30.55    An L-C circuit consists of a 60-mH inductor and a 250-microFarad capacitor. The initial charge on the capacitor is 6 micro-Coulombs, and the initial current in the inductor is zero. a) What is the maximum voltage across the capacitor? b) What is the maximum current in the indictor? c) What is the maximum energy stored in the inductor? d) When the current in the inductor has half its maximum value, what is the charge on the capacitor and what is the energy stored in the inductor?

Q: A battery of emf E is connected in series with a resistor, an inductor L. and a switch S. A…

A:

Q: An LC circuit contains a 20 mH inductor and a 50 µF capacitor with an initial charge of 10 mC. The…

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and…

Q: An L-C Circuit consists of an inductor with an inductance of 65.0 mH and a capacitor with a…

A: Since, there is a question with multiple sub-parts posted by you, we will solve the first three…

Q: A 10-mH inductor and a 25uF capacitor are connected in parallel. The combination is in series with a…

A: a. Here the capacitor and inductor are connected in parallel, so the effective impedance is

Q: A single-loop circuit consists of a 7.20 ohm resistor, a 12.0 H inductor, and a 3.20 mF capacitor.…

A: Write the expression for the charge on the capacitor in RLC circuit after time t.

Q: A 45.0 mH inductor has a reactance of 1.30 k. (a) What is its operating frequency? (b) What is the…

A: Hey, since there are multiple subparts question posted, we will answer three first questions. If you…

Q: An RLC series circuit has a 1.00 kΩ resistor, a 150 µH inductor, and a 25.0 nF capacitor. (a) Find…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: The angular frequency of the oscillations in an LC circuit is 2.0×103 rad/s. (a) If L=0.10H, what is…

A: (a)Given,L=0.1HThe angular frequency of oscillation in the LC Circuit is given by

Q: A 30.0-mH inductor has a reactance of 2.10 kV. (a) What is the frequency of the ac current that…

A: a) The inductive reactance is given by, Therefore,

Q: An RLC series circuit has a 2.50 Ω resistor, a 100 μH inductor, and an 80.0 μF capacitor. (a) Find…

A: Dear student, this question contains more than three sub-parts. We will answer first three…

Q: In tuning a radio, which is easier to tweak, the inductor or the capacitor? Explain a little pls

A: Expected  frequency is changed by a tuned coil / capacitor paired, and then the signal is indicted…

Q: A 12.6-V battery is in series with a resistance of 0.304 Ω and an inductor. (a) After a long time,…

A:

Q: A fully-charged capacitor with C = 1137F is connected in series with a resistor (w/ R = 867N) and an…

A:

Q: An L-C circuit consists of an inductor with an inductance of 60.0 mH and a capacitor with a…

A:

Q: An inductor that has an inductance of 14.0 H and a resistance of 40.0 is connected across a 100 V…

A:

Q: 30.55    An L-C circuit consists of a 60-mH inductor and a 250-microFarad capacitor. The initial…

A: The given values are,

Q: In the L-C circuit in the figure, the ammeter reads a maximum cur­rent of I = 5.19 mA. The…

A:

Q: A capacitor C=25μF is charged by a 40 volt battery. When the capacitor is fully charged, it is…

A: We’ll answer the first question since the exact one wasn’t specified. Please submit a new question…

Q: An RLC series circuit has a 2.12 kQ resistor, a 155 mH inductor, and a 32.9 nF capacitor. (a) What…

A:

Q: An R = 220-Ω resistor, an L = 1.95-mH inductor, and a V = 10.5-V source are connected in a series…

A: Time constant for a RL circuit is given by ζ=LR

Q: 440 Vac 400 Hz generator is connected to a series circuit with a 16 Ω resistor, a 11.9-mH inductor,…

A: 440 Vac 400 Hz generator is connected to a series circuit with a 16 Ω resistor, a 11.9-mH inductor,…

Q: A series RCL circuit consists of a 60.0 Ω resistor, a 15.0 µF capacitor, a 3.75 mH inductor, and a…

A: R = 60 ohm C = 15 micro farad L = 3.75 mH V = 60 volts f = 1375 Hz Xc = 1/(2πfC) =…

Q: A 15.0 mH inductor is connected across an AC generator that produces a peak voltage of 9.60 V. a.…

A: Given values:Inductance,     L = 15.0 mH = 15.0 x 10-3 HPeak voltage Vo = 9.60 Hz

Q: A 250-ohm resistor, a 0.450 H inductor, and a 6.45 µF capacitor are connected in series across an…

A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: 2. A capacitor of 12µF is charged by a 30 V battery. Afterwards, the capacitor is disconnected from…

A:

Q: An RLC series circuit has a 2.50 Ω resistor, a 100 μH inductor, and an 80.0 μF capacitor.…

A:

Q: Please choose the right answer for questions below: Seç. (a) What is the reactance of 2.5 Henry…

A: As per bartleby guidelines, we can only answer one question at a time. So, we are answering question…

Q: A series RLC circuit driven by a source with an amplitude of 120.0 V and a frequency of 50.0 Hz has…

A:

Q: -mH inductor and a 25 MF (micro F) capacitor are connected in parallel. The combination is in series…

A: Given values:- Inductance,(L)=10 mH=0.01 H ----(1) Capacistance,(C)=25 μF=25 x 10-6 F ----(2)…

Q: An L-C circuit consists of a 60.0 mH inductor and a 250 μF capacitor. The initial charge on the…

A:

Q: *Chapter 31, Problem 032 GO Z Your answer is partially correct. Try again. In the figure, an ac…

A: Given data: The emf of an AC generator is, Em= 25.8 V Angular frequency is, The inductance of the…

Q: The 4.00 A current through a 1.30 H inductor is dissipated by a 2.00 Ω resistor in a circuit like…

A: Since there are multiple sub parts posted, we will answer the first three sub parts. a) The equation…

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention.