A 8µFcapacitor is connected in series with a 1260 resistor. The total current of the circuit is 87mAZ0", 339HZ. Calculate the magnitude of the total impedance. Enter your answer in the space provided. Round your answer to one decimal place. Your answer should be in Ohms but do not enter the unit.

A 8µFcapacitor is connected in series with a 1260 resistor. The total current of the circuit is 87mAZ0", 339HZ. Calculate the magnitude of the total impedance. Enter your answer in the space provided. Round your answer to one decimal place. Your answer should be in Ohms but do not enter the unit.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.1P: Given the complex numbers A1=630 and A2=4+j5, (a) convert A1 to rectangular form: (b) convert A2 to...

See similar textbooks

Related questions

Q: Solve for Vx and give the magnitude of Vx (in Volts). Let the source V= 76 20°V. 10 2 j4 Q ww ll V,…

A: Need to find magnitude of Vx

Q: A large consumer has a kVA demand and a KVAH tariff measured by 'sine' and 'cosine' watthour type…

A: The solution can be achieved as follows.

Q: A series circuit composed of 100-ohm resistor and a 20-microfarad capacitor is connected across a…

A: It is given that: R=10 ΩC=20 μFV=240 VF=60 Hz

Q: A substation has a maximum demand of 65300 W and a connected load of 119000 W. If KWhr generated in…

Q: V. A series circuit of two pure elements has the following applied voltages and resulting currents…

A: In this question, Voltage across the two pure elements is given and current in the flowing is also…

Q: What is the value of the equivelent impedance? 250 sa wwm 302 20Q 100

Q: QUESTION 11 A resistor, inductor, and capacitor are connected in parallel with a function generator.…

A: The solution is given below

Q: Given the circuit below operating at 60 Hz. Determine all relevant ;ILave=:ILpk=_ quantities.…

Q: For the circuit element below, determine whether the element is absorbing or supplying power and the…

Q: Short Problem: Given a series circuit comprised of the following element: 66.04-ohm resistor,…

Q: 8H 120 V 60 Hz coil Solve for the total current flowing in the given circuit. Copy paste these in as…

A: Answer is 39.78 milli ampere Or 0.0398 amp Current is equal to voltage/ impedance Here impedance is…

Q: The load is given as 6+8j ohms in the system. If the apparent power of the load is 15 kVA, the…

A: Given, Load impedance, ZL=6+8j ohms Apparent power, S = 15 kVA

Q: Assume that -1,274 Determine the imaginary part of the equivalent impedance of the circuit, that is,…

Q: QUESTION 3 You make the following measurements in a 3-phase electrical circuit: Voltageline-to-line…

A: #3Given dataVline=208 VoltIline=24.5cosϕ=0.60

Q: After studding the network answer the questions. 1. Find Is. 2. Find the current passing through the…

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and…

Q: ?A circuit element has an impedance of 86 225° when the frequency is 142 Hz. What is the reactance…

Q: Solve the electric network. You may use any of the 3 solutions to SLE (Gauss Elim-REF, GJ-RREF, or…

Q: (a) An electrodynamic wattmeter is used to measure the electrical power in a circuit. The diagram in…

Q: - The voltage drops across two components when connected in series across an AC supply are vi (t) =…

A: The circuit this is excited the use of alternating supply is referred to as an AC Circuit. The…

Q: QUESTION 3 A 450nF capacitor, a 820 ohm resistor, and a function generator are all connected in…

A: The solution is given below

Q: Three Inductive loads each of resistance R = 28 ohms and inductance L = 0.03 H are connected in star…

Q: Q.23: Find the effective current in each branch and the total dissipated power for the circuit shown…

A: .

Q: In the figure, the load absorbs 22.256 KVA at a power factor 0.544639 inductive. For the feeder…

A: The solution is given below

Q: A complex voltage given by: 10 er=100+75sin600t+50sin1200t+25sin1800t Volt, is applied across the…

Q: If the current in a circuit is 5 mA and lags the voltage by 36.9°, and the voltage is given by:…

A: The ac voltage in the circuit is, v(t)=10cos2π60tv(t)=10cos2πftf=60 The ac current in the circuit…

Q: 1- Which of the following statement is TRUE ? a. True power is measured in VA b. All the power drawn…

A: Dear student as per our guidelines we are supposed to solve only one question.kindly repost other…

Q: Given a variable resistor R of unknown resistance connected in parallel with an inductive reactance…

A: The solution is given below

Q: The voltage applied to a circuit having a resistance of 12 ohms is 150 sin 377t volts. Determine:…

A: Given data, The value of resistance is R = 12 ohm. The value of voltage is V = 150 sin 377t V. a)…

Q: 9. The power factor of a load on a 120 volt. 60HZ source is raised from 0.707 to 0.866 lagging by…

A: As per the guidelines of Bartleby we only answer first question since both question are not…

Q: A load consists of R=55 Q, X1=72 Q and Xc=21 Q. All the elements are connected in parallel across…

Q: What is the rms current through a resistor of 470 ohm connected to an AC power supply with a maximum…

A: Given, Resistance (R) = 470 ohms AC power supply voltage = 28 V peak

Q: b. Find the current I, e. Draw the power triangle. d. Find the type of elements and their impedance…

Q: The watthourmeter is an example of integrating instrument. The meter is connected with 22.5A, 230V…

A: In this question we need to find percentage of error in energy meter.

