5) For the waveform shown in Figure (5): Find the voltage across 50 a) 24V b) 10v c) 18V d) 15V 200 50 I50 48V 50; V 242 Figure (5)

Q: What dimensions are used when measuring the area of a building? See NEC 220.12.

A: Referring to the NEC 220.12, the floor area is evaluated using the outside of the building dimension...

Q: Q2: A. Three similar resistors connected in star draw a line current of 10 A from a 380-V, 3-phase m...

A:

Q: Calculate the current in the circuit when the battery is supplied from the 10V and two resistors of ...

A: As given in the circuit, the resistors are connected in the parallel then their equivalent will be e...

Q: Would a universal motor be a good choice for a clock? For a furnace fan motor? For a home coffee gri...

A: Universal motor is not a good choice for a clock, because the torque demanded by the clock is not co...

Q: Rf ?

A:

Q: Q1. An SCR full bridge converter supplies power to a 560 V, 50 A, separately excited DC motor with a...

A:

Q: B. Find complex power supplied by each source shown in Figure 5. 4 07: 50ia H 30Ω 500 40Ω Figure 5 |...

A:

Q: 48. Using a A-Y or Y-A conversion, find the current I in each of the networks of Fig. 8.122. 20, 4.7...

A:

Q: Determine the Thevenin equivalent of the circuit in Fig. 10.27 as seen from the terminals Answer: ZT...

A: The Thevenin’s equivalent circuit for any circuit is the series combination of Thevenin’s voltage (V...

Q: For the circuit shown in Figure P4.29, the switch is closed for a long time prior to t=0.Find expres...

A: The circuit at t<0 is given as, At t = 0+ At t = ∞, The expression for time constant is given...

Q: The amplifier in a battery-powered device is beingdesigned to deliver 50 mW to a set of headphones.T...

A: The given amplifier is used to power both the headphones, the calculation for the voltage, and the c...

Q: Explain the effect of time constant on the capacitor voltage in RC transient circuits.

A:

Q: Suppose that the amplitude of the steady-state response xss (t) of a linear, first order system with...

A:

Q: Find out the Z transform of the following function including the roc: x(n)=5nu(n).

A: For any discrete-time function x(n), the Z transform of the function can be expressed as The unit s...

Q: 1. Use the Fourier transform to find io in the circuit if ig equals 3e-5|t| A.2. Find io(0-).3. Find...

A:

Q: 4) Consider the following circuit: R V, a) Use two sentences to briefly explain why Thévenin equival...

A:

Q: Know how to design simple voltage-divider and currentdivider circuits Find the no-load value of vo i...

A: Solving for No load V0 , Given data: VS is: 200 V R1 is: 25 Ω R2 is: 75 Ω The expression for the no ...

Q: Find out the value of the 3 node voltages using nodal analysis.

A: The nodal analysis is based on Kirchhoff's current law which states that the total current entering ...

Q: At the instant the switch  isclosed, the voltage on the capacitor is 56 V. Assume an ideal op amp.Ho...

A: From the figure shown in question, it is redrawn below when the switch is closed at, t=0 s    

Q: The resistivity of an alley is (51 x 10-82.m). The long , 6cm wide, and 0.014 cm thick. Detena the r...

A:

Q: Usually, transformers are designed to operate with peak flux densities just below saturation of the ...

A: The transformer is designed in such a way that it can act as a step-up transformer to boost the curr...

Q: 51 Show that when two or more emitter-follower outputs are connected to a common load, as shown in t...

A: In the given figure, both the transistors will be off when both input voltages are low Then output ...

Q: The circuit shown in Figure P4.39 is operating in steady state with the switch closed prior to t=0. ...

A: The circuit diagram before t = 0 is given as,     The expression for the IL(0-)  is given as, The ...

Q: What is memory-mapped I/O?

A: Memory-planned I/O is a method of performing I/O activities between the CPU and the I/O gadget. We c...

Q: if the current in a resistor doubles, what happens to the dissipated power? (assume the resistor ope...

A: The expression for the power is given as, When current is not double then, When current is double ...

Q: Consider the following circuit: Vin R1 o Veut R2 R3 If R = R2 = R3, is the output voltage just divid...

A: As all the resistances are equal let, the equivalent circuit is given by 

Q: A 20-kW compound generator works on full-load with a terminal voltage of230 V. The armature, series ...

A: Given: A dc compound generator which is short shunt connected and in which

Q: - In speed control of dc shunt motor, the armature voltage drop has the great effect on speed

A: Speed of the dc shunt motor is directly proportional to back EMF of the motor if there will be volta...

Q: Generate differential equations,of the electrical circuit by hand using Newton’slaw and the basic pr...

A:

Q: The parameters in the circuit are R1=0.1 Ω,ωL1=0.8 Ω, R2=24 Ω, ωL2=32 Ω, and VL=240+j0 V.1. Calculat...

A: The RLC circuit is shown below: The parameters of the circuit are as follows: (a) The phasor volta...

Q: A load absorbs maximum power from the circuit shown in Figure 4.Determine the load impedanceand the ...

A:

Q: A 100-turn coil wound on a magnetic core is found to have an inductance of 200 mH. What inductance w...

A: Given data, The value of number of turns N1 = 100. The value of number of turns N2 = 200. The value...

Q: I need an answer within a quarter of an hour

A: source transformation can be applied to transform voltage source into current source and vice versa ...

Q: A diode has a doping of ND = 1015/cm3 on the n-type side and NA = 1017/cm3 on the p-type side. What ...

A: The built-in potential of the given diode is given by the expression as shown below: Plugging the v...

Q: 2) For the circuit shown in Figure (2): Calculate the total current Ir a) 90 A b) 75.5A 31A 15A e) 8...

A:

Q: Consider a second-order unity feedback system with = 0.6 and a, = 5 rad/sec. Calculate the peak time...

A: Given data: The expression for the peak time is given as,  

Q: An energy meter is designed to make 100 revolutions of the disk for one unite of energy consumption....

A:

Q: - In speed control of dc shunt motor, to increase the speed above the rated value: * a) Armature vol...

A: Back emf, Eb, of generator is given by the following equation, Eb = (PØNZ)/(60A)where, P = no. of po...

Q: solve example please.

A: Given data:   Initial voltage, Vi = 70 V. Capacitance, Ci = 10 µC. When a charged capacitor is conne...

Q: Explain the effect of time constant on the capacitor voltage in RC transient circuits.

A:

Q: In the ionospheric propagation, consider that the reflected takes place at a height 300 height and t...

A: The ionospheric propagation is taking place at a height of 300 km hence it will lie in the F2 layer ...

Q: The capacitor 3000 µF has initially no charge at (t=0) the switch (SW) is applied to position (A)sho...

A:

Electrical Heating Unit

The conversion of electrical energy to heat energy is known as electric heating. The heating system that converts the electrical energy to heat energy for various application is called electrical heating unit. Electricity is employed as the firing mechanism in electric heating systems, which transforms electric current to heat. Electric heaters have heating elements in the form of electric resistors.