4. Three heaters and a three-phase y-connected motor are connected to a y-connected source of 208 v line-to-line. Each heater draws 10A at unity power factor (pf 1), and each phase of the motor draws 2 A at 0.85 power factor Find the total line current a. Find the total power consumed b. Determine the motor's inductive reactance per phase if the motor's R and X are considered to be in series c.

Question

Would appreciate help on this problem. Thanks!!

4. Three heaters and a three-phase y-connected motor are connected to a y-connected source of
208 v line-to-line. Each heater draws 10A at unity power factor (pf 1), and each phase of
the motor draws 2 A at 0.85 power factor
Find the total line current
a.
Find the total power consumed
b.
Determine the motor's inductive reactance per phase if the motor's R and X are
considered to be in series
c.
Expand
Transcribed Image Text

4. Three heaters and a three-phase y-connected motor are connected to a y-connected source of 208 v line-to-line. Each heater draws 10A at unity power factor (pf 1), and each phase of the motor draws 2 A at 0.85 power factor Find the total line current a. Find the total power consumed b. Determine the motor's inductive reactance per phase if the motor's R and X are considered to be in series c.

Expert Answer

1 Rating

Want to see the step-by-step answer?

Check out a sample Q&A here.

Want to see this answer and more?

Experts are waiting 24/7 to provide step-by-step solutions in as fast as 30 minutes!*

*Response times may vary by subject and question complexity. Median response time is 34 minutes for paid subscribers and may be longer for promotional offers.
Tagged in
Engineering
Electrical Engineering

Related Electrical Engineering Q&A

Find answers to questions asked by students like you.

Q: Help

A: The given data is

Q: Airframe Electrical System Question: Why is bare copper electrical wire not suitable for aircraft us...

A: The reason why Bare copper is not suitable for aircraft use is that:It develops a surface oxide coat...

Q: 1. FIGURE 52 shows the one-line diagram of a simple three-bus power system with generation at bus I....

A: Convert the line impedances into admittances, using Y=1/Z 

Q: I got parts a & b right. I just need a clarification how the author got the answer to part c 72....

A: From Part (a), the lower cutoff frequency (fL) is 34.412 Hz.

Q: Find the steady state response for i0(t) in the circuit in fig 9.29 if Vs=100sin50t mV

A: Steady state response for the current needs to be calculated using the below given data and figure:

Q: Also show that the power balance is achieved

A: In the given circuit, apply Kirchhoff’s current law at node Vx as follows,

Q: How much is the output voltage of a power supply if it supplies 75 W of power while delivering a cur...

A: The mathematical expression of power supplied to the load isThe mathematical expression of output vo...

Q: 15.3 Determine the erection sag and tension of a transmission line at 65°C in still air. The line ha...

A: It is given that:

Q: 3 Suppose that SS-1000H, DS-2000H, BP-1000, BX 0300H, and DI=04F0H Determine the memory address acce...

A: Question 3 and 5 are posted.  In that, first question (3) is solved as per rules. Repost the questio...

Q: The Pacific Intertie is a high voltage direct current (HVDC) connection between the Pacific Northwes...

A: As per the BNED guidelines, first three sub-parts only solved in below steps. Kindly repost the ques...

Q: NO 5

A: The flow of the program is given as follows.Mov ax,1750    ; 1750 is moved to ax.Mov ds, ax     ; Co...

Q: How would I sketch the input-output relationship of op-amp comparators with hysteresis?

A: Consider an inverting Op-Amp comparator circuit as shown in Figure 1.

Q: m T K, i- B ep)K inductance, Lm, is low compared Usually the to the resistance, Rm, and can be negle...

A: The transfer function is the ratio of the Laplace transform of output to the input into the system.I...

Q: A discrete-time periodic signal x[n] has a fundamental period of N: N-1, n=0, 1, 2, …, N-1. Determin...

A: Discrete-Time Fourier Series is given as-  

Q: A 69-kV, three phase short transmission line is 16km long. The line has a per phase series impedance...

A: We need to determine the sending end voltage, voltage regulation, the sending end power, and transmi...

Q: A monopole antenna is excited using a sinusoidal current distribution. If the antenna is transmittin...

A: From frequency, the corresponding wavelength can be computed using the following formula:

Q: table 2 resistor value R1 8kohms R2 6kohms R3 6kohms

A: To calculate the Rth, short circuit the voltage source.Now, Draw the circuit diagram,

Q: If the magnetic field strength of a plain wave is 6 A/m, then what will be strength of the electric ...

A: Consider that the given magnetic field strength as 6 A/m.Write the expression to find the electric f...

Q: I am having trouble with a Differential Amplifier problem that I attached a photo of. I must "Design...

A: For a single input single output BJT amplifier for the gain of +150 we have to make some changes in ...

Q: Airframe Electrical System Question: What are the two types of wire installation method. (Source: FA...

