Start your trial now! First week only $4.99!*arrow_forward*

Question

A 9-cm-diameter smooth sports ball has a velocity of 36 km/h during a typical hit. Determine the percent increase in the drag coefficient if the ball is given a spin of 3500 rpm in air at 1 atm and 25°C.

Tagged in

Engineering

Mechanical Engineering

Find answers to questions asked by students like you.

Q: A particular frost-free refrigerator uses about 745 kWh of electrical energy per year. Express this ...

A: Click to see the answer

Q: The cloth shroud from around a mummy is found to have a 14C activity of 9.7 disintegrations per minu...

A: Given: The half time for decay, t1/2 = 5715 yr The disintegration per minute per gram of carbon, N =...

Q: Water is pumped from a 200-ft-deep well into a 100-ft-high storage tank. Determine the power, in kW,...

A: Given data: The rate of volume of the water pump from the deep well is V=200 gal/min The depth of th...

Q: Two steel plates are to be held together by means of 16-mm-diameter high-strength steel bolts fittin...

A: Given, Pb = 200 MPa. Ps=130 MPa db=16 mm The diagram shows that the nut and bolts are applying a ten...

Q: Determine the vertical reaction at the journal bearing support A and at the fixed support B, then dr...

A: Draw the free body diagram for a better understanding of the problem.

Q: The temperature difference between the hot and cold fluids in a heat exchanger is given to be ∆? at ...

A: The symbols representing the temperature difference in the hot and cold fluids at each end are not w...

Q: 1. (a) The gusset plate in Figure la is subjected to the forces of four members; F is 10 kN and the ...

A: Click to see the answer

Q: On March 16, 1990, an Air Force SR-71 set a new continental speedrecord, averaging a velocity of 211...

A: Click to see the answer

Q: A tension test was performed on an aluminum 2014- T6 alloy specimen. The resulting stress-strain dia...

A: (a). The proportional limit is the limit in the stress- strain diagram up to which the stress is di...

Q: volumetric strain rate as the rate of increase of volume of a fluid element per unit volume. In Cart...

A: The volumetric strain is written as The primary dimensions of each term are as follows: Similarl...

Q: Two identical hockey pucks are moving on a hockey rink at the same speed of 3 m/s and in perpendicul...

A: By using principle of impulse momentum For puck A (in Y direction) For puck B (in Y direction) Fo...

Q: Air whose density is 0.082 lbm/ft3 enters the duct of an air-conditioning system at a volume flow ra...

A: Click to see the answer

Q: Show that the volume expansion coefficient of an ideal gas is B=1/T, where T is the absolute tempera...

A: Assumption Pressure is constant ( P = C ) We know that change in volume due to thermal expansion i...

Q: A steel penstock has a 750-mm outer diameter, a 12-mm wall thick-ness, and connects a reservoir at A...

A: Given data: Outer diameter of penstock, d0 = 750 mm Thickness of the penstock, t = 12 mm Density of ...

Q: The gas pedal and the brake pedal are capable of causing a car toaccelerate. Can the steering wheel ...

A: The gas pedal and the brake pedal of the car are capable of producing an acceleration in the car. Th...

Q: Determine the speed v of the 50-Mg mass when it is just over the top of the steel post, if after imp...

A: Given Data: The mass of load is M = 50 Mg. The length of the steel post is L= 1 m. The maximum stre...

Q: A 64-lb block is attached to a spring with a constant of k = 1 kip/ft and can move without friction ...

A: Given Data: The weight of the block is: w= 64 lb. The value of the spring constant is: k=1 kip/ft. ...

Q: Consider a TV set that consumes 120 W of electric power when it is on and is kept on for an average ...

A: Given: The average time per day TV is kept on is t=6 h The power consumes by the TV is P=120 W The u...

Q: An 8-kg cylinder C rests on a 4-kg platform A supported by a cord that passes over the pulleys D and...

A: Given data as per the question mass of block A = 4 kg mass of block C = 8 kg mass of block B = 4 kg ...

Q: Define the coefficient of performance of a heat pump in words. Can it be greater than unity?

A: It is a mathematical approach which explains the work-ability of the heat pump. It depends on the wo...

Q: The graph shows how the resultant force applied to an object of mass 2.0 kg. The object is initially...

A: Write the given data:

Q: please show me how to do it in detail.

A: Click to see the answer

Q: Argon is compressed in a polytropic process with n = 1.2 from 120 kPa and 10°C to 800 kPa in a pisto...

