1. Describe in generic terms the type of unit you think this is based on your interpretation of the wiring diagram below. Example: 115v Mini-Split Heat Pump 2. Then tell us what item or items in this electrical circuit is always energized?

Name three parameters that a no-load/open circuit test could measure for you

The waveform of a voltage source is shown in the given figure. Let A = 2 and B = -3.8. Determine the average current supplied to a 10-ohm resistor connected across the voltage source.  The average current supplied to a 10-ohm resistor connected across the voltage source is  ______A.

A common practice for electricians is to use a clamp-on ammeter to measure the current flow on each ungrounded conductor of a service entrance when all the house electrical loads are connected. Discuss what kind of information can be found by using a clamp-on ammeter in this way.

You just moved into a new house and notice that the bathroom light and hall light will not turn on unless the switch for both lights is in the on position. What can you conclude about the lights? a. The hall light and bathroom light are wired in parallel. b. The light switch for the bathroom resets a breaker for both lights C. The hall light and bathroom light are wired in series. d. The hall light and bathroom light must have two separate power sources. e. Two of the above.