30 m Smooth pipe: d= 5 cm Open jet P1 80 m 10 m + 60 m

Q: Q4:- Fully developed laminar flow between parallel plates with no pressure gradient as shown in…

A:

Q: i the figure below is 2.0 mes the mean vélőčity within the outlet pipe (atmospheric pr 95.48…

A:

Q: A new steel pipe, 15 cm in diameter and 1200 m long carries 0.020 m^3/s of heavy fuil oil with S=…

A:

Q: When water at 20 °C is in steady turbulent fl ow through an8-cm-diameter pipe, the wall shear stress…

A: Given data To determine axial pressure gradient (∂p/∂x) in pipe if  1) Horizontal flow with the…

Q: For the water channel fl ow of Fig.=, h 1 = 0.45 ft,H = 2.2 ft, and V 1 = 16 ft/s. Neglecting losses…

A: Write the given data.

Q: A power plant discharges cooling water through the manifoldin Fig.  which is 55 cm in diameter and 8…

A: Determined the total discharge through all the holes by using the given equation, Here, the total…

Q: Two reservoirs, which differ in surface elevation by 40 m,are connected by 350 m of new pipe of…

A: Write the given Data:

Q: Water at 40°C flows horizontally through a constriction similar to that in Fig. S3.9 when the…

A: Given,  Temperature of flow 40 C Pressure at section 1 , P1 = 35 KPa Diameter at section 1 , d1 =…

Q: In Fig. , free discharge, a gate opening of 0.72 ft willallow a fl ow rate of 30,000 gal/min. Recall…

A: Given dataflow rate Q=30 000 gal/min width b=8 ft    y1=6 ft    y2=4 ft    H=0.72 ft

Q: GLYCERIN (SP.GR. = 1.26 AND ABSOLUTE VISCOSITY OF 1.49 ?? − ? ) FLOWS THROUGH A RECTANGULAR CONDUIT…

A:

Q: Water flows through a venturi as shown in the figure at a flow rate of Q=49.7 L/s. The inlet and…

A: Given:- Water flowing through venturi meter Flow rate (Q) = 49.7 L/s = 0.0497 m3/s Inlet Diameter…

Q: In Fig. P3.130 the fl uid is gasoline at 20 ° C at a weight fl owof 120 N/s. Assuming no losses,…

A: Given data To determine the gauge pressure at section 1-1

Q: Example For the parallel Multiple pipe loop system. of Fig. P6.116, all pipes are 8-cm-diameter…

A: Very small variation in final answer from given answer because I took 4 digit accuracy.

Q: An engineer claims that the flow of SAE 30W oil, at 20 °C,through a 5-cm-diameter smooth pipe at 1…

A: Given data: The diameter pipe, d = 5 cm. Flow rate through pipe, Q = 1 million N/h. Now density of…

Q: Oil with a kinematic viscosity of 6 x 104 m2/s, flows in a horizontal circular straight pipe with…

A:

Q: Prob4 Flowing Liquid: Water; Pipe length: L=600 m; Diameter: D-0.15 m; Q=0.06 m³/s; h= 50 m [head…

A: Head losses in pipe: There are two types of losses that come into the picture one is called major…

Q: The reservoirs in Fig.  are connected by cast iron pipesjoined abruptly, with sharp-edged entrance…

A: Given data: The diameter of pipe 1 is d1=1 in. The length of pipe 1 is l1=20 ft. The diameter of…

Q: Water steadily through a reducing pipe bend. Krown conditions are p1 850 3 kPa atsolute, D1 -25 cm,…

A:

Q: A pump delivers 1 hp to a water at 68°F flowing in a 10-in-diameter horizontal, cast iron pipe at V…

A:

Q: Water at 40°C flows horizontally through a constriction similar to that in Fig. S5.9 when the…

A: Given data:-Pressure of water at bigger end, P1=35kPadiameter at bigger end, d1=0.5m⇒cross-sectional…

Q: An engineer needs to monitor a flow of 20°C gasoline atabout 250 ±25 gal/min through a 4-in-diameter…

A: Given data: The properties of gasoline at 20 degrees Celsius are: The area of the throat is

Q: Prob3 Consider a laminar flow that flow rate Q=0.2 ft³/s; v = 6.55 * 10.5 ft²/s. Find pipe diameter…

A: Reynold number for the fluid flowing through the pipe: When the flow occurs in a pipe, the flow is…

Q: Incompressible steady flow in the inlet between parallel plates is uniform, Vo = 8 cm/s, while…

A:

Q: Water at 20 ° C is delivered from one reservoir to anotherthrough a long 8-cm-diameter pipe. The…

A: Given data as per question Pipe diameter = 8 cm Z2 = 80 m h loss ≈17.5( V 2 /2 g ) flow rate = 500…

Q: The system in Fig. below consists of 1200 m of 5 cm cast iron pipe, two 45° and four 90° flanged…

A:

Q: Two oil tanks are connected by two 9-m-long pipes, asin Fig.. Pipe 1 is 5 cm in diameter and is 6…

