4 In the rectifier circuit shown in Figure P9.34, v(t) = Asin(2r 100)t V. Assume a forward voltage drop of 0.7 V across the diode when it is conducting. If conduction must begin during each positive half-cycle at an angle no greater than 5°, what is the minimum peak value A that the AC source must produce? +21

4 In the rectifier circuit shown in Figure P9.34, v(t) = Asin(2r 100)t V. Assume a forward voltage drop of 0.7 V across the diode when it is conducting. If conduction must begin during each positive half-cycle at an angle no greater than 5°, what is the minimum peak value A that the AC source must produce? +21

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

The diode in the circuit shown in Figure P9.32 isfabricated from silicon andR = 2.2 kΩ VS2 = 3 V Determine the minimum value of VS1 at and above whichthe diode will conduct with a significant current
Sketch the output waveform and the voltagetransfer characteristic for the circuit of Figure P9.24.Assume ideal diode characteristics, vS (t) =10 sin (2,000πt). Use the offset diode modelwith Vγ = 0.6 V.
What is an ideal diode? Draw its volt–ampere characteristic. After solving a circuit with ideal diodes, what check is necessary for diodes initially assumed to be on? Off?
A half-wave rectifier, similar to that of Figure 9.25in the text, is used to provide a DC supply to a 220-load. If the AC source voltage is 25 V (rms), find thepeak and average current in the load. Assume an idealdiode.
Sketch i versus v to scale for each of the circuits shown in Figure P9.39. Assume that the diodes are ideal and allow v to range from −10 V to +10 V.
Sketch i versus v to scale for the circuits shown in Figure P9.6. The reverse-breakdown voltages of the Zener diodes are shown. Assume voltages of 0.6 V for all diodes including the Zener diodes when current flows in the forward direction.
Consider the circuit of Figure P9.9. Determinewhether the diode is conducting or not. Assume thatthe diode is an ideal diode.
Sketch to scale the output waveform for the circuit shown in Figure P9.63. Assume that the diodes are ideal.
Consider the circuit of Figure P9.9. Determinewhether the diode is conducting or not. Assume thatthe diode is an ideal diode. Consider: VC = 15 V (Ignore the value in the figure)
Consider the voltage-regulator circuit shown in Figure P9.85. The ac ripple voltage is 1 V peak to peak. The dc (average) load voltage is 5 V. What is the Q-point current in the Zener diode? What is the maximum dynamic resistance allowed for the Zener diode if the output ripple is to be less than 10 mV peak to peak?
Consider the voltage regulator shown in Figure P9.28. The source voltage Vs varies from 10 to 14 V, and the load current iL varies from 50 to 100 mA. Assume that the Zener diode is ideal. Determine the largest value allowed for the resistance Rs so that the load voltage vL remains constant with variations in load current and source voltage. Determine the maximum power dissipation in Rs.
Consider the circuit of Figure P9.9. Determinewhether the diode is conducting or not. Assume thatthe diode is an ideal diode. Consider: VC = 10 V and VB = 15 V. (Ignore the values in the figure)