Answered: A circuit of resistance 422 dissipates…

A circuit of resistance 422 dissipates a power of 16W. Calculate (a) the current flowing through it, (b) the p.d. developed across it, and (c) the charge displaced in a time of 20 minutes.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: 39 Consider a system with input x[n] and output y[n]. The input-output relation for the system is…

Q: Draw a circuit that uses only one AND gate and one OR gate to realize the following function: (b)…

A: Given Boolean expression is F = WXYZ + VXYZ + UXYZ Asked to draw the circuit using only one AND…

Q: E 120 Vrms 60 Hz 30° R1 1002 L1 m 150m H L 0 A D R 5002 L 250m H R3 2502 C1 HH 30μF E1 150 Vrms 60…

A: To find the current that goes through the load first convert the above circuit into the rectangular…

Q: A 160 resistor, an 830 inductive reactance, and a 20 capacitive reactance are in series. A 120V 60Hz…

A: In this question, We need to determine the current in the circuit. We know As per ohms law,…

Q: Write a function using the block diagram shown below

A: Output of AND gate is the product of the inputs . And output of the OR gate is the sum of the…

Q: The charge entering the positive terminal of an element is q= 43sin(4xt) mC, while the voltage…

Q: 4.20 A 25-KVA, 2200/220-V, single-phase transformer has an equivalent series impedance of Zel = 3.5+…

Q: A 60-Hz induction motor runs at 860 r/min at full load. Determine a. the synchronous speed, b. the…

A: Given: In an induction motor, Supply frequency, f=60 Hz. Speed, Nr=860 rpm. Number of poles, P=8.

Q: or a uise litude modulated (PAM) transmission of voice signal having maximum frequency equal to fm =…

Q: Q- A carrier wave of frequency 2.5 GHz amplitude is modulated with two modulated with two modulating…

A: Given- Carrier wave frequency=2.5 GHz, Modulating frequencies=1 KHz & 2 KHz, To Find- The total…

Q: 1. Determine the voltages V1, V2, and V3, below using the principle of SUPERPOSITION. V3 |v1 ww 100…

Q: 4. Determine the power in the spectral components.

A: Given signal, VFM=100sin204.6π×106t+3sin30π×103t V

Q: 2. A switch with the following characteristics controls power to a 25-kW load as shown in Fig. P2.1.…

A: Since it is asked to solve questions (a) to (c) o we are solving these subparts only. The given…

Q: Find the total external armature current of a dc machine which has the following specifications: 120…

A: Using torque equation of DC motor calculate armature current. Torque of DC motor =12π×∅×Z×Ia×PA.…

Q: 2. An aging battery generating 200e-5t volts is connected in series with a 20 ohm resistor, and a…

Q: An accelerometer of sensitivity 10 mV/g is used to measure the acceleration of a vibrating beam. A…

A: Given, Sensitivity=10mV/g number of bit=12 bits sampling frequency, fs=25KHz cpacitance C1=1 nF

Q: Calculate the current in the loop, 10 Ω 20 V 5Ω {+- 10 V 80 V 20 Ω

A: Apply KVL in the loop Let the current in the loop be "i" in clockwise direction.

Q: PRELAB 1. Using one of the relationships for resistors connected in parallel, solve for the total…

A: In this question we need to find a equivalent resistance of the given circuit. As we see in given…

Q: Yız (G₁ Z-4% 20MVA X, -15% X₂=18% X-3% If: T1: 11kV-138 kv T2: 11kV-138kV T3: 20 kV-138 kv G1: 11kV…

Q: For the circuit shown below. Find ib 9V 1 ΚΩ W + 3 ΚΩ www • 2 ΚΩ +1 40a

A: Given circuit diagram, ib = ?

Q: What benefits do digital systems have over analog ones?

A: Benefits of digital systems over analog system: Digital systems are using digital signals to…

Q: A 500 lossless line has load voltage V₁ = 10 e/25° V and load impedance 50 e/³0⁰ 9. Find the value…

Q: If the power of an elementary electric dipole is 100 kW, what should be the numerical value of the…

A: Note: We have considered Half wave electric dipole antenna. According to the question, if power of…

Q: for the following circuit fill in (answer in phasor form the blanks ): Vs=5 sin 10t b) v=....... i…

Q: 2. Determine Vx. 8 M +Vx- 100V (+ 4^ JA an 4.0 pan 2.50

Q: 1) A dc-dc buck converter has a 48 V input. This converter is connected to a dc motor that spins at…

A: Given Buck converter input voltage Vin=48 V Buck converter output voltage =24 V @ 2000 rpm…

Q: Solve for VDS round off your answer with 1 decimal value. VG=0V www lp 5 mA +1₁ RG 10 ΜΩ VDD +15 V Q…

A: Apply KVL in drain source loop to find drain to source voltage . According to kvl sum of the voltage…

Q: For the core of Fig. (4), determine the flux density B in teslas and find the relative permeability…

A: It is given that: ϕ=6×10-5 WbA=1.2×10-3 m2μ=1.17×10-3 WbA.m

Q: 2. Find Ix.

