supplies power to the load. It is a passive element which means…

Q: Bandwidth of the input to pulse code modulator is restricted to 4 kHz. The input varies from -3.8V…

A: We need to find out the number of bits per sample for given signal to noise ratio and given signal…

Current Division Method

The generalized current divider formula is given by the following relation below,