82. Two large copper plates facing each other have charge densities +4.0 C/m? on the surface facing the other plate, and zero in between the plates. Find the electric flux through a 3 cm x 4 cm rectangular area between the plates, as shown below, for the following orientations of the area. (a) If the area is parallel to the plates, and (b) if the area is tilted 0 = 30° from the parallel direction. Note, this angle can also be 0 = 180° + 30°.

82. Two large copper plates facing each other have charge densities +4.0 C/m? on the surface facing the other plate, and zero in between the plates. Find the electric flux through a 3 cm x 4 cm rectangular area between the plates, as shown below, for the following orientations of the area. (a) If the area is parallel to the plates, and (b) if the area is tilted 0 = 30° from the parallel direction. Note, this angle can also be 0 = 180° + 30°.

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter6: Gauss's Law

Section: Chapter Questions

Problem 24P: Two large rectangular aluminum plates of area 150 cm2 face each other with a separation of 3 mm...

See similar textbooks

Similar questions

While outdoors on a sunny day, a student holds a large convex lens of radius 4.0 cm above a sheet of paper to produce a bright spot on the paper that Is 1.0 cm in radius, rather than a sharp focus. By what factor is the electric field in the bright spot of light related to the electric field of sunlight leaving the side of the lens facing the paper?
27 At what angle do electric lines of force enter and leave a charged surface for maximum electric flux? a. 0° b. 30° c. 60° d. 90°
An electric field of intensity 3.50 kN/C is applied along the x-axis. Calculate the electric flux through a rectangular plane 0.350 m wide and 0.700 m long if, a) the plane is parallel to the yz-plane, b) the plane is parallel to the xy-plane, and c) the plane contains the y-axis and its normal makes an angle of 40.0 degrees with the x-axis.
Given a thin, noncounducting sheet with +1.2uC charge and 14 cm x 25 cm dimensions, find the electric field.
An electric field of intensity 3.50 kN/C is applied along the x-axis. Calculate the electric flux through a rectangular plane 0.350 m wide and 0.700 m long if (a) the plane is parallel to the yz-plane, (b) the plane is parallel to the xy-plane, and (c) the plane contains the y-axis and its normal makes an angle of 40.0° with the x-axis.
In order to work well, a square antenna must intercept a flux of at least 0.075 N⋅m2/C when it is perpendicular to a uniform electric field of magnitude 5.0 N/C. What is the minimum side length of the antenna? Express your answer to two significant figures and include appropriate units.
A thin ring whose center is 35cm away has a radius of 52cm. If an electric field of 43700 N/C is measured how much charge is on the ring
Two large rectangular aluminum plates of area 150 cm2 face each other with a separation of 3 mm between them. The plates are charged with equal amount of opposite charges, 20C . The charges on the plates face each other. Find the flux through a circle of radius 3 cm between the plates when the normal to the circle makes an angle of 5o with a line perpendicular to the plates. Note that this angle can also be given as 180o + 5o.
A nonconducting, thin plane sheet of charge carries a uniform charge per unit area of 5.20 C/m2 as in Figure 15.30. (a) Find the electric field at a distance of 8.70 cm from the plate. (b) Explain whether your result changes as the distance from the sheet is varied.
Determine the value of the electric field in a disk with a radius of 12 cm and tilted at an angle of 63º.. An electric flux with a value of 13.76 Nm2 /C is passing through the area.
8. A flat sheet of paper of area 0.250 m2is oriented so that the normal to the sheet is at an angleof 60Oto a uniform electric field of magnitude 14 N/C. (a) Find the magnitude of the electric fluxthrough the sheet. (b) Does the answer to part (a) depend on the shape of the sheet? Why orwhy not? (c) For what angle between the normal to the sheet and the electric field is themagnitude of the flux through the sheet (i) largest and (ii) smallest? Explain your answers.(EXPLAIN ALL DETAILS) asap please
5. The electric flux through a square-shaped area of side 4 cm near a large charged sheet is found to be 8.3e-05 N m2 /C when the area is parallel to the plate. Find the charge density on the sheet. This is not and will not be graded