6.1 Convert a volume flow rate of 3.0 gal/min to m³/s. 6.2 Convert 459 gal/min to m3/s. 6.27 A small metering pump delivers 11.4 gal of a water treatment chemical per 24 h. Express this flow rate in ft3/s.

6.1 Convert a volume flow rate of 3.0 gal/min to m³/s. 6.2 Convert 459 gal/min to m3/s. 6.27 A small metering pump delivers 11.4 gal of a water treatment chemical per 24 h. Express this flow rate in ft3/s.

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Related questions

Q: Find the force against a dam that is 8 meters deep and 83 meters long. The density of water is 1000…

Q: A cylindrical tank with a large diameter is filled with water to a depth D = 0.30 m. A hole of…

A: Write the Bernoulli’s equation, and calculate the drainage speed. The speed of the water at top of…

Q: The maximum gauge pressure in a hydraulic lift is 17 atm. What is the largest size vehicle (kg) it…

Q: The blood flow in a vein of radius 0,31 cm. The velocity of the blood in vein is 0,2 m/s. Find the…

A: Given data: Radius (r) = 0.31 cm Flow velocity (v) = 0.2 m/s = 20 cm/s Required: Volume flow rate in…

Q: The pressure at 7 88m depth in a fluid is 104,097PA Calculate the donsity of the fluid and present…

A: Pressure of liquid P=104097 Pa and depth h=7.88 m. (Acceleration due to gravity g=9.8 m/s2). We need…

Q: A hydraulic jack has an input piston of area 0.0540 m2 and an output piston of area 0.660 m2. How…

A: Given data :- Area A1 = 0.0540 m2 Area A2 = 0.660 m2 Force F2 =1.45×104 N

Q: The figure shows a stream of water in steady flow from a kitchen faucet. At the faucet, the diameter…

Q: The pressure at 10.07m depth in a fluid is 104,287P.. Calculate the density of the fluid and present…

A: We know that pressure at depth d is given by; Pd= ρgh + Po Here we have, Pd= 104287 Pa, g = 9.8m/s2,…

Q: What is the average flow rate in cm/s of gasoline to the engine of a car traveling at 101 km/h if it…

A: Given data: Speed of car (v) = 101 km/h Car's averages = 12.0 km/L Required: The average flow rate…

Q: A large tanker truck can carry 20 tons (40,000 lb) of liquid. (a) What volume of water can it…

Q: Four hydraulic pumps are used to lift an object of weight 60 N with a force of 20 N. Which of the…

Q: A force of 150 N is applied to a hydraulic piston of area of 0.8 m3 If it is attached to a larger…

Q: A hydraulic jack has an input piston of area 0.050 m2 and an output piston of area 0.70 m2 . How…

A: The expression for the input force is,

Q: granite has a mass density of 2650kg/m3.. find its weight density in lb/ft3

A: We know that , 1 pound(lb) = 453.6 g , that means 1kg = (1000/453.6) lb. Again we know that 1 fit…

Q: estion 4 2.5 points The maximum gauge pressure in hydraulic lift is 16.7 atm. What is the largest…

A: Given data P= 16.7 atm D = 32.7 c.m

Q: What is the average flow rate in cm/s of gasoline to the engine of a car traveling at 114 km/h if it…

A: The expression for average flow rate of gasoline to the car engine is given by Q=vL 1 Here, Q is…

Q: 1.13 If a pump discharges 284 l pm of water whose density is 985 kg/m', find (a) the mass flow rate,…

Q: A hydraulic jack has an input piston of area 0.0600 m2 and an output piston of area 0.660 m2. How…

A: according to pascal law pressure is same on input and output side FinputAinput=FoutputAoutput

Q: A piece of wood is 0.600 m long, 0.200 m wide, and 0.075 m thick. Its density is 700 kg/m Part A…

A: Buoyancy Force: It is a physical quantity that represents the force induced in the upward direction…

Q: Wastewater is flowing in an open channel at a depth of 2.1872 yards and a velocity of 3.2808…

A: GivenIn an open channelSection 1Depth of channel, x1=2.1872 yardsvelocity of flow, v1=3.2808…

Q: What gauge pressure must a machine produce in order to suck mud of density 1800 kg/m³ up a tube by a…

Q: If a pump discharges 75 gal/min of water whose specific weight is 61.5 lb/ft^3 (g = 31.95 fps^2),…

Q: What gauge pressure must a pump produce in order to pump water from the bottom of Grand Canyon (730…

A: Given: Height of elevation of Grand Canyon: h1=730 [m] Height of elevation of Indian Garden: h2=1370…

Q: 8. 15 > flow in m/s. Ip! 3

A: According to Continuity equation, the net volumetric flow rate through a tube of flow always remain…

Q: The maximum gauge pressure in a hydraulic lift is 17 atm. What is the largest size vehicle (kg) it…

A: Gauge pressure is P = 17 atm 1 atm = 1.013 × 10⁵ Pa = 1.013 × 10⁵ N/m² => P = 17 × 1.013 × 10⁵…

Q: In a hydraulic system, a force of 558 N is exerted on a piston with an area of 0.002 m2. The…

A: Pressure exerted on piston = 558 N Piston area = 0.002 m2

Q: Two pistons of a hydraulic lift have a radius of 5 cm and 11.5 cm respectively. If the input force…

Q: ) A heavy thunderstorm dumps 12000 m' of water on a 6.0 acre flat piece of land (1 acre = 43560 ft).…

A: Given data *The given volume of water is V = 12000 m3 = (12000 × 35.31) ft3 = 423720 ft3 *The area…

Q: Find the pressure Force=2.6 N Area=1 m2

A: Given data : Force (F) = 2.6 N Area (A) = 1 m2

Q: Find the force against a dam that is 12 meters deep and 111 meters long. The density of water is…

A: Depth of tank d=12 m and height h=111 m. Density of water ρ=1000 kg/m3. The velocity with which the…

Q: In Niagara falls 5800 m3 of water flows every minute. What is the flow rate ( Q)?

