Question

This problem is (12.20) from a book  "Thermodynamics and Statistical Mechanics An Integrated Approach by M. Scott Shell"

12.20. Show that the following relation describing activity coefficients must hold for
binary solution,
dx1
n
Expand
Transcribed Image Text

12.20. Show that the following relation describing activity coefficients must hold for binary solution, dx1 n

Expert Answer

Want to see the step-by-step answer?

Check out a sample Q&A here.

Want to see this answer and more?

Experts are waiting 24/7 to provide step-by-step solutions in as fast as 30 minutes!*

*Response times may vary by subject and question complexity. Median response time is 34 minutes for paid subscribers and may be longer for promotional offers.
Tagged in
Engineering
Chemical Engineering

Related Chemical Engineering Q&A

Find answers to questions asked by students like you.

Q: This problem is (10.15) from a book  "Thermodynamics and Statistical Mechanics An Integrated Approac...

A: Part (a)It is given that the surface tension (γ) is constant with the temperature for a single-compo...

Q: In

A: Part (a) The reversible reaction for the formation of ammonia from nitrogen and hydrogen is:N2 + 3H2...

Q: Determine the kinetic energy in Btu/hr of 100 gallon/min of water flowing through a pipe with an ins...

A: The formula to calculate the kinetic energy of an object with constant mass in a rectilinear motion ...

Q: with degree of freedom analysis

A: Distillation column is used to separate the feed  into vapor and liquid form by partial vaporization...

Q: This problem is (7.13) from a book  "Thermodynamics and Statistical Mechanics An Integrated Approach...

A: Note that the given expression for the intensive Gibbs energy in a binary mixture of A and B is corr...

Q: This problem is (8.18) from a book  "Thermodynamics and Statistical Mechanics An Integrated Approach...

A: Compressibility (β) of a substance is the fractional differential change in its volume with respect ...

Q: Please answer part e, f and h ONLY. thank you!

A: Measurable quantities : which are used to measure thermodynamic properties (entropy, chemical potent...

Q: EXERCISES Section 2.1 2.1. Minimum work of separation. A refinery stream is separated at 1,500 kPa i...

A: The minimum work in kJ/h required is calculated using below formula:

Q: 4.7 A single equilibrium stage in a distillation column is shown in Fig. E4.7. The model that descri...

A: Part (a)Assume that the molar holdup (H) of the given stage is constant and the molar overflow which...

Q: Following is a diagram of the shirt cleaning process at a professional clothing cleaning service. Th...

A: Symbols:Dirt = DWhizzo = WhLet the basis of the calculation be taken as 100 lbm dirty shirts contain...

Q: This problem is (11.16) from a book  "Thermodynamics and Statistical Mechanics An Integrated Approac...

A: (a) Proteins in aqueous solution become larger in the size due to accumulation of fluid therefore pr...

Q: This problem is (12.17) from a book  "Thermodynamics and Statistical Mechanics An Integrated Approac...

A: Given equation of Osmotic Pressure:

Q: The density of a particular fluid is given by the following equation:where rho = 64e^((7.9x10^-7)P) ...

A: part (a)Since exponential term is dimensionless hence units of 7.9x10^-7 is in^2/lbf as shown below ...

Q: 6.19 Consider the following cascade connection of isothermal reactors. A first-order reaction A Bocc...

A: Since questions has many parts, we are only answering first three parts. Part (a)For tank A,Mass bal...

Q: Please show all steps, thank you

A: Part (a)Use the Lineweaver Burke plot to determine the value of Vmax (or rmax) and Km at 30°C and en...

Q: This problem is (7.19) from a book  "Thermodynamics and Statistical Mechanics An Integrated Approach...

A: Energetic quantity X is the function of P (pressure) and V (volume) Fundamental equation of energeti...

Q: What are some enviromental, social, and economic risks of polystyrene watse.  How can recycling help...

A: Polystyrene is formed by polymerization process of monomer styrene. It is an aromatic hydrocarbon.Re...

Q: 100 mol/hr pentane flows through an adiabatic heat exchanger (one type of heat exchanger is shown be...

A: Part (a) Let the heat exchange be on countercurrent type. Since the heat is exchanged adiabatically,...

Q: Analytical solution of reactor design equation: Consider the irreversible reaction, which occurs in ...

A: (1) For the reaction given in the question rate law expression is given as follows:Where CA represen...

Q: a.) Provide a definition for a "Thin film" b.) Provide a definition for a "semi-infinite slab." c.) ...

A: (a) Thin film is defined as thickness of material or substance which have been deposited on the surf...

Q: 2. The absorption tower is often used for absorbing gases. The gas is introduced at the bottom of th...

A: Part (a)Let,The mass of inlet gas be m1 kg.The mass of outlet gas be m2 kg.The mass of inlet water(a...

Q: 3.14. Limestone (calcium carbonate) particles are stored in 50-L bags. The void fraction of the part...

A: Part (a)The density of the solid limestone is calculated from its given specific gravity as:

Q: dy, dt dy, 4x2 = 4y1-6y2 + 21, + 4112 dt Find the four transfer functions relating the outputs (y, y...

A: Take the Laplace transform of the two given equations and label them as equation (1) and (2) respect...

