A 12-volt battery is connected to a series circuit in which the inductance is 1/2 henry and the resistance is 10 ohms. Determine the current if the initial current is zero.

Q: A battery is connected to a series RL circuit at time t = 0. At what multiple of T will the current…

A:

Q: 1. In a circuit the resistance is 12 Q and the inductance is 4 H. The battery gives a constant…

A:

Q: 3. A series RL circuit, consisting of a single resistor and a single inductor, is being supplied by…

A:

Q: What is the charge accumulated by the capacitor in the RC circuit with R= 3 Ohm , C= 5 pF and E=9V…

A: Hello. Since you have posted multiple questions and not specified which question needs to be solved,…

Q: An uncharged capacitor is connected in series with a resistor, a dc battery, and an open switch. At…

A: a) Consider a series RC circuit. The capacitor is initially discharged but starts to charge when the…

Q: It takes 2.67 ms for the current in an LR circuit to increase from zero to 0.80 its maximum value.…

A:

Q: of 2.20 H are identical. (a) What is the resistance R in the two circuits?  Ω (b) What is the…

A: Time constant for RC circuit  Time constant =RC    C=3.70 µF Time constant for RL circuit    Time…

Q: A Reconfigurable RCL Circuit. A series RCL circuit is composed of a resistor (R = 220 0), two…

A: We know that the formula of the equivalent capacitance when two capacitances are in the series is…

Q: You wish to invent a sparker for lightning gas burners. A 1.5-A current from a battery runs through…

A:

Q: An 8.5 nF capacitor is initially charged by connecting it to a 120 V power supply and then…

A:

Q: Consider the use of an inductor in series with a computer operating on 60 Hz electricity. Construct…

A:

Q: Consider a long coaxial cable made of two coaxial cylindrical conductors that carry equal currents I…

A: The ampere’s circuital law is

Q: A 12 volte battery is connected to simple series circuit in which inductor is H and the resistance…

A:

Q: Calculate the voltage and current of the inductance and the voltage and current for the capacitance…

A:

Q: A series circuit contains a resistor and an inductor as shown in the figure. Determine a…

A:

Q: Series RLC circuit consists of a 25-ohm resistor, a 0.221-henry inductor and a 66.3 microfarad…

A:

Q: Problem 2: An AC voltage source is connected to an inductor with inductance 0.046 H. The voltage…

A:

Q: In an R-C circuit, a resistor, an uncharged capacitor, a dc battery, and an open switch are in…

A: a. the current flow through the resistor in the RC circuit just after the switch is closed is i=emfR

Q: Phasors and alternating current. A 200 resistor is connected in series with a 4.00 µF capacitor and…

A: Given, v_{A} = (5.00V) cos [(800rad / s) * t] Capacitance=4.00 µF

Q: Electrosurgical units (ESUs) supply high-frequency electricity from resonant RLC circuits to cut,…

A:

Q: Question 2 ( - - A circuit has in series a resistor R Q, an inductor of L H, and a capacitor of C…

A: We have a series LCR circuit with initial current I(0)=0 A and initial charge Q(0)=Qo C. We need to…

Q: A Resistor-Inductor (RL) circuit is an electrical circuit composed of resistors and inductors driven…

A: The differential equation for R-L circuit is given by Ldidt + Ri = E didt + RLi = EL we know that…

Q: An inductor has a 53.4-2 reactance when connected to a 60.0-Hz source. The inductor is removed and…

A: Initially reactance =53.4ohm Initially frequency=60hz Final frequency= 49hz Vrms=120v

Q: Electrosurgical units (ESUs) supply high-frequency electricity from resonant RLC circuits to cut,…

A:

Q: Solve using mathematical model of SERIAL R-L ELECTRIC CIRCUIT Kirchoff's Second Law says that in a…

A: It is given that

Q: An inductor and a capacitor are connected in series. It is found that it takes takes 2 microsecond…

A: Capacitors are the devices used to store electrical charges inside them. Inductors are the devices…

Q: You are working in a factory and have been tasked with determining the electrical needs for a new…

A: The motor can be modeled as a series RL circuit, therefore the diagram, Given,

Q: An inductor has a 51.2-A reactance when connected to a 60.0-Hz source. The inductor is removed and…

A: Given: The inductance of the instructor is 51.2 Ohm and the frequency of the source is 60 Hz. The…

Q: An alternating source drives a series RLC circuit with an emf amplitude of 6.20 V, at a phase angle…

A:

Q: Example: A 300-V dc power supply is used to charge a 25-µF capacitor. After the capacitor is fully…

A:

Q: A student builds a series circuit using a 1.20 mH inductor and an initially uncharged 1.20 µF…

A: Given: The inductance is 1.20 mH. The capacitor is 1.20 μC. The current is 19.0t.

Q: The resistance in an RLC circuit is doubled. (a) Does theresonance frequency increase, decrease, or…

A:

Q: You make a circuit with a function generator at 3.39 kHz battery, a 51.0 Q resistor, and an inductor…

A:

Q: In the figure shown, a circuit contains two identical resistors with resistance R = 5 Q and an…

A:

Q: Both 1) A capacitor is charged by a constant current of 4.0 mA for 0.80 s. If the potential…

A: Dear srudent The Capacitance is given by : C = Q/V Where Q= total charge and V= Potential difference…

Q: A microscope illuminator uses a transformer to step down the 120 V AC of the wall outlet to power a…

A: (a) The power is given by, P=V2R Here, V is the voltage and  The resistance of the bulb filament is…

Q: Students who are studying LR circuits obtain some identical inductors with a common inductance value…

A: Time constant tau = L/R. For fig 1: Net inductance L = L1 + L2 = L0+ L0 = 2L0 Net resistance R =…

Q: Determine the current i (t), if the initial current is zero.

A:

Q: Activity: If a 500-V dc power supply is used to charge a 25-pF capacitor. After the capacitor is…

A:

Q: "In the RLC circuit of the following figure: R = 100 Q, C = 0.1 µF, and L = 0.5 Henry. www QUESTION…

A: R = 100 ohm C = 0.1 μFL = 0.5 henry frequency (f) = 1000 Hz

Q: In the circuit the emf ɛ = 188 volts and the inductance L= 38.4 mH. What will be the magnitude of…

A:

Q: An alternating source drives a series RLC circuit with an emf amplitude of 6.32 V, at a phase angle…

A: The expression for the resultant emf is Em2=VR2+VL-Vc2 Here, Em is the maximum emf, VR is the…

Q: 1 A circuit shown consistsof threeSiis of inductanceś 1.0 H each and a 1.0 pF capacitance. At an…

A:

Q: Q3) an LRC circuit is set up with an inductance of 1/5 henry, a resistance of 1 ohm, and a…

A: In the given LRC circuit, given that the value of inductance and capacitance and resistance and also…

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention.