4-5. Determine the mass flow of air in the duct if it has avelocity of 45 ft/s. The air has a temperature of 70°F, and the(gage) pressure is 6 psi. The atmospheric pressure is 14.7 psi.Air flora46

Answered: 4-5. Determine the mass flow of air in…

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

An overhead water tank is to supply water from 15th floor thru a booster pump. Thewater surface for the overhead tank is maintained at Elevation 47m and the lowestpoint of supply is at elevation 0m. The head of the booster pump is 46ft and the flowcapacity is 65gpm. Determine the pressure of water at ground floor from the givendata and if the material specification of the riser pipe used for distribution is PN 20does the pressure rating of the pipe can withstand the highest pressure available inthe system?
Water at 20°C exits the atmosphere through the split nozzle as shown in Figure-5. The duct areas are ?1=0.02 m2 and ?2=?3=0.008 m2. If the gauge pressure at the inlet is equal to 9786 kPa and the flow rate is ?.2=?.3=200 m3/h, compute the force acting on the flange.
Flowing water in pipe 1 and pipe 2 is flowing to pipe 3 which is 7m long and discharges the water to the air. If the diameter of pipe 1 is 200mm and the diameter of pipe 2 is 250mm and V3 is 9m/s, find h.
Three pipes of diameters 0.4m, 0.2m and 0.3m of lengths of 400m, 200m, and 300m, respectively, are connected in series. The compound pipe connects two water tanks having a difference of water level of 25m. Determine the discharge through the compound pipe neglecting the minor losses when the coefficient of friction for the compound pipe is 0.006.
Water flows from A to E through the pipe system shown. It is known that the flow in pipe BFGC IS 30 LITERS /SEC. and that the pressure head at A is 60 m. Assuming that f =0.022 and that all the pipes are level, determine the total flow from A to E and the pressure heads at B, C, D and E.
A pump draws water from a 20 cm diam suction pipe and discharges through a 15 cm diam pipe in which the velocity is 3.60 m/s. The pressure is – 34. 465 kPa at A in the suction pipe. The 15 cm diam pipe discharges horizontally into air at C inclined at 45 degrees. Find the maximum height and range that the water can reach if B is 1.8 m. above A and 20 hp is delivered to the pump? Assume that the pump operates at 80 % efficiency and that the frictional loss in the pipe between A and C is 3 m.
If this tank is sealed at the top with a pressure of 30.0 kPa above the fluid, compute the resultance faoece and direction excerted by the fluid on the cureved surfaces.
A pump transfers water from a large 0pen tank to another tank above it. At the suction side, the friction losses is equivalent to 6.4ft of water. The vapor pressure of water is 0.46psi. If the NPSH available is 15ft, calculate the elevation difference bet the open tank and the pump.
A fan has a static head of 100m at 1kg/cm3 and 70F. If air velocity is 15m/s, find the total equivalent head in mm of water gage. ANSWER: 129.53 mm
The energy loss between points 1 and 2 is 3.40 lb-ft/lb and the pump delivers 40 gal/min of fluid having a specific weight of 60.0 lb/ft3. What is the required hp of the pump? The inside diameter for the 2-in and 3-in schedule 40 steel pipes are 2.067 inches and 3.068 inches respectively
The rectangular bin with an inclined gate AB is filled with water to the depth shown. Determine the location in meters along with the inclination of the center of pressure from the water surface when the total pressure is acting on gate AB x=0.82 a=2.02 m b=30 degrees asap 15 mins
Determine the velocity at the pipe with 8 8 inches diameter in ft/s

SEE MORE QUESTIONS

Recommended textbooks for you

Structural Analysis

Civil Engineering

ISBN:

9781337630931

Author:

KASSIMALI, Aslam.

Publisher:

Cengage,

Structural Analysis (10th Edition)

Civil Engineering

ISBN:

9780134610672

Author:

Russell C. Hibbeler

Publisher:

PEARSON

Principles of Foundation Engineering (MindTap Cou…

Civil Engineering

ISBN:

9781337705028

Author:

Braja M. Das, Nagaratnam Sivakugan

Publisher:

Cengage Learning

Structural Analysis

Civil Engineering

ISBN:

9781337630931

Author:

KASSIMALI, Aslam.

Publisher:

Cengage,

Structural Analysis (10th Edition)

Civil Engineering

ISBN:

9780134610672

Author:

Russell C. Hibbeler

Publisher:

PEARSON

Principles of Foundation Engineering (MindTap Cou…

Civil Engineering

ISBN:

9781337705028

Author:

Braja M. Das, Nagaratnam Sivakugan

Publisher:

Cengage Learning

Fundamentals of Structural Analysis

Civil Engineering

ISBN:

9780073398006

Author:

Kenneth M. Leet Emeritus, Chia-Ming Uang, Joel Lanning

Publisher:

McGraw-Hill Education

Sustainable Energy

Civil Engineering

ISBN:

9781337551663

Author:

DUNLAP, Richard A.

Publisher:

Cengage,

Traffic and Highway Engineering

Civil Engineering

ISBN:

9781305156241

Author:

Garber, Nicholas J.

Publisher:

Cengage Learning

SEE MORE TEXTBOOKS

4-5. Determine the mass flow of air in the duct if it has a velocity of 45 ft/s. The air has a temperature of 70°F, and the (gage) pressure is 6 psi. The atmospheric pressure is 14.7 psi. Air flora 46