Q: PLEASE ANSWER (D) ONLY.

A: Since questions have too many parts, we are only answering first three parts.Part (a)For tank A,Mass...

Q: The figure below represents a simple flow sheet for a single unit. Only the value of D is known. Wha...

A: Click to see the answer

Q: The density of gold is 19.3 g/cm^3 . A 6. 4 mg piece of gold is hammered into a square that is 8.6x...

A: Part (a):The thickness of gold which is hammered into square is given in centimeters as: 8.6*10-6 cm...

Q: What conditions or principles usually dictate whether an impure feed should be separated prior to en...

A: Feed stream entering the process do not contain pure chemicals. There is scope for purification. The...

Q: Calculate the rate of heat loss by radiation from the upper surface of the electronic chip of Proble...

A: From the given data: TS = Surface temperature = 75⸰C = 348 KTsur = surrounding temperature = 25⸰C = ...

Q: 5.9 Two liquid storage systems are shown in Fig. E5.9. Each tank is 4 feet in diameter. For System I...

A: Note: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question...

Q: Ethylene oxide is formed by the partial oxidation of ethylene. Unfortunately some of the ethylene is...

A: Part (a) The schematic diagram of the given process is shown below.

Q: Problem 3. Acetylene is produced from methane in the reaction C2H2 (g) 3H2 (g) 2CH4 (g) An undesired...

A: Acetylene is produced from methane is given by the first reaction represented by equation (1). The a...

Q: 5.9. Extraction of uranyl nitrate. A 20 wt% solution of uranyl nitrate (UN) in water is to be treate...

A: Dear student, we answer three parts in a question, so we are providing answers to the first three pa...

Q: (a) If 300 lb of air and 24.0 lb of carbon are fed to a reactor at 600 ° and after complete combusti...

A: Part (a)Moles of Carbon fed to the reactor is written as equation (1).Moles of Air fed to the reacto...

Q: This problem is (6.20) from a book  "Thermodynamics and Statistical Mechanics An Integrated Approach...

A: Part (d):We know that

Q: This problem is (10.20) from a book  "Thermodynamics and Statistical Mechanics An Integrated Approac...

A: In the given problem there is a rigid, sealed container containing equal number of moles of liquid X...

Q: A 2-in. schedule 40 steel pipe (ID=2.067in., OD = 2.375 in.) carries steam at 350F with a heat-trans...

A: answer:The schematic diagram of the pipe with insulation is given below with the inner radius R1, Ou...

Q: Consider an ideal gas mixture of n species. a.) In a mixture containing equal mole fraction of O_2, ...

A: a. Ideal gas mixture is the mixture of two or more gases and there is no interaction between molecul...

Q: This problem is (6.30) from a book  "Thermodynamics and Statistical Mechanics An Integrated Approach...

A: Hose is used for conveying water with the value of inside and outside diameter along with the given ...

Q: A rectangular fin 1.0 ft long, 1.0 ft wide, and 2in. thick loses heat to the atmosphere at70 F. The ...

A: Given thatThermal conductivity=k=24 Btu/h.ft.0FHeat transfer coefficient=h= 2 Btu/h.ft2.0fAtmospheri...

Q: Calculate the fugacity and fugacity coefficient of the pure (a) CH4 and (b) CO at 500oC and 10 bar.

A: Here to find the fugacity and fugacity coefficient for CO and CH4 at temperature 500ºC and pressure ...

Q: Problem 4 You have developed a genetically engineered strain of a methanotroph bacteria (a bacteria ...

A: Let n1 to n5 represent the molar flowrate of components in outlet stream.The reactions taking place ...

Q: Given the below plot of the natural log of the fugacity coefficient, ln(φi), of pure NH3 as afunctio...

A: Molar volume is defined as volume possessed by one mol of a substance at given conditions of tempera...

Q: Energy conservation is important for houses. To what fraction is the heat transfer rate reduced by r...

A: For convective heat transfer through the glass window of area A ft2 having convective heat transfer ...

Q: Write the energy balance for the material in a closed container, neglecting potential and kinetic en...

A: Energy conservation law states that the total energy of the system and the surroundings can neither ...

Q: is carried out isothermally in a continuous flow reactor. Calculate both the CSTR and the PFR reacto...

A: The reaction taking place is, S→P According to the Michaelis-Menten equation, the reaction rate for ...

Q: Calculate the theoretical flame temperature when ethylene at 25°C is burned with: lon tom n frttebod...

A: Since there are multiple parts we will answer the first three parts only. To get the solution for th...

Q: This problem is (6.30) from a book  "Thermodynamics and Statistical Mechanics An Integrated Approach...

A: The information provided in the question is as follows:Inside diameter of the hose is d1 = 5 cmNozzl...

Q: This problem is (7.12) from a book  "Thermodynamics and Statistical Mechanics An Integrated Approach...

A: In the given problem there is a binary system containing component A and B.

Q: Each side of conversion equal sighns is one drag item plz help me solve this with three steps bc i h...

A: Given that the volume of a copper piece is 560 L, the mass of copper in grams is to be calculated by...

Q: An open container is filled with water up to a depth of 3 meters and above water it is filled with o...

A: As per the given information, the tank is filled with oil and water as shown in Figure1.Density of O...