A chemist wants to extract a solute from 100 mL of water using only 300 mL of ether. The distribution constant, Kp, between ether and water is 2.49. Calculate q, the fraction of solute that would remain in the water under each of the extraction conditions. The chemist performs a single extraction with 300 mL of ether. The chemist performs three extractions with 100 mL of ether. = b The chemist performs six extractions with 50 mL of ether. q = > TOOLS x10

A chemist wants to extract a solute from 100 mL of water using only 300 mL of ether. The distribution constant, Kp, between ether and water is 2.49. Calculate q, the fraction of solute that would remain in the water under each of the extraction conditions. The chemist performs a single extraction with 300 mL of ether. The chemist performs three extractions with 100 mL of ether. = b The chemist performs six extractions with 50 mL of ether. q = > TOOLS x10

Introductory Chemistry For Today

8th Edition

ISBN:9781285644561

Author:Seager

Publisher:Seager

Chapter7: Solutions And Colloids

Section: Chapter Questions

Problem 7.107E

See similar textbooks

Similar questions

The dispersed phase of a certain colloidal dispersion consists of spheres of diameter 1.0 102 nm. (a) What are the volume (V=43r2) and surface area (A = r2) of each sphere? (b) How many spheres are required to give a total volume of 1.0 cm3? What is the total surface area of these spheres in square meters?
For each of the following pairs of solutions, select the solution for which solute solubility is greatest. a. Ammonia gas in water with P = 1 atm and T = 50C Ammonia gas in water with P = 1 atm and T = 90C b. Carbon dioxide gas in water with P = 2 atm and T = 50C Carbon dioxide gas in water with P = 1 atm and T = 50C c. Table salt in water with P = 1 atm and T = 60C Table salt in water with P = 1 atm and T = 50C d. Table sugar in water with P = 2 atm and T = 40C Table sugar in water with P = 1 atm and T = 70C
A solution is made by dissolving 0.455 g of PbBr2 in 100 g of H2O at 50C. Based on the data in Table 8-1, should this solution be characterized as a. saturated or unsaturated b. dilute or concentrated
For each of the following pairs of solutions, select the solution for which solute solubility is greatest. a. Oxygen gas in water with P = 1 atm and T = 10C Oxygen gas in water with P = 1 atm and T = 20C b. Nitrogen gas in water with P = 2 atm and T = 50C Nitrogen gas in water with P = 1 atm and T = 70C c. Table salt in water with P = 1 atm and T = 40C Table salt in water with P = 1 atm and T = 70C d. Table sugar in water with P = 3 atm and T = 30C Table sugar in water with P = 1 atm and T = 80C
You are asked to create a 0.35 M solution of calcium chloride (CaCl2) using a 250.0 mL volumetric flask. a.You have two solvents, difluoromethane (CH2F2) and ethanol (C2H5OH) available to dissolve your CaCl2. Which solvent would be more appropriate to use? Justify your response in 2 sentences or less.
What will be the normality of a solution obtained by mixing 0.45 N and 0.60 N NaOH in the ratio 2: 1 by volume?
A chemist attempts to prepare some very pure crystals of borax by dissolving 100g of Na 2 B 4 O 7 in200 grams of boiling water. He then cools the solution slowly until some borax crystallizes out.Calculate the grams of borax recovered in the crystals per 100 grams of initial solution (Na 2 B 4 O 7plus water), if the residual solution at 55 0 C after the crystals are removed contains 12.4%Na 2 B 4 O 7 . What is the percent yield or percent recovery of Na 2 B 4 O 7 . (MW: Na =23, O =16, B=10.8,H =1) round off up to 4 decimal places
What is Molarity of a 10.00% (v/v) acetic acid ? Density of pure acetic acid is 1.05 g/mL.
One gallon of certain lotion contains 946 mL of benzyl benzoate. Calculate the percentage (v/v) of benzyl benzoate in the lotion.
The solubility of manganese (II) hydroxide (Mn(OH)2) is 2.2 x 10-5 M. What is the Ksp of Mn(OH)2?
Matching - Match the term with its correct definition below. % V/V concentrated %W/V concentration molar concentration dilute % W/W ppm quantity of a given solute in a solution relatively small quantity of solute per unit volume of solution relatively large quantity of solute per unit volume of solution unit used for very low concentrations amount of solute, in moles, dissolved in one litre of solution concentration expressed as mass of solute in volume of solution concentration expressed as solute volume in solvent volume concentration expressed as solute mass in solvent mass
Consider the reaction of 75.0 mL of 0.350 M C₅H₅N (Kb = 1.7 x 10⁻⁹) with 100.0 mL of 0.437 M HCl. What would the total volume of the solution be after the reaction, in mL?