A: Given data The length of both the pipe is L=9 m The diameter of the pipe 1 is D1=5 cm=0.05 m The…

Q: The pump in Fig. is used to deliver gasoline at 20°Cthrough 350 m of 30-cm-diameter galvanized iron…

A: Given, T1 = 20°C L = 350 m D = 30 cm = 0.3 m Q =? Considering Properties of Gasoline at 20°C,ρ = 680…

Q: The pipe flow in the figure shown below is driven by pressurized air in the tank. What gage pressure…

A:

Q: Roman aqueduct customersobtained extra water by attaching a diffuser to theirpipe exits. Fig. shows…

A: Given data Diameter of the give pipe D1 = 3 cm = 0.03mLength of the pipe L = 2mHeight of the tank H…

Q: Oil (SG = 0.89) enters at section 1 in Fig. P3.20 at a weightfl ow of 250 N/h to lubricate a thrust…

A: Given data S=0.91F=250 N/hr

Q: Examples of The Inlet to pump is 10.50m above the bottom of sump from which it draw water through a…

A:

Q: A soda straw is 20 cm long and 2 mm in diameter. It deliverscold cola, approximated as water at…

A: (a) The value of density and viscosities of the weather at 10°C are: ρ=1000 kgm3 and μ=1.307×10-3…

Q: Water at 20 ° C is to be siphoned through a tube 1 m longand 2 mm in diameter, as in Fig. . Is there…

A: Draw the diagram for the problem. Here, the points 1 and 2 indicate the points in the siphon as…

Q: The following data were obtained for the flow of 20°C water at20 m3/h through a badly corroded…

A: Given data P1=420 KPaP2=250 KPaZ1=12 mZ2=3 m

Q: A 10-cm-diameter smooth pipe contains an orifice platewith D: 1/2D taps and β = 0.5. The measured…

A: Given data: The diameter of the smooth pipe is D = 10 cm. The ratio of orifice diameter to the pipe…

Q: The long pipe in Fig. P3.172 is fi lled with water at 20 ° C.When valve A is closed, p 1 - p 2 = 75…

A: Understand that for valve A closed there is no flow, so there is no velocity and no head loss due to…

Q: P.4.10 Oil of viscosity 10 mNs/m? and specific gravity 0.90, flows through 60 m of 100 mm diameter…

A:

Q: Consider a turbine extracting energy from a penstock in a dam, as in Fig. P3.171. For turbulent pipe…

A: Draw a diagram for the problem. Write the Bernoulli’s equation assuming steady flow between points…

Q: . Three reservoirs are connected, if pipe (1) and pipe (3) having equal discharge, and the discharge…

A:

Q: In Fig.  let y1 = 6 ft and the gate width b= 8 ft.Find the gate opening H that would allow a…

A: Given data y1=6 ftb=8 ftQ=30000 gal/min=66.84 ft3/s

Q: A venturi meter, shown in Fig. designed constriction whose pressure difference is a mea- sure of the…

A: Apply energy equation between points 1 and 2 P1ρg+V122g+Z1=P2ρg+V222g+Z2 By rearranging the terms…

Q: As can often be seen in a kitchen sink when the faucet isrunning, a high-speed channel fl ow ( V 1 ,…

A: Let's assume the width as w and P1 and P2 are the pressure at 1 and 2 respectively,

Q: Q3) Refer to Fig. P5.4. Water at 10°C flows up AB (5 m long, 40 mm diameter), B Horizontal then…

A: Given data:-length of pipe AB, LAB=5mdiameter of pipe AB, dAB=40mm=0.04m⇒cross-sectional area of…

Q: The pipe flow in the figure shown below is driven by pressurized air in the tank. What gage pressure…

A: The required gauge pressure in the tank is 2.0 E6  Pa (2.0 x 106 Pa).

Q: SAE 50W oil at 20 °C flows from one tank to anotherthrough a tube 160 cm long and 5 cm in diameter.…

A: Given:  Length of the tube, L=160 cmL=1.6m Diameter of the tube, D=5cm Elevation of the tank 1,…

Q: For the series/parallel pipe system shown below find the missing discharges Q, Q, and the head loss…

A:

Q: Answer completely The Fanning equation and the Darcy-Weisbach equation both relate the pressure…

A: To Explain :   The physical significance of the pressure drop and explain the reason behind the…

Q: A smooth pipe (30 cm) diameter and (100m) long has flush entrance and submerged discharge. The…

A: Given               Velocity, v = 3 m/s            Diameter, D = 30 cm                Length, L =…

Q: The 35 °C water fl ow of Fig. P3.135 discharges to sea-levelstandard atmosphere. Neglecting losses,…

A: GIVEN:…

Q: The system in the figure below consists of 1200m of 5 cm cast iron pipe (ɛ = 0.26 mm), two 45° and…

A: Given that ,  Now , for the given problem ,

Applied Fluid Mechanics

A fluid is a substance that is continuously deformed by the application of shear stress. The rate of deformation of a fluid depends on its viscosity. The fluid tries to flow when it interacts with some other system.