A: Given data: Volume of the Niagara falls, V = 5800 m 3 Time. t = 1 min = 60 sec

Q: Hydraulic engineers in the United States often use, as a unit of volume of water, the acre-foot,…

A: It is given that,

Q: The large cylinder of a homemade automobile hydraulic lift is 18 inches in diameter. The large…

Q: What is the average flow rate in cm3/s of gasoline to the engine of a car traveling at 117 km/h if…

A: It is given that , speed of car = 117 km / h efficiency = 10.4 km/ L of fuel Average flow rate =…

Q: A hydraulic jack has an Input piston of area 0.0540 m2 and an output piston of area 0.740 m2. How…

A: Given data: Input piston area (A1) = 0.0540 m2 Output piston area (A2) = 0.740 m2 Force on Output…

Q: Suppose that it takes 10 hours (h) to drain the container of 5700 cubic meters of water. What is the…

A: In this question we have given two term that is Time ( t ) = 10 hours Volume ( V ) = 5700 m 3

Q: Hydraulic engineers in the United States often use, as a unit of volume of water, the acre-foot,…

Q: A cargo ship of mass 50000 metric tonnes is floating in the Great Lakes. The Great Lakes are fresh…

A: The cargo ships us floating on the lake. Therefore, the weight must be equal to the buoyant force.

Q: A rectangular gate in a vertical dam is 5 ft wide and 6 ft high. Find the force against the gate…

A: 9. Given: The weight density of water=62.5 The water level is 8ft above the top.

Q: You drill a small hole of area 0.0129 m2 near ground level on the side of a 15.9 m high, very large…

A: Given data: Area of hole (a) = 0.0129 m2 Height (h) = 15.9 m

Q: ) What is the flow rate in cm/s? 141.4 cm3/s ) What is the diameter (in cm) of the stream 0.200 m…

Q: A large tanker truck can carry 16 tons (32,000 lb) of liquid. (a) What volume of pure water (in ft³)…

A: Density is the ratio of mass by volume. d=mVV=md Here, V is volume, m is mass and d is density. It…

Q: A 2m wide channel is conveying water at a depth of 0.5m, what is the daily flow if the velocity is…

A: The formula for the cross-sectional area of the channel is: The formula for the flow rate is:

Q: What is the average flow rate in cm/s of gasoline to the engine of a car traveling at 106 km/h if it…

A: Explanation Average flow is defined as the volume consumed in unit time. So average flow rate is,…

Q: Find the force against a dam that is 18 meters deep and 69 meters long. The density of water is 1000…

Q: A hydraulic lift's first cylinder has a 4.5 cm-diameter while a second cylinder has a 17.8…

Question

Solve completely and correctly. I will rate and review accordingly.

6.1 Convert a volume flow rate of 3.0
gal/min to m³/s.
6.2 Convert 459 gal/min to m3/s.
6.27 A small metering pump delivers 11.4
gal of a water treatment chemical per 24
h. Express this flow rate in ft°/s.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Trending now

This is a popular solution!

Step by step

Solved in 4 steps with 4 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

A piece of wood is 0.550 m long, 0.240 m wide, and 0.078 m thick. Its density is 700 kg/m3 What volume of lead must be fastened underneath it to sink the wood in calm water so that its top is just even with the water level? Express your answer in cubic meters.
What is the weight of a cubic meter of cork? Could you lift it? (For the density of cork, use 400 kg/m3)
Find the force against a dam that is 3 meters deep and 54 meters long. The density of water is 1000 kg/m3.
The hydraulic lift in an auto-repair shop has a cylinder diameter of 0.2 m. To what pressure should the hydraulic fluid be pumped to lift 40 kg of piston/arms and 700 kg of a car?
The water hose at your home outputs 24 gallons of water a minute. How many cubic meters per hour does the hose output? There are 264.172 gal in 1 m3.
A large tanker truck can carry 20 tons (40,000 lb) of liquid. A. What volume of water can it carry? DW=62.4 lb/ft3 B. What volume of gasoline can it carry? DW=42 lb/ft3
A cylindrical tank with a large diameter is filled with water to a depth D = 0.30 m. A hole of cross-sectional areaA 6.5 cm2 in the bottom of the tank allows water to drain out. (a)What is the drainage rate in cubic meters per second? (b) At whatdistance below the bottom of the tank is the cross-sectional area ofthe stream equal to one-half the area of the hole?
At the surface of a freshwater lake, the pressure is 105 kPa What is the pressure increase in going 42.6 m below the surface? The density of fresh water at 4°C is 1.00 × 103 kg/m3. answer in kPa
A block of wood with volume 1.6 m3 is submerged in a liquid which has a density of 1050 kg/m3. If the block is placed in the liquid, what is the buoyant force? use 9.81m/s squared for acceleration round off into 4 decimal places
A hydraulic lift's first cylinder has a 4.5 cm-diameter while a second cylinder has a 17.8 cm-diameter. A 5480.4 kg truck rests on the second cylinder. What force must be exerted on the first cylinder to support the weight of the truck? use 9.81m/s squared for acceleration round off into 4 decimal places
A hydraulic jack is used to lift a small car of weight 2500 N. The areas of the input and output pistons of the jack are 0.4 m² and 1.8 m², respectively. How much force is needed to lift the small car?
Find the pressure in atmospheres in the water at the base of a Dam if the water in the reservoir is 200 meters deep. (1.01 x 105 N/m2 = 1 ATM.)