Question
Asked Apr 28, 2019
6 views
4.
Find the current I assuming ideal diod
es
1.2k2
10V (+
15%4
12V+
3V
help_outline

Image Transcriptionclose

4. Find the current I assuming ideal diod es 1.2k2 10V (+ 15%4 12V+ 3V

fullscreen
check_circle

Expert Answer

star
star
star
star
star
1 Rating
Step 1

The given is redrawn as shown in Figure 1.

fullscreen
Step 2

Assume that the given diodes D1, D2 and D3 are ideal. Therefore, diodes becomes ON when the voltage is greater than 0 V.

fullscreen
Step 3

The voltage across the respective dio...

fullscreen

Want to see the full answer?

See Solution

Check out a sample Q&A here.

Want to see this answer and more?

Solutions are written by subject experts who are available 24/7. Questions are typically answered within 1 hour.*

See Solution
*Response times may vary by subject and question.
Tagged in

Engineering

Electrical Engineering

Related Electrical Engineering Q&A

Find answers to questions asked by student like you
question_answer

Q: Can someone help me with question 2 please? Derive  Vout(t) expression for the circuit in figure 1 a...

A: Part (A) (For circuit in Figure 1):Notice that, the value of resistance and input frequency are chan...

question_answer

Q: For this circuit (attached), find the voltages at points A, B, C, D, and E. You may assume all the t...

A: Given data:Redraw the given circuit as shown in Figure 1.

question_answer

Q: Show that the system shown in the figure below oscillates at a frequency of 1 rad/sec.

A: This is a unity negative feedback system. For this system to oscillate at some frequency, we need tw...

question_answer

Q: A 3-phase line 3 km long delivers 3000 kW at a p.f. 0·8 lagging to a load. The resistance and reacta...

A: Click to see the answer

question_answer

Q: Find in e rut 3 2 12A T.F

A: Since, the given circuit diagram is as shown in the figure 1:

question_answer

Q: Use linearity and the assumption that Vo = 1 V to find the actual value of Vo in the following circu...

A: A linear circuit is one whose output is linearly related or in other words which is directly proport...

question_answer

Q: 11- Find i (t) in the following circuit. You may employ any method you wish t = 0 22 22 24 V (t)

A: First calculate the current just after the switch is closed.Capacitor behaves as a short circuit jus...

question_answer

Q: Use source transformation to find ix in the circuit below. (circuit displayed in attachment)

A: We can transform the current source into equivalent voltage source. The value of voltage source is c...

question_answer

Q: In the following circuit, use either differential equation approach or the shortcut method to find i...

A:  The current i0(t) is to be calculated in the following circuit: -

question_answer

Q: please help with question 45. thank you

A: The values of Z0, Z1, Z2 and Z3 as a function of A, B, C and D should be obtained by the following s...

question_answer

Q: Figure 3.60 For Prob. 3.11. 3.12 Using nodal analysis, determine V, in the circuit in Fig. 3.61. 40 ...

A: Nodal analysis depends primarity on the application of Kirchoff's Voltage Law (KVL). The circuit men...

question_answer

Q: s) We noded 0holgss to Solve the aitteisb end nd uR loop Umobtis to Solue the wrts ond find

A: a) Nodal Analysis:Let V1 is the node voltage at node. 

question_answer

Q: Resistor Color CodeWhat Color Code would a 30Ω ±5% look like?

A: Use color code table to obtain the desired result of your problem: -Let us consider a resistor have ...

question_answer

Q: Q1: a) Discuss the effect of earth on the capacitance of a line : b) Derive in expression for the ca...

A: (a) The earth can be considered as a conducting infinite equipotential plane. The electric flux line...

question_answer

Q: .il Verizon LTE 7:41 PM ร์ 100% Done 1- In the following circuit find ve) andi,(C) given; y(1) = 240...

A: From the given circuit, the switch is connected to v1(t) at t < 0. As the supply v1(t) is connect...

question_answer

Q: How to convert the following decimal number to numbers with metric prefixes in following below?29) 5...

A: We need to convert the given numbers to numbers with metric prefixes.

question_answer

Q: In the following circuit, use either differential equation approach or the step by step method to fi...

A: Figure 1 shows the modified circuit when t < 0.

question_answer

Q: A single phase transmission line is delivering 500 kVA load at 2 kV. Its resistance is 0·2 Ω and ind...

A: Given,The inductive reactance is,

question_answer

Q: Find the charge q(t) flowing through an device if the current is:(c) i(t)= 20 cos(10t + π/6)10^-6A, ...

A: Charge is defined as integral of current over a certain interval of time. The mathematical expressio...

question_answer

Q: In the following circuit, use either differential equation approach or the step by step method to fi...

A: STEP BY STEP METHOD:From the given circuit, the switch opens at t =0. That is, switch is in closed c...

question_answer

Q: A 230-kV, three-phase transmission line has a per phase series impedance of .... (please see attache...

A: We only answer the first three parts of a question on this platform, unless specified otherwise. Sin...

question_answer

Q: Q3. By using the method of images, prove that the capacitance between conductor and earth, taking in...