Q: For the circuit shown, determine the current through the 2+j5 ohms impedance. 1 2л jsn mm 2 B Loa D…

A: Impedance - Impedance represented by the symbol Z is a measure of the opposition to electrical…

Q: Given a variable resistor R of unknown resistance connected in parallel with an inductive reactance…

Q: Referring to the Figure 1 below, given the value of frequency, f =50 Hz Determine: - i) The phasor…

Q: ANSWER THE FOLLOWING PROBLEM: MAKE SURE TO SHOW YOUR COMPLETE SOLUTION AND ANSWER MUST BE IN FOUR…

A: Here given three loads a) lamp load 10 kW a unity power factor (b) motor load of 80 kVA at 0.8 power…

Q: A bank of three 42:1 single phase transformer connected in wye-delta is used to step down the HV…

Q: An alternating voltage v = 100 sin 120pi t volts is applied across a coil of resistance 32 Ω…

A: Given: An alternating voltage is v=100sin120πt And coil of resistance R=32 Ω Inductance of coil,…

Q: 2. A resistor of 6 0 and an unknown impedance coil in series draw 12 amps from a 120 volts, 60 Hz…

Q: A impedance of Z = 15z 35° ohms is connected across a source with a voltage of 207.846 sin (157.08t)…

A: We need to find out time period .

Q: A 150-kVA load has a power factor of 0.75 lagging. What is the kVA rating of connected capacitors to…

Q: 3/ Calculate the form factor of the triangular voltage waveform shown below v(t)4 10- t(sec) Ans…

A: Given Form factor:It is the ratio of rms value to the average valueForm factor=RMS valueAverage…

Q: The admittance of a network is (0.05– j0.08) S. Determine the values of resistance and reactance in…

Q: A series circuit of two pure elements has the following applied voltages and resulting currents of…

Q: R= 180 2 120 V 30 mH 1000 Hz coil Solve for total circuit Z. Copy paste these in as needed 2° (No…

A: The solution is given below

Q: A battery is connected in series with a small generator to supply a purely resistive load of 5 ohms.…

Q: Recording... www.falstad.com/ci... My Questions | bart. My Drive- Google * Question Completion…

A: The solution is given below

Q: A passive electronic component needs to be provided in the circuit, as shown in Figure 3, to improve…

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

AVERAGE POWER( NEED NEAT HANDWRITTEN SOLUTION ONLY OTHERWISE DOWNVOTE).
please solve all question 1.1) Calculate Vpk and Vpk-pk for 6 VRMS 1.2)Calculate Vpk and VRMS for 14.1414 Vpk-pk 1.3)Calculate Vpk-pk and VRMS for 20 Vpk 1.4)Calculate the time period for (a) 50Hz (b) 1kHz (c) 20kHz 1.5)Calculate the frequency for time period (a) 20mSec (b) 100uSec (c) 2 Sec
Rab = 11 for the indicated circle, if (Q5 *: R is the value of * 2012 892 512 a Rab 1212 2012 ww 112 212 b
Given the following Resistances and Inductors in Series and Voltage Source: R1 = 1,301 ohms R2 = 1,237 ohms L1 = 2 Henry L2 = 2 Henry Vs = 3 Volts Frequency = 51 Hz What is the Total Impedance (Amplitude) in ohms?
Determine the impedance of the pure element. Write the magnitude only in ohms in four decimal places. the correct answer is 270.6522 show solution pls thank you.
Two relays each with 20-ohm resistance and 0.16-henry inductance are connected in series. What is the equivalent impedance?a. 20 + j102.2 ohms c. 20 + j95.32 ohmsb. 20 + j120.63 ohms d. 10 + j25.32 ohms
l10 answer 9 and 10
What is the Average value of 169sin 377t? Answer: 107.59 volts
Solve the total power of the entire circuit(in watts)given:r1= 4 ohmsr2= 50 ohmsE= 65 V
Solve the following problem. Use four decimal places for accuracy. 1. A 3 phase, 4 wire system has the following currents: la=20cis0: Ic=28cis125 and Ib1 = 26.33cis235.76 all in amperes respectively. Find the line current Ib
A series RL is supplied by a voltage source of 10 Volts. If the R = 5 Ω and XL = 5 Ω , what is the rms value of the resistor voltage in Volts.
PLEASE RESOLVE! THE FINAL ANSWER MUST BE IN THE CHOICES. DC/AC MOTOR (UPVOTE WILL BE GIVEN. PLEASE WRITE THE COMPLETE SOLUTIONS LEGIBLY. NO LONG EXPLANATIONS NEEDED. ANSWER IN 2 DECIMAL PLACES. BOX THE FINAL ANSWER.) A current of (120-j150) A flows through a circuit when applied voltage is (8 + j12) V. A. What is the magnitude of the circuit impedance: a. 0.0635 ohm b. 0.0256 ohm c. 1.52 ohm d. 1.325 ohm B. What is the reactive power? a. 825.75 VAR b. 525.68 VAR c. 639.75 VAR d. 438.72 VAR