A: Given: The initial pressure of the argon in the piston-cylinder device is P1=120 kPa The final press...

Q: R12–7. The truck travels in a circular path having a radius of 50 m at a speed of v = 4 m/s. For a s...

A: The radius of the circular path is given as, The initial speed is given as, The speed is increased...

Q: 6-54. Locate the center of mass of the assembly. The assembly consists of a cylindrical center core,...

A: Calculate the masses of each part A, B and C separately and their respective z coordinate separately...

Q: Two model rockets are fired simultaneously from a ledge and follow the trajectories shown. Neglectin...

A: Given Data: The maximum height reached by rocket A is HA. The maximum height reached by the rocket ...

Q: The device shown is used to mix soils in order to provide in-situ stabilization. If the mixer is con...

A: Given Data: The inner diameter of the shaft is d = 3 in. The outer diameter of the shaft is D = 4.5...

Q: Question 5.7 In a parallel flow heat exchanger, hot fluid enters the heat exchanger at a temperature...

A: Click to see the answer

Q: The maximum allowable value of each of the reactions is 180 N. Neglecting the weight of the beam, de...

A: Drawing the FBD of the given figure: Here, RA = Reaction at point A RBY = Vertical reaction at poin...

Q: On both P-v and T-s diagrams, the area enclosed by the process curve represents the net work of the ...

A: The net work of the reversible process is represented by; Here, the term ∫Pdv represents the area e...

Q: Water discharging into a 9-m-wide rectangular horizontal channel from a sluice gate is observed to h...

A: Write the expression of the Froude number before the hydraulic jump. Since Fr > 1, thus the flow...

Q: The 40-kg gymnast drops from her maximum height of h = 0.5 m straight down to the bar as shown. Her ...

A: The mass of the gymnast, m = 40 kg The maximum height of the bar, h = 0.5 m The center of mass, y = ...

Q: A sphere of radius r and mass m is projected along a rough horizontal surface with the initial veloc...

A: Given data: The radius of the sphere is r. The mass of the sphere is m. The initial angular veloci...

Q: Water fl ows down a rectangular channel that is 4 ft wideand 2 ft deep. The fl ow rate is 20,000 gal...

A: Step 1: The width of the channel is w = 4 ft The depth of the channel is d = 2 ft The flow rate in ...

Q: (a) Two vertical rods, one of steel and other of copper are each rigidly fixed at the top and 60 cm ...

A: Write the expression of the cross-sectional area of the rods. Understand that the crossbar...

Q: 17-77. Disk D turns with a constant clockwise angular velocity of 30 rad/s. Disk E has a weight of 6...

A: Given Data: The angular velocity of disc D is ω = 30 rad/s. The radius of disc D and disc E is r = ...

Q: Ethane at 10 MPa and 100°C is heated at constant pressure until its volume has increased by 60 perce...

A: Given data To determine te final temperture using idael gas equation of state and compressibility f...

Q: Oil at 20°C is flowing through a vertical glass funnel that consists of a 20-cm-high cylindrical res...

A: Given: The diameter of pipe = 1 cm The height of cylindrical reservoir = 20 cm The height of the pip...

Q: D= 1.75 in d= 0.75 in r= .120 in

A: Calculate D/d and r/d ratio, Fr calculating the stress concentration factor we use the concentratio...

Q: 16–19. The vacuum cleaner's armature shaft S rotates with an angular acceleration of a = 404 rad/s²,...

A: Given data

Q: In a hydroelectric power plant, 100 m3/s of water flows from an elevation of 120 m to a turbine, whe...

A: Given data: *The volume flow rate of the water is V=100 m3/s. *The elevation of the flow of water to...

Q: 4. (a) Determine the force in each member of the truss shown in Figure 4a and state if the members a...

A: Click to see the answer

Q: Collar A is connected as shown to a 50-lb load and can slide on a frictionless horizontal rod. Deter...

A: Draw the free body diagram of force acting at the collar. Also, draw the force triangle diagram.

Q: Disk A has a mass mA = 4 kg, a radius rA = 300 mm, and an initial angular velocity ω0 = 300 rpm cloc...

A: Disk A Mass = 4 kg Radius = 300 mm Angular velocity = 300 rpm clockwise Disk B Mass = 1.6 kg Radius ...

Q: Two rods are connected by a frictionless collar B. Knowing that the magnitude of the couple MA is 50...

A: Given data Magnitude of couple at A is MA=500lb-in To determine the magnitude of moment at C for equ...