1. In the parallel reaction , rate constants k1 and k2 were determined to be 0.15 min^(−1) and 0.06 min^(−1), respectively. Determine the half-life for species A. Starting with the initial concentration of A at 0.10 mol.dm−3, calculate the time t at which [C] will be 0.05 mol.dm^(−3). Obtain the highest concentration of C attainable.

Q: The exhaust duct from a heater has an inside diameter of 114.3 mm with ceramic walls 6.4 mm thick. T...

A: Given data: Inside diameter = 114.3 mm Ceramic walls 6.4mm, the average k = 1.52W/mKThermal conducti...

Q: N2(g) + O2(g)2NO(g)H° = 181 kJ and S° = 24.9 J/KG° would be negative at temperatures (above, below) ...

A: Given reaction N2(g) + O2(g) --------> 2NO(g) H° = 181 kJ  =   181 × 103J S° = 24.9 J/K Assume  H...

Q: What is the %v/v of 10.0 mL of CH3OH (methanol) dissolved in water to a volume of 40.0 mL?

A:

Q: A feed consisting of 30% benzene, 40% toluene, and 30% xylene is separated into a distillate contain...

A: Consider the following distillation column shown in the figure: To Find: xtoluene and xxylene  reco...

Q: (2) Using the method of partial derivatives, express the following partial derivatives in terms of m...

A: It is required to prove ∂H∂VP = βTκ + CvβV using the Method of partial derivatives.

Q: 1. Heating of a Spherical Particle Consider a solid spherical particle of radius R and thermal diffu...

A: First consider a sphere of radius R and the thermal diffusivity α Now to get governing equation for ...

Q: The equilibrium constant, K., for the following reaction is 9.52×10-² at 350 K. CH4 (g) + CC14 (g) =...

A: The given reaction is CH4(g)+CCl4(g)⇔2CH2Cl2(g) Equilibrium constant for the reaction is 9.52×10-2 a...

Q: 23. Show that in the limit of infinite dilution, the reduced viscosity and inherent viscosity are eq...

A: Reduced viscosity is defined as the ratio of specific viscosity to the concentration of the substanc...

Q: How do i find the specific heat of Zinc when mass: 20.422g volume of water: 50.5 initial temperature...

A: Given that, Mass of metal mM = 20.411 g Volume of water VW = 50.5 mL Mass of water mW = 50.5 g Initi...

Q: Make a table as required in the illustrated example with commentary on the amount of heat transfer l...

A: Given: m=3.416 h=11W/m2K   (Taking SI units as proper units are not given in question) k=377 W/mK  (...

Q: Experiments are conducted on the uptake of a water pollutant in water over an adsorbing solid. Once ...

A: Given: Pollutant is adsorbed over solid  After reaching equilibrium the concentration of pollutant i...

Q: Can a homogeneous or solid catalyst be used in reactive distillation?

A: It is to be mentioned whether homogeneous or solid catalyst can be used in reactive distillation.

Q: What is the value of the equilibrium constant at 298 K for a reaction that has a ΔGo of +64.29 kJ/mo...

A: Given Data: ∆G = Change in Gibbs free energy = 64.29 kJ/mol                      T = Temperature = 2...

Q: 1) Consider the infinitely tall, annular mixing tank. The fluid to be mixed is between the inner cyl...

A: Given: Fluid is mixing in an annulus between inner cylinder and outer wall Inner cylinder angular ve...

Q: The mass/volume percent of a solution is given to be 110%. If 20 grams of solute is dissolved in wat...

A: Given Data: volume of solution (in ml) = ? ml                      Mass/volume Percent = 110%       ...

Q: After mixing with the return flow of 20% potassium nitrate solution by 1000 kg by mass per hour, it ...

A: Hello! You have posted multiple subparts to this question. We have answered the first three here.We ...

Q: How many mL of solution will result when 15.0 g of H2SO4 (Molar mass 98 g/mole) is dissolved to make...

A:

Q: Write down the chemical formula of sodium chloride NACI O M9OH2 O dasdjasod O dasdasdas

A: The chemical formula of sodium chloride is to mention.

Q: Titration of 50.00 mL of 0.04715 M Na2C2O4 required 39.25 mL of a potassium permanganate solution.Mn...

A:

Q: Question: 1.5 mol of methane gas, which behaves ideally, with a pressure of 10 bar and a temperature...