A: The two types of wire installation method are :Open WiringWire Groups and Bundles 

Q: Figure 3.60 For Prob. 3.11. 3.12 Using nodal analysis, determine V, in the circuit in Fig. 3.61. 40 ...

A: Nodal analysis depends primarity on the application of Kirchoff's Voltage Law (KVL). The circuit men...

Q: The circuit has been under DC conditions for a long time.

A: (a)    Amount of energy stored in each of capacitor is calculated as follows,

Q: If we want to have a Q+ state of 0, which of the following input combinations would work for a DFF w...

A: The table which gives input combinations with knowing the present and next state is called as excita...

Q: 1. A single receptacle installed on an individual branch circuit must be rated at least _ pecenrt of...

A: NOTE – As your query contains multiple questions and it is not mentioned which question has to be so...

Q: A signal is sampled at Nyquist's rate. This will ensure that the analog signal can be recovered from...

A: According to Nyquist’s sampling theorem, a signal can be recovered from its samples without any loss...

Q: For the circuit below: (a) Determine the Thevenin equivalent. (b) Find the maximum power that can be...

A: (a) According to the Thevenin’s theorem any linear complex circuit can be simplified in the form of ...

Q: The three conductors A, B and C of a 3-φ line are arranged in a horizontal plane with DAB = 2 m and ...

A: The conductors of 3 phase line are arranged in horizontal plane.

Q: Explain why the deposition temperature for polysilicon films is moderately low, usually between 600°...

A: The deposition temperature for the polysilicon film is moderately low because polysilicon will have ...

Q: Please answer all questions , and give me a sample answers 1- What is done to prevent a plan from be...

A: 1.The working plans of an architect are commonly complex due to the inclusion of more information.To...

Q: A short 3-φ transmission line with an impedance of (5 + j 20) Ω per phase has sending end and receiv...

A: The resistance and reactance of each conductors are,

Q: Draw a diagram to show a green light that glows when liquid flow occurs

A: The lightning of the bulb is controlled by the flow of the liquid. When the liquid is flowing the bu...

Q: 5.1 Dependent Sources 5.1 In the circuit of Figure P5.1 find the two values of kr (in S) for which p...

A: Given circuit is –

Q: Feedback Control of Dynamic Systems (7th edition) - Problem 7.25

A:  First, find out the canonical form from the given transfer function    and after that design a cont...

Q: 3. For the following circuit determine (include and show all the steps): (4 marks) a. Total impedanc...

A: consider that the total impedance of the circuit is Z.

Q: A lightning bolt with 10 kA strikes an object for 10 ms. How much charge will be deposited on the ob...

A: Electric charge can be defined as the product of electric current and time for which the current is ...

Q: What will be the intrinsic impedance of free space? Show detailed steps of calculation.

A: Intrinsic impedance of free space depends on permitivity and permeability of free space. Permitivity...

Q: For this circuit (attached), find the voltages at points A, B, C, D, and E. You may assume all the t...

A: Given data:Redraw the given circuit as shown in Figure 1.

Q: 9 Find v,1) in the following circuit. You may employ any method you wish. + Vo (t) 4

A: We need to calculate v0(t), in the following circuit: -

Q: A(n) blank is a device,or group of devices, by which the conductors of a circuit can be disconnected...

A: A circuit breaker is a device,or group of devices, by which the conductors of a circuit can be disco...

Q: In the following circuit, use either differential equation approach or the shortcut method to find i...

A:  The current i0(t) is to be calculated in the following circuit: -

Q: Find the field strength at 1 km away from an isotopic station of 1 kW power.

A: Field strength at a point located a distance r away  from a isotropic transmitting antenna can be ex...

Q: iam here waiting

A: The given instruction is

Q: The three conductors of a 3-Φ transmission line are arranged in a horizantal plane and are 5m apart....

A: Consider that the phase inductance of  phase conductor R,Y and B are LA, LB and LC respectively, geo...

Q: In a binary pulse code modulated system, an analog signal x(t)=10sin(40t) is used as input. A unifor...

A: Pulse code modulation system is the fundamental backbode of analog to digital signal conversion. It ...

Q: If 1 unit of electricity costs about 2 USD, then how much electric bill will be generated if a 100 W...

A: 1 unit of electricity is equivalent to 1 kilowatthours (kWh) of electrical energy. It is to be noted...

Q: A sinewave voltage with amplitude 2 V and frequency 1 kHz is applied capacitor. The capacitance is 0...

A: Given parameters are,

Q: What is the radiation resistance of an antenna which is radiating a power of 100 kW and draws a curr...

A: The power radiated by the antenna can be expressed as

Q: Determine the value of the thermal voltage at the room temperature.

A: In science, 27o C is taken as room temperature. It is converted in absolute temperature that is in K...

Q: Find VAD, VB and VCE

A: To find VAD:

Q: Find out the expression of the output voltage.  Refer to the following diagram for the same.

A:  Given circuit diagram is shown below,