26. Which one of the following is the correct definition of ultimatetensile strength, as derived from the results of a tensile test on ametal specimen?the maximum load divided by the original area of the specimenthe stress observed when the specimen finally failsthe stress encountered when the stress-strain curve transforms fromelastic to plastic behaviorthe maximum load divided by the final area of the specimen

Ultimate tensile strength is ,The maximum load divided by the original area of the specimen.

Answered: 26. Which one of the following is the…

Welding: Principles and Applications (MindTap Course List)

8th Edition

ISBN:9781305494695

Author:Larry Jeffus

Publisher:Larry Jeffus

Chapter26: Welding Metallurgy

Section: Chapter Questions

Problem 25R: What are the common types of strength measurements?

See similar textbooks

Similar questions

22) In stress and strain diagram for a perfectly ductile material, the yield strength, and ultimate tensile strength are well defined Select one: True False
In a tensile test, initial length of the experimental specimen is ____________ the final length of the specimen.
27d) If a material of a component has a youngs modulus of elasticity of 500 GPa, what strain will be produced by a stress of 3 MPa?
The following data were obtained from a standard tensile stress test on a mild steel specimen. Graph the result and determine proportional limit stress and Young’s Modulus.
Simple stress and Strain
Part 2 As the area under the stress-strain curve decreases, the toughness___________. stays the same cannot be evaluated increases decreases
What are the tensile forces?
Mark the following points on an Engineering Stress-Strain curve. Plastic limitElastic limitFracture strengthYield strengthUltimate tensile strength
Pick the best soultion for the multiple choices. Modulus of resilience is: Slope of elastic portion of stress – strain curve Area under the elastic portion of the stress –strain curve Energy absorbed during fracture in a tension test Energy absorbed during fracture in an impact test Slope of the plastic portion of the stress- strain curve ( ) Fatigue failure occurs under the condition of: High elastic stress High corrosivity High stress fluctuations High temperature High rate of loading ( ) Creep failure of a material occurs most rapidly when the operating temperature is: Cryogenic temperature Equal to its melting point Grater than 0.4 times its melting point in K Greater than 200 oF Close to boiling point ( ) Young’s modulus of a material is indicative of its: Tensile strength Yield Strength Ductility Stiffness Corrosion Resistance…
Three identical fatigue specimen ( denoted A ,B and C ) are fabricated from none ferrous alloy .Each one is subjected to one of the maximum- minimum stress cycles listed in the following table, the frequency is the same for all the three tests.. Which of the following samples will have the longest life and the shortest life Specimen Stress,max ( MPa) Stress , min (MPa) A +450 -150 B +300 -300 C +500 -200
27b) If a material of component has a tensile modulus elasticity of 300 GPa, what strain will be produced by a stress of 5MPA?
Fracture occurs when the stress is greater than the ultimate tensile strength Select one: True False

SEE MORE QUESTIONS

Recommended textbooks for you

Welding: Principles and Applications (MindTap Cou…

Mechanical Engineering

ISBN:

9781305494695

Author:

Larry Jeffus

Publisher:

Cengage Learning