4.26 The resistances in the series network of problem 4.1 are measured at 30°C. Their resistive elements are made of nichrome, Permanickel and Grade A nickel, respectively. What will be the resistance of the network at 60°C?

Q: 5² +35+k 25³ +45² +55 Find the value of k that makes the final value of the system output 38. The…

A:

Q: WHAT IS THE MODULO OF THE CIRCUIT? WHAT IS THE OUTPUT (IN BINARY) AFTER 738 PULSES?

A: The modulo of the circuit is based on the number of flip-flops used to design the circuit. The given…

Q: Attenuation, distortion, and noise contribute to transmission impairment. What is the solution, or…

A: Attenuation:- The loss of signal power in networking cables or connections is known as attenuation.…

Q: A DC generator has eight poles, wound as lap then rewound as a wave, calculate the electrical motive…

A: In this question,  DC Generator ,  Number of pole P= 8,   Number of conductors Z= 240 Flux = 0.04wb…

Q: 3. Find the maximum power that can be delivered to a load resistor attached to terminals a and b by…

A:

Q: N 44ov 60H2 чего 10+јзол -||--

A:

Q: Find the octal equivalent to 359.325d

A: This is basic problem of conversion in digital electronics.

Q: In lap winding, the number of brushes is always half the number of poles two double the number of…

A: There are two types of windings,  Lap winding Wave winding

Q: Given Figure shows the input characteristic for an n-p-n silicon transistor. When the base emitter…

A: In this question we have to find the value of base current, static value of resistance and dynamic…

Q: The power input to a 500 V, 50 Hz. 6-pole. 3-phase induction motor running at 975 RPM is 40 kW. The…

A: Solution !!

Q: 4. Determine / in the given circuit. SV 3.2 M 75 8V

A: Given data, Circuit diagram is given as,

Q: At a frequency of 1.5 kHz, the open circuit impedance of the length of the transmission line is…

A:

Q: 6. Vin C₁ HE 0.0022 μF 4 mH 4 -00000- R₁ 150 22 Vout What is the bandwidth in the given circuit. If…

A: In this question,  We need to determine the bandwidth of the Given circuit.  We know bandwidth of…

Q: A single phase 11 kV line with a length of 15 km is to transmit 500 kVA. The inductive reactance of…

A:

Q: Consider the following figure for a 4-pole, 3-phase, 24-slots double layer winding. Find the pole…

A: Given the figure of double layer winding. Here, The total number of poles = 4. The total number of…

Q: The potential at the terminals of the battery falls from 9 V on open circuit to 6 volts when a…

A: Use voltage division rule to find internal resistance of the battery.  If two resistors R1 and R2…

Q: 8.the letter D on the D flip flop stands for? 9. it is a logic circuit that is known for being time…

A: In this question,  We need to define the D flip flop.  We are discussing about the logic circuit…

Q: 1. When the inputs to an exclusive-OR circuit are alike, the output is binary 2. An exclusive-NOR…

A:

Q: Find the power factor and apparent power

A: It is given that: vt=160cos377t+100 V V=160∠100 V  Z=60+j40 Ω

Q: (coso) (47) find the Power factor of the following ckf.

A: It is given that:

Q: Circle the right answer(s) The most important advantages of renewable energy sources compared to…

A: In this question,  We need to choose rhe correct options In this question, we are discussing about…

Q: A capacitor of 2 mF has a voltage of 525cos(201). The energy stored in it at t = 850 ms is: a. 36.22…

A: Given data: C=2 mFV=524 cos20tt=850 ms

Q: Problem 8. For the oscilloscope display of a pulse waveform shown in Figure 10.18 the 'time/cm'…

A:

Q: 4. Application of Complex Number Determine the values of L and C that will make the equivalent…

A: First find the equivalent impedance seen from the source then equate with the given impedance to get…

Q: In a 3-phase power measurement using two wattmeter method, if one wattmeter reads 2.5 times the…

A: Given: In a 3-phase power measurement using two wattmeter method, One wattmeter reads 2.5 times the…

