Engineering

Electrical EngineeringQ&A Library1.- You have a 1.5V Energizer battery of Nickel-Metal Hydride, which provides us with up to 2500 mAh. We want to charge it slowly for 10 hours. Propose a circuit that gives us the necessary current to be able to fully charge it in that time. You can only use 2 +/- 5V voltage sources. What is the power of the emitter resistance?Start your trial now! First week only $4.99!*arrow_forward*

Question

1.- You have a 1.5V Energizer battery of Nickel-Metal Hydride, which provides us with up to 2500 mAh. We want to charge it slowly for 10 hours. Propose a circuit that gives us the necessary current to be able to fully charge it in that time. You can only use 2 +/- 5V voltage sources. What is the power of the emitter resistance?

Tagged in

Engineering

Electrical Engineering

Find answers to questions asked by students like you.

Q: Calculate the power delivered by 10 V source using A) Superposition B) By creating Norton equivalen...

A: We’ll answer the first question since the exact one wasn’t specified. Please submit a new question s...

Q: Given a 115kV/13.2kV distribution transformer rated at 30 MVA (OA) with an 8% nameplate impedance (P...

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3.Please resubmit the question and ...

Q: Find the Norton equivalent to the left of terminalsa and b of the circuit shown in Figure P3.54.

A: To find the Norton equivalent find the equivalent resistance as seen from the terminals ab by short-...

Q: 1. Determine the numerical value of Vr. 30 V 15 N 15 V 2 A 10 2 х

A: The circuit diagram is:

Q: 26 CHAPTER 2 Symbols and Schematic Diagrams REVIEW QUESTIONS 7. Referring to the circuit in Figure 2...

A: Hi. Thank you for the question. Since there are multiple questions present in the image and you have...

Q: What is the angular frequency w of the AC current i(t) = 40cos(5t+60°) A?

A: The standard expression of the AC current is, Here, ω is the angular frequency of the current.

Q: By using SuperMesh Find :-- All equations- Find Ix- Find Power of Ib

A: Given circuit is –

Q: 21 3 2017 For this circuit, determine the value of re. The circuit values are as follows: RF = 150 k...

A: Apply KVL in the path indicated by the arrow.

Q: The output voltage of an opamp is v(t)=10sin(200t) V. Find out the value of the slew rate of the op...

A: The slew rate (SR) of an operational amplifier (opamp) is defined as the maximum rate of change in t...

Q: Transmitted power by a radio is 50 mw. Express the transmitted power in terms of dBm.

A: dBm is the power expressed in decibels where the reference power is 1 mW. Transmitted power (Pt) by ...

Q: What is the node voltage at the green dot?

A: Given circuit is –

Q: 3. A single-phase 100-kVA, 7200-V/120-V, 60HZ distribution transformer is used as a step down transf...

A: transformation ratio, primary side impedance, secondary side impedance, primary and secondary side c...

Q: Solve part a & b

A: Schematic of a 4 to 2 priority encoder with active-high enable input is shown below. Here, the assu...

Q: 6. A 50-kVA, 2400/240-volt, 60HZ single - phase transformer is supplied with power directly from a l...

A: Click to see the answer

Q: Solve for part (a) only. I will take it as reference and solve the remaining by myself. Thanks in ad...

A: If a resistor of resistance R and a capacitor of capacitance C are in series, then the value of the ...

Q: In the circuit shown below, let w = 1100 rad/s, I. = (4.5- 78°) A, IL = (2.4/139°) A. Find: (a) I, (...

A: (a) The voltage across the capacitor is

Q: 4 In the full-wave power supply shown in Figure P9.44 the diodes are 1N4001 with a rated peak revers...

A: (a) Given circuit diagram is - Given values are -

Q: Q3 Consider the following three continuous-time signals with fundamental period of T=1/2: x(t) = cos...

A: Fourier series expansion of a periodic signal is given as Here, Ꞷ0 is the fundamental angular frequ...

Q: Assume that a continuous-time aperiodic signal x(t) is real and odd.

A: Since, it is given that, the function is real and odd, then it can be written as:

Q: A continuous-time signal x(t) is reconstructed from a discrete-time sequence x[n] = e^(j2(pi)fn). Le...

A: Referring to the question, the given points are:

Q: Find Zeq in polar form of follwing picture

A: The equivalent impedance Zeq can also be calculated as Here, Yeq is the equivalent admittance.

Q: Compute the frequency at which the output of thecircuit of Example 6.7 is attenuated by 10 percent(t...

A: The circuit diagram is:

Q: Electromagnetic wave is propagating through a dielectric medium with relative permeability of 2.5 an...

A: The velocity of an electromagnetic wave travelling through a dielectric medium can be determined usi...