A: From the diagram shown below, we can say that:

question_answer

Q: Nt

A: To find the thevenin resistance or equivalent resistance:Thevenin resistance is determined by open  ...

question_answer

Q: How was the value of the capacitor derived?

A: Click to see the answer

question_answer

Q: 2. Assuming ideal diode models, find status of diodes Di and D2 (on or off) D2 + 15V 10% +

A: First, assume both diodes are on,

question_answer

Q: The initial voltage across a 7.5F capacitor is 4.5V after 0.5 seconds. If the current is described a...

A: Initial voltage Vo=4.5 VC=7.5FAt 0.5s current is given as:

question_answer

Q: 15.3 Determine the erection sag and tension of a transmission line at 65°C in still air. The line ha...

A: It is given that:

question_answer

Q: Finel)inefollo Can ollomh -0 et 2v2 ols) Lo

A: When t < 0, the switch is open and there is no independent source connected to the circuit.So, at...

question_answer

Q: 5- In the following circuit find io) t-0 2Ω 2 12 o (t)

A: Figure 1 shows the modified circuit when t < 0.

question_answer

Q: please could you help me to find the solution of  question (b)

A: The output of each meter should be determined.

question_answer

Q: I got parts a & b right. I just need a clarification how the author got the answer to part c 72....

A: From Part (a), the lower cutoff frequency (fL) is 34.412 Hz.

question_answer

Q: The switch in the circuit seen in fig. p7.52 has been in position a for a long time. At t=0, the swi...

A: Figure 1 shows the modified circuit when t < 0.

question_answer

Q: If we want to have a Q+ state of 0, which of the following input combinations would work for a DFF w...

A: The table which gives input combinations with knowing the present and next state is called as excita...

question_answer

Q: Convert the following numbers to scientific notation.Following these Question and answer.29) 5000 KΩ...

A: We need to convert the numbers given below into scientific notations.

question_answer

Q: Feedback Control of Dynamic Systems (7th edition) - Problem 7.39

A: Hi there!! Since there are four parts in the question, I will be answering only the first two parts....

question_answer

Q: A substation receives 6000 kVA at 6 kV, 0.8 p.f. lagging on low voltage side of a transformer from a...

A: The single line diagram of the system is shown below:

question_answer

Q: From this equation: How was this equation derived? Then from that derivation, how was this equation ...

A: The below equation should be derived from the given equation.

question_answer

Q: How would I sketch the output waveform and calculate the frequency of a op-amp / signal generator?

A: Operational amplifier is a device which is linear and is capable of ideal DC amplification and is th...

question_answer

Q: A single phase overhead transmission line delivers 4000 kW at 11 kV at 0·8 p.f. lagging. If resistan...

A: The equivalent circuit diagram is as follows:

question_answer

Q: help me with ques 8A

A: Consider the four inputs namely A, B, C, and D and its respective outputs are mentioned as X1, X2, X...

question_answer

Q: Problem 1: derive an expression for the amplitude of the output voltage as a function of R1, R2, c, ...

A: Problem:1 Since this an Amplifier and its amplification factor is infinite. So, voltage at positive ...

question_answer

Q: 2 A 8Ω 4Ω 12 V 6Ω 6Ω HI- Figure 3.46 For Review Questions 3.1 and 3.2. 3.2 In the circuit of Fig. 3....

A: The purely resistive circuit provided in the question can be solved by applying Kirchoff's Voltage L...

question_answer

Q: 12- Find i(t) and v(t) in the following circuit. You may employ any method you wish. 24"φ

A: When t < 0, the inductor acts as a short circuit.So, at time t=0, we will get :

question_answer

Q: e lar Cov depemaent Source loiC나 VTR 3 /2 3另

A: Follow below steps to obtain the result: -Apply Kirchhoff’s voltage law in the loop and solve as bel...

question_answer

Q: CompressionLet’s take a look at compression.Take the file Fig 05-15 which can be found on the author...

A: 1. Right click on file and go to properties to get  the type of file format.Answer: a) Chapter 5.doc...

question_answer

Q: Sketch the derived result for Vout(t). Clearly labeling your initial voltages and time constants for...

A: From the given figure, apply KVL rule,Take Laplace Transform of above equation,Take  as common from ...

question_answer

Q: Ql: a) A set of reading obtained in an experiment is 49.7. 50.1, 50.2, 49.6, 49.7 determined: 1- Ari...

A: As this question has many sub parts, so I will be answering the first five sub-parts of Q1. a.   In ...

question_answer

Q: A short 3-φ transmission line with an impedance of (5 + j 20) Ω per phase has sending end and receiv...

A: The resistance and reactance of each conductors are,

question_answer

Q: A single phase 11 kV line with a length of 15 km is to transmit 500 kVA. The inductive reactance of ...

A: Given,The length is 15 km.The inductive reactance is,

question_answer

Q: You are given that the system shown in Figure 4.25 has a 110/220 kV autotransformer. The positive- a...

A: Since there is single line to ground fault in phase a. So, fault current in phase a will be IF and f...