5. 1) As shown in the image below, the snowmobile has a weight of 259 lb, centered at G1, while the rider has a weight of 154 Ib, centered at G2. If the acceleration is a = 13.5 ft/s?, dimensions are dį = 0.9 ft, d2 = 0.4 ft, d3 = 1.6 ft, dą = 1.6 ft, and height h %3D %3D of G2 of the rider is 1.8 ft, determine the normal reaction force under the front skid at point B. Assume there is only traction (horizontal) force under the rear tracks, but no friction force under the front skid. Please pay attention: the numbers may change since they are randomized. Your answer must include 2 places after the decimal point, and proper unit. Take g = 32.2 ft/s².

5. 1) As shown in the image below, the snowmobile has a weight of 259 lb, centered at G1, while the rider has a weight of 154 Ib, centered at G2. If the acceleration is a = 13.5 ft/s?, dimensions are dį = 0.9 ft, d2 = 0.4 ft, d3 = 1.6 ft, dą = 1.6 ft, and height h %3D %3D of G2 of the rider is 1.8 ft, determine the normal reaction force under the front skid at point B. Assume there is only traction (horizontal) force under the rear tracks, but no friction force under the front skid. Please pay attention: the numbers may change since they are randomized. Your answer must include 2 places after the decimal point, and proper unit. Take g = 32.2 ft/s².

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

By using a forked rod, a smooth cylinder C having a mass of 0.5 kg is forced to move along the vertical slotted path (r = 0.4 θ) m, where θ is in radians. If the angular position of the arm is θ = (0.3 t3 ) rad, where t is in seconds. The cylinder is in contact with only one edge of the rod and slot at any instant. Find "the force of the rod on the cylinder at the instant t=2s" Find "the normal force of the slot at the instant t=2s" Find the "radius of curvature at t=2s" Find the "ψ angle at t=2s"
The figure depicts two pucks on a frictionless table. Puck 2 is four times as massive as puck 1. Starting from rest, the pucks are pushed by two equal forces. 1-Which pucks will have the grater kinetic energy upon reaching the finish line? 2- Which puck will reach the finish time first ?
The bulldozer below has a mass of 10 metric tons and the centre of gravity at G1 is 1 m and drives from rest. It carries a load of 1 metric ton with the centre of gravity G2 3m. The distance from the front wheel to the centre and the rear wheel to the centre is 1,7 m and 0,8 m respectively. Neglect the weight of the wheels. 1)Show all forces acting on the bulldozer 2)Determine the acceleration of the bulldozer neglecting the weight. 3)If the bulldozer increase speed to 15 m/s with a constant acceleration after it travelled 50 m. Calculate the normal force exerted on the front and rear wheels.
A block of mass 4m can move without friction on a horizontal table. The block is attached to another block of mass m by a string that passes over a frictionless pulley. If the masses of the string and the pulley are negligible, what is the magnitude of the acceleration of the descending block?
Pulleys and ropes are massless and frictionless. The coefficient of static friction between the mass m2 and the surface is µ(s) and the coefficient of kinetic friction is µ(k). The velocity of the mass m2 is V2 and the acceleration is a2. Give your answer in terms of (Ɵ, m1, m2, g, µ(s), µ(k) and V2). Under what conditions are V2 and a2 opposite direction. Hint: m1*a1=2*T-m1*g m2*a2=-T +/- cosƟ*m*g*µ(k) 2*x1=x2 => 2*a1=a2
Three friends ride a Ferris wheel with a diameter of 76m. Their combined mass with each car of the Ferris wheel is 389kg. When their car is at position A, the steel support applies 503N force at the car at an angle of 40degrees with the horizontal. What is the speed of the cars?
1. Two masses are connected by a cord and accelerates to the left. M1 has a mass of 20 kg and rests on an incline plane at 37 degrees with respect to the horizontal while m2 has a mass of 10 kg and is hanging above the floor. Find the magnitude of the acceleration and the tension in the cord assuming that there is no friction between the block and the inclined plane. 2. In the previous problem, suppose that the 10 kg block, instead of hanging, lies on a horizontal, frictionless surface to the right of the pulley and the 10 kg mass is horizontal. Calculate the following:a. The acceleration of the blocks.b. The tension in the cable.
AB bar, negligible weightmovement on the surface indicated by the wheelsis doing. The bar is at rest when θ = 0°is being released. A and B when θ = 30°Find the velocities of the points.
2. A block of mass m1 = 2.05 kg and a block of mass m2 = 6.40 kg are connected by a massless string over a pulley in the shape of a solid disk having radius R = 0.250 m and mass M = 10.0 kg.The fixed, wedge-shaped ramp makes an angle of ? = 30.0°as shown in the figure. The coefficient of kinetic friction is 0.360 for both blocks. a) Draw force diagrams of both blocks and of the pulley. b) Determine the acceleration of the two blocks. (Enter the magnitude of the acceleration.) c) Determine the tensions in the string on both sides of the pulley.
Block A in Fig. has mass 4.00 kg, and block B hasmass 12.0 kg. The coefficient of kinetic friction between block Band the horizontal surface is 0.25. (a) What is the mass of block C ifblock B is moving to the right and speeding up with an accelerationof 2.00 m/s2? (b) What is the tension in each cord when block B hasthis acceleration?
Equation of Motion(NORMAL AND TANGENTIAL) Fn= Man Ft= Mat Given a 1400 kg car that travels along a road with increasing vertical profile y = 0.0003x². If the constant velocity of the car is 30 m/s. of the distance is at 210m, a. Determine the x-component of the velocity (m/s) of the car. b. Compute the total force (KN). a. Determine the x-component of the velocity (m/s) of the car. b. Compute the total force (KN). Hint: The slope of a line is equivalent to tanø where Ø is an angle measured from the x-axis.
16- A helicopter with a mass of 72kg is towed by a rope 15m perpendicularly from the ocean surface. The pilot's acceleration is g/10. What is the work (J) done on the pilot by the force exerted by the helicopter? (g=9.80m/s2)