´A 480 250 360 130 320 360 х 450 Dimensions in mm
Q: Knowing that the tension in cable AC is 1260 N, determine (a) the angle between cable AC and the…
A: Given data *The tension in the cable is TAC = 1260 N *The coordinates of point A is A = (2.4, 1.8,…
Q: The 500-N weight is supported by two cables, the cable forces being F1 and F2. Knowing that the…
A: Given Weight, w = 500 N
Q: For the plate of Prob. 2.89, determine the tensions in cables AB and AD knowing that the tension in…
A: Consider the free body diagram of the given system considering A as the origin. Here,
Q: A disabled automobile is pulled by means of two ropes as shown. The tension in AB is 500 Ib, and the…
A:
Q: B P2.3 and P2.4 2.4 Two structural members B and C are bolted to bracket A. Know- ing that both…
A:
Q: Problem 1.- A stake is being pulled out of the ground by means of two ropes as shown. Knowing that…
A: Given data: The tension in the rope, T=120 N. The vertical resultant force is, Ry=160 N. Balance…
Q: A stake is being pulled out of the ground by means of two ropes as shown. Knowing that a = 30°,…
A:
Q: Points B, D, and C lie on the x-y plane and vertical force F is on the z-axis. If force F subjected…
A: Given: The coordinates of different points are : O= (0,0,0)A=(0,0,-4)B= (3,3,0)C = (2,4.5,0)D =…
Q: The end of the coaxial cable AE is attached to the pole AB, which is supported by the wire stays AC…
A:
Q: A transmission tower is held by three guy wires anchored by bolts at B, C, and D. If the tension in…
A:
Q: Q. 1 For the figure 1, determine the required tension in cable BC, if the resultant of three forces…
A: Since we only answer one question at a time, we will answer the first one. Please resubmit the…
Q: A wall section of precast concrete is temporarily held in place by the cables shown. If the tension…
A: The coordinates of A, B & C are: Let the tension is AB,AC are: Let the tension is AB,AC are:…
Q: Q1. Knowing that the forces values given as: F1=120 N, F23D160 N, F3=280 N, F4=65 N, a)Determine the…
A: Given data F1 = 120N F2 = 160N F3 = 280 F4 = 65N
Q: 2/88 If the resultant of the forces shown passes through point A, determine the magnitude of the…
A:
Q: Q2): 425 b 30 A steel tank is to be positioned in an excavation. Knowing that the magnitude of P is…
A: GivenP=500lb at an angle α from horizontal 425lb at an angle 30o from horizontal
Q: A steel tank is to be positioned in an excavation. Knowing that the magnitude of P= 500 lb,…
A: Given Force, F = 500 lb Find 1. Angle 2. Resultant, R
Q: Knowing that the two forces shown can be replaced by an equivalent force acting at O (no couple),…
A: If a force F is inclined at an angle θ with the horizontal, then the component of force along the…
Q: Knowing that the tension in rope AC is 365 N, determine the resultant of the three forces exerted at…
A: Given Data: The force F1 = 500 N The force F2 = 200 N The force F3 = 365 N θ is the angle between…
Q: Determine the magnitude of the concurrent forces HG shown. 5 KN H. 30 30 G 3 KN 45° K 3 KN
A: the magnitude of concurrent force HG
Q: Q1. Knowing that the forces values given as: F1=120 N, F2=160 N, F3=280 N, F4=65 N, a)Determine the…
A: Consider the diagram shown below for the components of the forces.
Q: Two forces are applied as shown to a hook support. Knowing that the magnitude of P is 35 N,…
A: Given Data: The magnitude of force F = 50 N. The magnitude of force P = 35 N. The angle made by the…
Q: The pole AB is held up by the rope attached to B. The magnitude of the force in the rope is T= 240…
A:
Q: Q1): The cable stays AB and AD help support pole AC. Knowing that the tension is 120 Ib in AB and 40…
A:
Q: Determine (a) the required tension in cable AC , knowing that the resultant of the three forces…
A: Given data as per the question Forces applied on the point C = 75 lb and 50 lb Calculations…
Q: Q/3 A rectangular plate is supported by hinges A and B and by cables DF and DG. Knowing that the…
A:
Q: Knowing that the tension in cable BC is 725 N, determine the resultant of the three forces exerted…
A: Find the resultant force at point B.
