2.31 The normal stresses at a point in a steel member are dx = 8 ksi, ay = -4 ksi, and ₂ = 10 ksi. Using E= 29 × 10³ ksi and v=0.3, determine the normal strains at this point.

What are two advantages of using a shrink-fit toolholder ?

Sub: Advanced Manufacturing Process

Provide the appropriate datum feature symbols and datum features in the feature control frames on the drawing

2 5 What is the shape and size of this tolerance zone? 1.25 0.50 Diam +/-0.002" 0.010

How would you solve this

a) Name two groups of standards in addition to national, industry-wide standards and where they are valid. b) Which three options exist for defining dimensional tolerances in a technical drawing?

Kilmer Company's customer demand for its only product exceeds its manufacturing capacity. The company provided the following information for the machine whose limited capacity is prohibiting the company from producing and selling additional units: Actual run time this week Machine time available per week Actual run rate this week Ideal run rate Defect-free output this week Total output this week (including defects) 1-a. Utilization rate 1-b. Efficiency rate. 1-c. Quality rate 1-d. Overall equipment effectiveness 7,500 minutes 12,500 minutes 2-a. Utilization loss in units 2-b. Efficiency loss in units 2-c. Quality loss in units 6.30 units per minute 7 units per minute Required: 1. and 2. With respect to the company's overall equipment effectiveness, calculate the following: Note: Do not round intermediate calculations. Round final answers to 2 decimal places and "Units" answers to the nearest whole number. 37,800 units 47,250 units

hand written plz Answer the following questions using the information provided in this unit. Know and Understand 1. True or False? The primary purpose of section views is to help feature exterior detail without using hidden lines. For the next three terms, match the three types of lines to the three descriptions. Answers are used only once. 2. Cutting-plane line 3. Section line 4. Short break line A. Not exclusive to section views, but needed for broken- out sections. B. Drawn thick in a view adjacent to the section view. C. Drawn thin, and usually continuous, but sometimes dashed. 5. Of the following, which is not a type of section view featured in this unit? A. Full B. Half C. Quarter D. Offset 6. True or False? The preferred dividing line between the two halves of a half-section view is the visible line. 7. An object with a number of odd features, such as spokes or holes, often has a(n) section so the odd features can be rotated around the axis into a vertical cutting plane,…

In GD&T