Q: If a line of charge with uniform density ρl extends between z=-L/2 and z=L/2 along the z-axis, obtai...

A: Electric field due to charge is given by –

Q: The current through a 0.5-H inductor is given byiL = 2 cos(377t + π/6).Write the expression for thev...

A: The values of current and inductance are:

Q: Q3) A 140-MVA, 13.2-kV three-phase generator, which has a positive-sequence reactance of 1.5 per uni...

A: Part (1.) The MVA rating of the generator is 140 MVA. The voltage rating of the generator is 13.2 kV...

Q: The circuit shown in Figure P3.35 is a simplifiedDC version of a typical three-wire, three-phase ACY...

A: Draw the currents in both the loops.

Q: Use Norton's theorem to find V, in the circuit below. 12 k2 2 k2 10 k2 24 k2 3 mA 1 k2 V. 36 V

A: The circuit diagram is: Norton’s current is the value of the current through the load when the load...

Q: How do I use turn this circuit into thevenin's equivalent to find the voltage between nodes A and B?

A: Click to see the answer

Q: Determine the minimum value and the maximumvalue that the series resistor may have in a regulatorcir...

A: The values of the regulator circuit are:

Q: Calculate the First Null Beamwidth and the gain of a parabolic reflector antenna. The diameter of th...

A: The beamwidth of a parabolic antenna is the angular difference between the point of maximum power ra...

Q: Draw the magnetic field lines for a solenoid (current flowing through many loops of wire wrapped aro...

A: The following figure shows magnetic field lines due to a solenoid. Note: As shown in the above figu...

Q: Calculate the directivity of an isotropic antenna.

A: An isotropic antenna radiates equally in all possible directions. Directivity is a measure of how e...

Q: For the three circuit elelents in the image find Zeq

A: The impedance offered by the inductor and the capacitor is given by, And,

Q: Prove the shifting property of convolution: If xi[n]* x2[n] = c[n], then x1[n-m]* x2[n-p] = c[n-m-p]...

A: if k = -infinity then, k-m = - infinity

Q: Please don't use the Z transform

A: Click to see the answer

Q: A periodic waveform with w0 = 10^5 rad/s is applied to a circuit as shown in Fig. P3.2.3. Determine ...

A: Given the value of the angular frequency: Now the 50th harmonic is given as:

Q: In the RL circuit shown below, the switch is open for a long time and closes at t = 0. If Is = 0.45A...

A: Click to see the answer

Q: R1 R2 х {R1} {R2} V1 U1 out {VIN} For the circuit shown assume the OPAMP is ideal. In terms of V1, R...

A: Referring to the given op-amp, the output of the op-amp is given as:

Q: Derive the expression of narrow band fm

A: The general expression of a frequency modulated (fm) wave is given as

Q: Why to choose active filters over passive filters?

A: A filter is used to remove the undesirable portions of the frequency spectrum of a signal. Active fi...

Q: Find the rms value of each of the followingperiodic currents:a. i(t) = cos 377t + cos 377t Ab. i(t) ...

A: The RMS value to the combination of DC and sinusoidal sources of the same frequency is given by the ...

Q: Problem 8.3-14 7.5 A 1-0 18. Ohms i () 144. V 36. Ohms 54. Ohms 3 H 36. Ohms This circuit is at stea...

A: Given circuit is –

Q: Find out the ratio of the ac output voltage (ve) to the ac input voltage (v6) B iь Bi, RL EO RE Ve

A: According to Kirchhoff's voltage law, the total voltage drop across any closed loop is zero. Applyi...

Q: 4. Use the nodal analysis method to formulate a system of simultaneous linear equations representing...

A: To apply the nodal analysis first apply the voltage at the different nodes as shown in the figure gi...

Q: (1) For the circuit shown, assume that the diode voltage during on-time is 0.7V. Obtain and draw the...

A: Part (a): Write the expression for the time period and calculate the time period of the square wave,...

Q: A single-phase circuit is placed across a 120-Vrms, 60-Hz source, with an ammeter, a voltmeter, and ...

A: The current in the circuit is 12 A. The voltage across the circuit is 120 V. The active power read b...

Q: What will be the time constant of a series RC circuit where R=1.5 kiloohm and C=50 milliFarad?

A: For an RC circuit, the time constant can be obtained by multiplying the value of the resistance with...

Q: In the circuit shown in Figure P3.70, VS models thevoltage produced by the generator in a power plan...

A: The circuit diagram is:

Q: R2 E2 (Click on the image to enlarge) Suppose R = 22, R2 = 22, R, = 22, R = 4S2, E, = 26V, E, = 12V,...

A: (a) Clearly, from the given network the loop current i1 is equal to the value of current source I1. ...