Q: A steel tank is to be positioned in an excavation. Knowing that a =20°, determine (a) the required…
A:
Q: determine the resultant of the forces indicated From (3,6,-1) A 100KN(-5,0,4) B 200KN(4,0,-5) C…
A:
Q: Problem 2 A barge is pulled by two tugboats. If the resultant of the forces exerted by the tugboats…
A:
Q: Q1): The cable stays AB and AD help support pole AC. Knowing that the tension is 120 Ib in AB and 40…
A:
Q: The hydraulic cylinder BC exerts on member AB a force P directed along line BC . Knowing that P must…
A: Given Load P component’s magnitude = 600 N To find The magnitude of the force Component along line…
Q: A force acts at the origin of a coordinate system in a direction defined by the angles e = 70.9° and…
A:
Q: To test the strength of a 625 × 500-mm suitcase, forces are applied as shown. If P = 88 N, (a)…
A:
Q: A truss supports the loading shown. Determine the equivalent force acting on the truss and the point…
A: Write the all forces in the vector form.…
Q: Cables AB, BC and AD support a 10 kips load as shown. Determine; a) The magnitude of the tensions in…
A:
Q: A beam supports three loads of given magnitude and a fourth load whose magnitude is a function of…
A: The beam is given as follows, Ballance the force in the y-direction to get the resultant equivalent…
Q: For the reinforcement shown, Determine by the method of nodes the magnitude of the force on the…
A: Given data F = 321 N P = 123 N a = 2.2 m b = 1.8 m θ= 76°
Q: A trolley that moves along a horizontal beam is acted upon by two forces as shown. Knowing that a =…
A:
Q: Q3: The hook support shown below subjected to three forces. Knowing that the magnitude of P is 35 N,…
A:
Q: Cable AC is 70 ft long, and the tension in that cable is 5250 lb. Determine (a) the x, y, and z…
A: a) The free-body diagram of the force acting on anchor C is shown as, The angle on anchor C in the…
Q: 1. Determine the minimum value of the magnitude of the force P, as shown, so that the resultant of…
A:
Q: For the post of Prob. 2.36, determine (a) the required tension in rope AC if the resultant of the…
A: (a) The expression for resultant force at point C in the vertical direction is, Fy=-1100 mm1460…
Q: QUESTION 5 Two structural members B and C are bolted to bracket A. Knowing that both members are in…
A:
Q: The end of the coaxial cable AE is attached to the pole AB, which is strengthened by the guy wires…
A: The component of force exerted on the pole at point A is FyA=85×sin60=69.28 lb Force acting at BC is…
Q: 2/88 If the resultant of the forces shown passes through point A, determine the magnitude of the…
A: Note - as per the company guidelines we are supposed to answer the first question. kindly post other…
Q: The supporting cable AB and AC are oriented so that the components of 360-N force along AB and AC…
A:
Q: Q2): 423 lb 30° A steel tank is to be positioned in an excavation. Knowing that the magnitude ofP is…
A:
Q: Q1. Knowing that the forces values given as: F1=120 N, F2=160 N, F3=280 N, F4=65 N, a)Determine the…
A: Given data F1 = 120N F2 = 160N F3 = 280N F4 = 65N
Q: 4. The block shown is acted on by its weight W = 400 lb, a horizontal force F = 600 lb, and the…
A: The vector sum of two or more vectors is the outcome. It's the outcome of combining two or more…
Q: The pole AB is held up by the rope attached to B. The magnitude of the force in the rope is T = 240…
A:
A rectangular plate is supported by three cables as shown. Knowing that the tension in cable AD is 429 N, determine the components of the force exerted on the plate at D.
Trending now
This is a popular solution!
Step by step
Solved in 2 steps with 4 images
- 18) In a HCP stucture as the volume of the unit cell increased atomic packing factor increases. Select one: True False12) The imperfections of crystals do not depend upon a. Deformation of the solid b. coordination number c. Rapid cooling from high temperature d. High energy radiation striking the solidA laser emits light of frequency 851523504007150 Hz. What is the wavelength of the light in nm? Round your answer to 3 significant figures.
- Name the imperfection of crystals when an impurity atom substitutes an original atom.It is a linear defect that revolves around the line that runs along the extra half-plane of atoms. a. Vacancy b. Dislocation of the edges c. Self-interstitial d. Dislocation of a screw e. Frenkel flaw Which of these is not a microscopic method? a. SEM b. XRD c. SPM d. AFM e. TEMThe orderly arrangement of atoms in a structure is known as crystalline structure. Select one: True False
- 11) Which of the following is constant during Atomic Packing Factor (APF) calculation a. All of the above b. Volume of an atom c. Number of effective atoms per unit cell d. Volume of unit cellhe crystal lattice has a -------------- arrangement a- One dimensional. b- Two dimensional. c- Three dimensional d- Four dimensional.D Name the Crystallographic Direction and Show the Steps