1. A hydraulic press contains 0.25 m³ of oil. Find the decrease in the volume of the oil when it is subjectedto a pressure increase of 1.6 x 107 Pa. The bulk modulus of oil is 5.0 x 10° Pa and its compressibilityk =:= 20 x 10-6 atm-1. What is the fractional change in volume of the oil?B2. The figure shows a stream of water flowing through a hole at depth h = 17.1 cm in a tank holdingwater to height H = 38.7 cm.H3. As Styrofoam box used to keep drinks cold at a picnic has a wall thickness of 9 cm. it's filled with ice,water, and cans of cola at 0°C. a) What is the total wall area of the Styrofoam box if the rate of heat flowinto the box is 9.5 /s if the temperature of the outside wall is 38°C? b) How much ice melts in five hours?

1. A hydraulic press contains 0.25 m³ of oil. Find the decrease in the volume of the oil when it is subjected to a pressure increase of 1.6 x 107 Pa. The bulk modulus of oil is 5.0 x 10° Pa and its compressibilityk = = 20 x 10-6 atm-1. What is the fractional change in volume of the oil? B

1. A hydraulic press contains 0.25 m³ of oil. Find the decrease in the volume of the oil when it is subjected to a pressure increase of 1.6 x 107 Pa. The bulk modulus of oil is 5.0 x 10° Pa and its compressibilityk = = 20 x 10-6 atm-1. What is the fractional change in volume of the oil? B

College Physics

10th Edition

ISBN:9781285737027

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter9: Solids And Fluids

Section: Chapter Questions

Problem 24P

See similar textbooks

Similar questions

Calculate the pressure due to the ocean at the bottom of the Marianas Trench near the Philippines, given its depth is 11.0 km and assuming the density of sea water is constant all the way down. (b) Calculate the percent decrease in volume of sea water due to such a pressure, assuming its bulk modulus is the same as water and is constant. (c) What would be the percent increase in its density? Is the assumption of constant density valid? Will the actual pressure be greater or smaller than that calculated under this assumption?
The small piston of a hydraulic lift (Fig. P14.8) has a cross-sectional area of 3.00 cm2, and its large piston has a cross-sectional area of 200 cm2. What downward force of magnitude F1 must be applied to the small piston for the lift to raise a load whose weight is Fg = 15.0 kN?
Artificial diamonds can be made using high-pressure, high-temperature presses. Suppose an artificial diamond of volume 1.00 106 m3 is formed under a pressure of 5.00 GPa. Find the change in its volume when it is released from the press and brought to atmospheric pressure. Take the diamonds bulk modulus to be B = 194 GPa.
Pressure in the spinal fluid is measured as shown in Figure 11.43. If the pressure in the spinal fluid is 10.0 mm Hg: (a) What is the reading of the water manometer in cm water? (b) What is the reading if the person sits up, placing the top of the fluid 60 cm above the tap? The fluid density is 1.05 g/mL. Figure 11.43 A water manometer used to measure pressure in the spinal fluid. The height of the fluid in the manometer is measured relative to the spinal column, and the manometer is open to the atmosphere. The measured pressure will be considerably greater if the person sits up.
What effect does capillary action have on the reading of a manometer with uniform diameter? Explain your answer.
During heavy lifting, a disk between spinal vertebrae is subjected to a 5000-N compressional force. (a) What pressure is created, assuming that the disk has a uniform circular cross section 2.00 cm in radius? (b) What deformation is produced if the disk is 0.800 cm thick and has a Young's modulus of 1.5109N/m2 ?
An oil gusher shoots crude oil 25.0 m into the air through a pipe with a 0.100-m diameter. Neglecting air resistance but not the resistance of the pipe, and assuming laminar flow, calculate the gauge pressure at the entrance of the 50.0-m-long vertical pipe. Take the density of the oil to be 900 kg/m3 and its viscosity to be 1.00 (N/m2) s (or 1.00 Pa s). Note that you must take into account the pressure due to the 50.0-m column of oil in the pipe.
The small piston of a hydraulic lift (Fig. P15.6) has a cross-sectional area of 3.00 cm2, and its large piston has a cross-sectional area of 200 cm2. What downward force of magnitude F1 must be applied to the small piston for the lift to raise a load whose weight is Fg = 15.0 kN? Figure P15.6
A 50.0-kg woman wearing high-heeled shoes is invited into a home in which the kitchen has vinyl floor covering. The heel on each shoe is circular and has a radius of 0.500 cm. (a) If the woman balances on one heel, what pressure does she exert on the floor? (b) Should the homeowner be concerned? Explain your answer.
(a) Suppose a blood vessel's radius is decreased to 90.0% of its original value by plaque deposits and the body compensates by increasing the pressure difference along the vessel to keep the flow rate constant. By what factor must the pressure difference increase? (b) If turbulence is created by the obstruction, what additional effect would it have on the flow rate?