Q: Evaluate the steady state response of a series RC, where R=20 ohm and C=0.10 uF if the input voltage…

A:

Q: A 24 V peak voltage is supplied to the load of R2 = Calculate: a) the peak load current. b) the…

A:

Q: 6. Determine Vo using mesh analysis. 30V 24V 182 Il 922² + + 14 1022 12 122 13 2002⁰ +48V

A:

Q: 3.) E=20v 452 1002 th 222 Find the ff a.) RT b.) It a) Ix Vy ८८. 62 1552 d.) Xy e.) I₂ f.)PL 522…

A:

Q: A flow chart detailing the sequence of manufacture of a energy saving switch for a kettle

A: Flow Chart:- A flow diagram, often known as a flow chart, is a visual representation of the…

Q: At 50Hz operation, a single phase transformer has hysterestic loss of 200 W, and Eddy current loss…

A: Given- Frequency f=50 Hz, Hysteretic loss ph= 200 W, Eddy current loss Pe= 100 W. To Find- The core…

Q: The condition in which a diode conducts current is called bias.

A:

Q: 13.For an active low RS FLIP FLOP with a HIGH normal output, the value of its S and R inputs,…

A: The Flip-Flop is a device that stores a bit of information. The Flip-Flop changes its state during…

Q: n a household during a particular week three 2 kW fires are used on average 25 h each and eight 100W…

A: Given,Fires-Number of fires =3Energy = 2 kWTime =25 hBulbs-Number of bulbs=8Energy=100 WTime=35 h

Q: If the no load secondary voltage of a 1-phase transformer is 235 V and full load secondary voltage…

A: Given: A 1-phase transformer has, No load secondary voltage, V2nl=235 V. Full load secondary…

Q: A 15 KVA, 2400: 240/120 V, 60 Hz, the two-winding transformer is to be reconnected as a 2400:2520 V…

A:

Q: Determine the system function of the discrete system described by difference quation y(n)-1/2…

A: Solution !! y(n)-1/2 y(n-1)+1/4 y(n-2) = x(n)-x(n-1) Taking z-transform,    Y(z) -1/2z-1Y(z) +…

Q: 4. a. Design a Combinational circuit with three inputs, (A, B, and C) and four outputs, (U, V, W,…

A: This is a basic problem of logic gate function. The detailed solution is given in the next step.

Q: A long shunt compound generator has an armature, series field and shunt field resistances of 0.040,…

A:

Q: A field effect transistor operates with a drain current of 100 mA and a gate-source bias of-1V. The…

A:

Q: Electrical equipment in an office takes a current of 13A from a 240V supply. Estimate the cost per…

A: Given: Current, I=13A Supply voltage, V=240V Time for equipment use, t=30 hrs Cost, A=13.56p/kWh

Q: The internal characteristic of generator is the curve between Armature current and generated emf…

A: Given  The internal characteristic of generator is the curve between....

Q: 2. Determine the total resistance and the total current. 30V 652 M 1522 W 1022 M 182 422 M M 82 2052

A:

Q: On full load a 300V series motor takes 90A and runs at 900 rpm, the armature resistance is 0.10 and…

A:

Q: Example 12.36. A capacitor of capacitance 10 uF has a loss angle of 10° at 50 Hz. Find (i) power…

A: Given: C =10 μfδ = 10∘f = 50 Hz Find:. Power Factor Angle φcPower Factor cosφc

Q: (Non-anonymous question. Find the time response c(t) from the transfer function, G(s): 15…

A:

Q: Operation of Complex Number Given the following complex numbers, evaluate the following operations…

A: As per Bartleby guideline we need to answer the first three questions only. Kindly repost the rest…

Q: A DC generator feeds a load of current 20 A and voltage 220 V. Calculate the electrical motive force…

A:

Q: Calculate the p.d. developed across a 7500 resistor when the current flowing through it is (a) 3 A,…

A: It is given that: R=750 Ω

Q: 1. The total inductance for this circuit is mh. 4h 2 h 3h 1h

A: Circuit is given as: