1.5 µF Li3 300 mH 220 V 50 Hz L23 120 mH 300 2 C2 0.5 µF You are given the below parallel RLC circuit, answer the following questions showing the detailed steps. Figure 3: Parallel RLC Circuit a) Total impedance of the circuit b) The voltage and current Phase shifts of the total impedence. c) The voltage across Cl and the current flows through it. d) The voltage across L1 and C2. e) The currents flow through L1, R and L2. Open W

1.5 µF Li3 300 mH 220 V 50 Hz L23 120 mH 300 2 C2 0.5 µF You are given the below parallel RLC circuit, answer the following questions showing the detailed steps. Figure 3: Parallel RLC Circuit a) Total impedance of the circuit b) The voltage and current Phase shifts of the total impedence. c) The voltage across Cl and the current flows through it. d) The voltage across L1 and C2. e) The currents flow through L1, R and L2. Open W

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter6: Power Flows

Section: Chapter Questions

Problem 6.61P

See similar textbooks

Similar questions

You are an electrician working in an industrial plant. A 30-hp three-phase induction motor has a current draw of 36 amperes at full load. The motor is connected to a 480-volt line. A three-phase wattmeter indicates a true power of 22 kW. Determine the power factor of the motor and the amount of capacitance needed to correct the power factor to 95. Also determine the minimum voltage rating of the capacitors. The capacitors are to be connected in wye.
The circuit is connected to a 400-Hz line with an applied voltage of 35.678 V. The resistor has a true power of 14.4 W. and there are 12.96 inductive VARs and 28.8 capacitive VARs. ET35.678VITZVAPFERIRRP14.4WELILXLVARsL12.96LECICXCVARsC28.8C
the voltage drops across four series connected impedances are as follows V1 = 60sin (wt + pi/6) V2 = 100 cos (wt + pi/4) V3 = 75 sin (wt + 5pi/6) V4 = Vm sin (wt + θ) Find the values of Vm and θ if the voltage across the series is 180 sin (wt + 3pi/5) and draw the equivalent circuit diagram.
I am trouble understanding this circuit. Here, R= 25.0 ohms, L=30.0 mH and C=12.0µF. Additionally the amplitude and frequency of the source voltage are 20.0 V, and 500 Hz. a) How would I draw the phasor diagram for the circuit, to determine the phase angles betweenthe source voltage and the current ? b) If the frequency of the source changes, what frequency would allow for the current to be the maximum? Any help and guidence would be greatly appreciated :)
I am trouble understanding this circuit. Here, R= 25.0 ohms, L=30.0 mH and C=12.0µF. Additionally the amplitude and frequency of the source voltage are 20.0 V, and 500 Hz. a) How would I draw the phasor diagram for the circut, and how would I determine the phase angles between the source voltage and the current. b) In the event the frequency of the source changed, at what frequency would the current in the circuit be maximum? Any help and guidence would be greatly appreciated :)
A circuit consists of an AC voltage source, a 10-ohm resistor, and a capacitor, all connected in series. The magnitude of the impedance of the capacitor is also 10 ohms. Which of the following is true about the source voltage and the current through the circuit? a. Insufficient information is given. b. The source voltage will lag the current. c. The source voltage will lead the current. d. The source voltage will be in-phase with the current.
A capacitor and a resistor are connected in parallel to a 120-V, 60-Hz line. The resistor has a resistance of 40 Ω, and the capacitor has a capacitance of 132.6 µF. What is the total current flow through the circuit? What is the impedance of the circuit?What is the power factor of the circuit? How many degrees out of phase are the current and voltage?
Three impedances are connected in series across a 100 V, 50 Hz supply. The impedances are: Z1 is a coil of inductance 0.018 H and 2 Ω resistance, Z2 is a coil of inductance 0.0228 H and 5 Ω resistance, and Z3 consists of a capacitor of capacitance 400 μF and resistance 3 Ω. Calculate (a) the circuit impedance, (b) the circuit current, (c) the circuit phase angle, and (d) the voltage drop across each impedance.
A series RLC circuit with L=160 mH, C= 100 micro F and R=40 ohm is connected to a sinusoidal voltage v(t) = 40sinWt, with W= 200 rad/sec. find,(1) What is impedance of the circuit (2) Let the current at any instant in the circuit be I(t) = I0 sin(Фt-F). find I0(3) What is the phase Ф I need all parts complete solve don't copy from any answer else I will give downvote
A coil of resistance 30 Q and inductance 400 mH, are connected in series across a 240 V, 50 Hz a.c. supply. Calculate (a) the circuit impedance (b) the voltage across the resistance (C) the voltage across the coil and (d) the phase angle in degrees.
A2 KO resistor and 30 mH inductor are connected in series, across a 120 V A.C power source oscillating at 60 Hz frequency .Calculate i) The current in the circuit i) The voltage drop across the resistor & inductor ii) The power dissipated in the circuit. iv) The apparent power & reactive power in the circuit. v) Draw the phasor diagram.
Determine the values of the resistance and the series-connected inductance or capacitance for each of the following impedances: (a) (12 + j5) ohm (b) −j40 ohm (c) 30∠60◦ ohm (d) 2.20 × 106∠−30◦ ohm. Assume for each a frequency of 50 H