A: Given that, Number of Moles of Methane gas = 1.5 mol Initial Pressure P1 = 10 bar Initial Temperatur...

Q: Voltaic cells use spontaneous chemical reactions to generate electricity.  Briefly describe the move...

A:

Q: A process stream contains 4% by weight salt and the rest water. This is prepared by passing a part o...

A: The process diagram and flow streams 1, 2,3 and 4  for the operation can be shown as

Q: The analysis of coal indicates 75 wt% C, 17% H, 2% S, and the balance noncombustible ash. The coal i...

A: The chemical reactions taking place are C+O2→CO2            ........(1)C+0.5O2→CO        ........(2)...

Q: A gas that behaves as an ideal gas has internal energy equal to 457 J/mol at 35°C. What is the speci...

A: Given: Gas behaves ideally Specific internal energy (U)= 457 Jmol Temperature (T) = 35 °C Pressure (...

Q: 46.29 g of KOH is dissolved in 250. mL of water. a. What is the mass percent of KOH in this solution...

A: ( According to Bartleby guideline we can only 3 subparts remaining parts you have to put separately ...

Q: system aluminum copper is drawn below. Answer the following questions by referring to this diagram. ...

A: Given-Phase diagram for a system Al-Cu To find a) concentration of saturated solution of copper in a...

Q: Chlorine gas is to be heated from 110.0°C to 190.0°C. Calculate the heat input required to raise the...

A: Energy balance for closed system can be written as, Q=∆U=∆H-∆(pv)where, Q=heat flow∆U=change in inte...

Q: Oil is cooled from an initial temperature of 96°C to 60°C by water in an adiabatic concentricheat ex...

A:  Given Data:  Tin(oil) = 96 oC                         Tout(oil) = 60 oC                         Tin...

Q: 10. Technetium-99 is an ideal radioisotope for scanning organs because it has a half-life of 6.0 hou...

A: Hello you have posted multiple subparts to the question, we are solving first 3 subparts for you. pl...

Q: Chemical Engineering Question

A: Note: Since we are entitled to answer only 1 question, we'll answer the first one. Please re-submit ...

Q: What does it mean if the IR spectrum of your final product (Cyclohexanone) shows a wide peak between...

A: Cyclohexanone with a wide IR spectrum between 3300 and 3600 cm-1.  

Q: solve i and ii in the image provided.

A: Given that, Mol% of NH3 in gas mixture y1 = 10% = 0.1 Mol% of air in gas mixture = 90% = 0.9 Absorpt...

Q: On a summer day, the air temperature over a lake is measured to be 25°C. Determine the water tempera...

A: Given: On a summer day, the air temperature over a lake is measured to be 25 °C. Required: water tem...

Q: Calculate the vapor pressure above liquid ethanol (ethyl alcohol) at 35 o C when Ar is added until t...

A: To calculate vapour pressure we will use antoine equation: lnpsat.=A-BT+Chere psat. is vapour pressu...

Q: Question 3 Mixed acid is prepared by blending : (i) 125 kg, spent acid containing 11.3% HNO3, 44.4% ...

A:

Q: Derive the explicit expression for ̄Cp− ̄CV for a van der Waals gas.

A:

Q: Chemical Engineering Question

A: Given data: Composition of fresh feed is, Benzene = 45 mass % Xylene = 55 mass % Mass flow rate of t...

Q: 2.82 A gaseous fuel consisting of a mixture of methane (CH4) and ethane (C2H6) is fed into a burner ...

A: Hi and thanks for the question. Since you have posted a question with multiple sub-parts, we will an...

Q: 1

A:

Q: A wet Streom at l00.0 bar quall ty foactor of O,990 defective st eom tropp aud with leaks through ex...

A: Given: Inlet Pressure of wet stream P1=100 bar Quality factor =0.99 Exit pressure of wet stream P2=1...

Q: The analysis of coal indicates 75 wt% C, 17% H, 2% S, and the balance noncombustible ash. The coal i...

A: The balance equation for the reaction is as  C+O2→CO2C+0.5O2→CO2H+0.5O2→H2OS+O2→SO2 Assuming 5000kg ...

Q: feed consisting of 30% benzene, 40% toluene, and 30% xylene is separated into a distillate containin...

A: Note: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question...

Q: You are tasked with investigating the process of converting 10 moles ofice at -5°C and 1 atm to stea...

A: