44. Employ phasor-based analysis to obtain an expression for i(t) in the circuit Fig. 10.57. 4 cos (100t-20°) A ( 592 i(1) 292 1 mF 20 mH

Q: Two-three phase ac generators 1 and 2 are connected in parallel. The first generator has a per phase…

A: When two or more power generating or consuming unit connected in parallel then sum of active active…

Q: Control System , Given transfer function, T (s) = αs + β / s^2 + (α + 2)s + β (i) Pick a…

A:

Q: consider two buses connected by an impedance of (0 + 5j) Q. The bus '1' voltage is 100 230° V, and…

A:

Q: A single-phase power system consists of a 600-V 50-Hz generator supplying the circuit shown in…

A: The given circuit diagrams (1-a) and (1-b) are shown below: It is given that: V=600 Vf=50…

Q: PROBLEM #3 DETERMINE THE VALUE OF √x AS LABELED IN THE CIRCUIT. USE KVL AND FLL TO 500mA 2.3V m 7.35…

A:

Q: 3. Normalized impedance of 1-j is: a) In the upper half of the impedance smith chart. b) In the…

A: Smith chart:  Smith chart is a quick and easy way to determine the value of input resistance or…

Q: From the curcuit given below, determine the total amount of power in the series circuit.

A: It is given that:

Q: For an n-channel JFET, VGs(om=-8V and Ipss=7 mA. Determine the value of VGs required to set up ID of…

A: Use drain current equation of jet to determine value of VGS.

Q: ADM system is designed to operate at 3 times the Nyquist rate for a signal with a 3 kHz bandwidth.…

A: Given,The system is designed to operate at 3 times the Nyquist rate.Bandwisth , BW=3 kHzStep-size,…

Q: A d.c. series motor drives a load at 30 rev/s and takes a current of 10 A when the supply voltage is…

A: Types of DC Machine Seperetely excited DC Motor Self excited DC motor DC shunt motor DC series…

Q: A 75-ohm load terminates a 50-ohm transmission line. The point of reflection is at the load. If the…

A:

Q: . In the transformer shown in the below figure, the inductance measured across the terminal 1 and 2…

A: Given data- A transformer as shown in the figure. It is needed to find the Coefficient of coupling…

Q: Draw a block diagram given the function shown below: a. F = A B + C b. F=XY+X'Y + Y' Z C. (A + B')…

A: Given that boolean  expressions to implement block diagrams

Q: In a d.c. series motor, the torque developed is 20 Nm at 10 A. If the load current is doubled, the…

A: Given a dc series motor with, Torque developed, τ1=20 Nm. At the current, I1=10 A. When the current…

Q: Using Boolean Algebra, simplify the following expressions:  ( A + A’ ) ( A B + A B C’ ) [ A B ( C…

A:

Q: A 3-phase 3-wire supply feeds a load consisting of three equal resistors connected in star. If one…

A:

Q: A gain of 11 is required from a noninverting constant- multiplier op-amp circuit. If the input…

A: Given  Gain = 11 and R = 10k ohm  Rf = ?

Q: A system is used to transmit base3 PCM signal of 256 level steps, the input signal works in the…

A: Given number of levels L = 256 frequency of input signal ranges ⇒ ( 50 to 90 kHz) Formula to be used…

Q: 3. A 10ohms resistor and an unknown inductance is connected in series. The series combination is…

A:

Q: The system that has the transfer function G(s) = Underdamped system Undamped System Critically…

A: In this question,  We need to choose the correct option.  A system can decided according to the…

Q: A long compound DC generator feeding a load of current 100 A, at a voltage of 230 V. Calculate the…

A: Given: Current, IL=100A, Resistance, Ra=0.04ΩRsh=115ΩRse=0.01Ω Voltage, V=230V

Q: 10. A power supply provides 400 watts to a load and is 80% efficient. In 24 hours, does this supply…

A: Given: Power output, Pout=400 W. Efficiency, η=80%=0.8 . Time, t=24 hours.

Q: For a boost converter operating in continuous conduction mode, when the dc input voltage is 10…

A:

Q: "A coaxial cable has a foam polyethylene insulator whose velocity factor is 0.7. If the inner…

A:

Q: Determine the total amount of power in the series circuit in Fig.

A: It is given that:

Q: 4. The portion of the flux that goes through one of the transformer coils but not the other one is…

A: We need to select correct option for given statement regarding transformer and induction motor

Q: A generator with constant 1.0 p.u. terminal voltage supplies power through a step-up transformer of…

A: Given data- Generator constant terminal voltage = 1.0 p.u. Reactance=0.12 p.u. Finite bus…

Q: After closing the switch 'S' at t = 0, the current 1 (t) at any instant 't' in the network shown in…

A: Given data- Time constant- τ=LR=0.01, To Find- The current at any instant (t).

Q: Question 47 If a resistor is dissipating 1/4 W, it can supply 1/4 W to the load. True False

A: False. Because, never a resistance supplies power to the load. It is a passive element which means…

Q: The RL circuit of the following figure is fed from a constant magnitude, variable frequency…

A: Given- At 100 Hz, Voltage drop in R = uRMS , Voltage drop in  L = uRMS .   To find- New voltage…

Q: 6. The open loop transfer function of a unity feedback system is given by K (s+3)(s+6) Calculate the…

A:

Q: H (jw) = Y(jw) X (jw) = 105(10 + jw) (1000 + jw) (1 + jw)(100 + jw)(10000 + jw)

A:

Q: 4.20 A 25-KVA, 2200/220-V, single-phase transformer has an equivalent series impedance of Zel = 3.5+…

A:

Q: 2. Calculate the total resistance between the points A and B. A www 4 ohm www 3 ohm 1 ohm 2 ohm

A: Given data, Circuit diagram is given as,

Q: 1) A dc-dc buck converter has a 48 V input. This converter is connected to a dc motor that spins at…

A: Given Buck converter input voltage Vin=48 V   Buck converter output voltage =24 V @ 2000 rpm…

Q: which represent the elements named R and Lin the figure? Obtain the impedance parameters ¿Que repr…

A:

Q: The voltage Vo in the circuit shown equals 10Α 200 ἦν. Ο 5A 200 ΩΣ ЗА

A: Given data, Circuit diagram is given as,

Q: An 800 kV transmission line has a maximum power transfer capacity, P, it is operated at 400 kV with…

A: Let Vs be sending end voltage,      VR be the receiving end voltage and     X be the series…

Q: 4. The given system has NF- 8.74dB, has all impedances at 5002 and uses high side injection, a.…

A: According to the question, for the given system as shown below, We need to find, (a) Mixer…

Q: If we have Const Pie = 3.14, what is the value of this expression: Pie = Pie +1 Pie = 3.14 Pie =…

A:

Q: A conducting rod of length 0.5 m falls freely from the top of a building of height 7.2 m at a place…

A: Solution !! l = 0.5 m; h = 7.2 m; u = 0 m s-1; g = 10 m s-2; BH = 40378.7 nT The final velocity of…

Q: A music signal has frequency components from 15 Hz to 30 kHz. If this signal could be used to…

A: Frequency components of music signal = 15 Hz - 30 kHz Carrier frequency fc = 1.2 MHz We have to…

Q: 5. What value of the current when a capacitor of 10uF connected to a 110V a.c. 50 Hz power supply?…

A: Given: Capacitor, C=10μF Frequency, f=50Hz Voltage, V=110V

Q: to a 110V supply. At a temperature of 18°C, the current drawn is 0.575 A. After running the machine…

A:

Q: A 3-phase 3-wire supply feeds a load consisting of three equal resistors connected in star. If one…

A: The given circuit is a 3 phase with 3 wire star connected load. If one of the resistor is removed…

Q: 8. The magnitude bode plot of a transfer function is given below. Determine the transfer function…

A: We need to find out the transfer function for given bode plot , first we will find out corner…

Q: The bode plot of a transfer function is given below. has

A: option (a) One pole and one zero

Q: 4. Find the power dissipated in each lamp to prove which lamp shines brighter than the other when…

A:

Q: 2. V Min 0 in the standing wave pattern a) Kr=0 b) Kr=+0.5 c) Kr=±0.8 d) Kr=+1

A: SWR= (Vmax/Vmin)=(1+|Kr|)/(1-|Kr|) Where SWR= Standing wave ratio

Q: 3. Calculate the value of voltage in the circuit. Hili U=? 1=3 mA R1 600 Q

A: Given data, Circuit diagram is given as,