2. Would the calculated value of the molarity of the NaOH solution be too high or too low or unchanged if the following errors were made? Explain your answers. a) the beaker into which the student poured the NaOH solution from the fume hood had some distilled water in it b) the flask into which the student weighed the KHP was wet c) the buret tip was too far above the mouth of the flask and two drops of the NaOH ran down the outside of the flask d) an air bubble was in the tip of the buret when the student started the titration 158 EXPERIMENT 10

2. Would the calculated value of the molarity of the NaOH solution be too high or too low or unchanged if the following errors were made? Explain your answers. a) the beaker into which the student poured the NaOH solution from the fume hood had some distilled water in it b) the flask into which the student weighed the KHP was wet c) the buret tip was too far above the mouth of the flask and two drops of the NaOH ran down the outside of the flask d) an air bubble was in the tip of the buret when the student started the titration 158 EXPERIMENT 10

Introductory Chemistry: A Foundation

9th Edition

ISBN:9781337399425

Author:Steven S. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Donald J. DeCoste

Chapter7: Reactions In Aqueous Solutions

Section: Chapter Questions

Problem 2ALQ: ssume a highly magnified view of a solution of HCI that allows you to “see” the HCl. Draw this...

See similar textbooks

Similar questions

Calcium carbonate, CaCO3, can be obtained in a very pure state. Standard solutions of calcium ion are usually prepared by dissolving calcium carbonate in acid. What mass of CaCO3 should be taken to prepare 500. mL of 0.0200 M calcium ion solution?
On Easter Sunday, April 3, 1983, nitric acid spilled from a tank car near downtown Denver, Colorado. The spill was neutralized with sodium carbonate: 2HNO3(aq)+Na2CO3(aq)2NaNO3(aq)+H2O(l)+CO2(g) a. Calculate H for this reaction. Approximately 2.0 104 gal nitric acid was spilled. Assume that the acid was an aqueous solution containing 70.0% HNO3 by mass with a density of 1.42 glcm3. What mass of sodium carbonate was required for complete neutralization of the spill, and what quantity of heat was evolved? (Hf for NaNO3(aq) = 467 kJ/mol) b. According to The Denver Post for April 4, 1983, authorities feared that dangerous air pollution might occur during the neutralization. Considering the magnitude of H, what was their major concern?
A student weighs out a 4.80-g sample of aluminum bromide, transfers it to a 100-mL volumetric flask, adds enough water to dissolve it, and then adds water to the 100-mL mark. What is the molarity of aluminum bromide in the resulting solution?
The units of parts per million (ppm) and parts per billion (ppb) are commonly used by environmental chemists. In general, 1 ppm means 1 part of solute for every 106 parts of solution. Mathematically, by mass: ppm=gsolutegsolution=mgsolutekgsolution In the case of very dilute aqueous solutions, a concentration of 1.0 ppm is equal to 1.0 g of solute per 1.0 mL, which equals 1.0 g solution. Parts per billion is defined in a similar fashion. Calculate the molarity of each of the following aqueous solutions. a. 5.0 ppb Hg in H2O b. 1.0 ppb CHCl3 in H2O c. 10.0 ppm As in H2O d. 0.10 ppm DDT (C14H9Cl5) in H2O
On the basis of the general solubility rules given in Table 7.1, predict which of the following substances are not likely to be soluble in water. Indicate which specific rule(s) led to your conclusion. :math>PbSe. BaCO3 :math>Mg(OH)2f. AlPO4 :math>Na2SO4g. PbCl2 :math>(NH4)2Sh. CaSO4
A sample of solid calcium hydroxide, Ca(OH)2, is allowed to stand in water until a saturated solution is formed. A titration of 75.00 mL of this solution with 5.00102M HCl requires 36.6 mL of the acid to reach the end point. Ca(OH)2(aq)+2HCl(aq)CaCl2(aq)+2H2O(l) What is the molarity?
Lead poisoning has been a hazard for centuries. Some scholars believe that the decline of the Roman Empire can be traced, in part, to high levels of lead in water from containers and pipes, and from wine that was stored in leadglazed containers. If we presume that the typical Roman water supply was saturated with lead carbonate, PbCO3 (Ksp = 7.4 1014), how much lead will a Roman ingest in a year if he or she drinks 1 L/day from the container?