A: Given- Source current= IS1 = 2A IS2 = 4A Voltage source- V1 = 4 V To find- Current Ix =?

Q: 4. If Req= 6 ohms, determine R. Rea Tn – — || Ղ R - Տոռ 4 – կռ - 3. - 5n

A: Given

Q: Determine io from the given circuit below. www 2.2 Ω ہے 500 V 200 io www 46 Q ww 50 Q www 30 Ω 9Q

Q: Q1] for the following circuit choose the correct answer Assume that the circuit operates at w = 50…

Q: 1. Given the Circuit below, find branch currents 11, 12 and 13. ↓ 50 ww 15V i1 6Ω www 1002 10V i2 4Ω

Q: Write a function using the block diagram shown below: a b' a D D

A: This is a basic problem of logic gate function. The solution is given in the next step.

Q: V₁ = h(t) = [4-e-Ju() N₁ = ? Use the convolution theoren to find (+)

A: Use convolution theorem to find output Vo. Output Vo is the convolution of input Vi(t)and h(t) I.e.…

Q: Two DC generators, each with armature resistance of 0.02 ohm and field resistance of 50 ohms run in…

Q: Find the percent modulation of an AM wave whose total power content is 2500 W and whose sidebands…

Q: 3. Determine the voltage across the 40-ohm resistor. 60V 250 M 4052 12.0 8n 18 18 18

A: We will find out the voltage across the given resistor by using of voltage division rule .

Q: 5. A unity gain feedback system has an open loop transfer function given by G(s) = k (s+3)(s+5)…

Q: 3. A short shunt compound generator delivers 100 amperes at a terminal voltage of 200 V. Armature…

Q: Q1) Consider the signal x(t) = 3 *exp(-0.5t) * u(t), where u(t) is the unit step function. (a)…

Q: Feedback & Control Systems - State-Space Representation Write the state-space representation of the…

A: The set of all potential and recognized states for a system is known as state space. Each distinct…

Q: 2 52 Req R14.0 R33.13 www. R14.0 R2 3.0 R45.0

A: We need to find out the equivalent resistance for given circuit , we will do star to delta…

Q: For the op-amp shown in the following figure, the voltage gain is equal to------- Vino 3 ΚΩ 80 ΚΩ…

A: Circuit is given as:

Q: Expand the expression to a standard SOP form: a. A B + AB' C + ABC

A: The basic digital electronics problem on boolean expression is solved as follows.

Q: If (211)X = (152)8, then the value of base x is?

A: Given expression, 211x=1528.

Q: A 220 V three phase motor takes 21,437 W at 0.71 lagging power factor. What is the ine curent?…

A: For 3 phase,P3ϕ=3 VL IL cosϕ IL =P3ϕ3 VL cosϕ For 1 phase,P1ϕ= VL IL cosϕ IL =P1ϕ VL cosϕ

Q: IN FIGARE BELOW (a) HOW MANY NODES ARE THERE? (b) HOW MANY BRANCHES ARE THERE? (C) IF WE MOVE FROM B…

A: Given- A circuit with no. of current source =2 No. of resistor = 5 To find- Number of nodes= ?…

Q: Question 25 Assume that the N-channel MOSFET shown in the following figure is ideal, and its…

A: Given- N-channel MOSFET, Threshold voltage=+1.0 V, To Find- The voltage Vab.

Q: X Z D D f

A: The logic function is solved as below.

Concept explainers

Electrical Heating Unit

The conversion of electrical energy to heat energy is known as electric heating. The heating system that converts the electrical energy to heat energy for various application is called electrical heating unit. Electricity is employed as the firing mechanism in electric heating systems, which transforms electric current to heat. Electric heaters have heating elements in the form of electric resistors.

Question

Solution in handwritten

A circuit of resistance 422 dissipates a power of
16W. Calculate (a) the current flowing through
it, (b) the p.d. developed across it, and (c) the
charge displaced in a time of 20 minutes.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

In your own words, describe Ohm's law. Give two instances from the real world or from your educational career in which it would be used.
(a) What are the voltages at vC1 and vC2 in the circuitas shown = −1.6 V, IEE = 2.5 mA,RC = 600 , and VREF = −2 V? (b) Redesign IEEand RC in the current switch described in part (a)to operate at one-tenth of the power with the samevoltages.
The headphones have a resistanceof 600Ω . The headphone amplifier in a battery-powered deviceis designed to deliver 0.1 W to the headphones. If theresistance of the headphones is 24 , calculate thevoltage and current required from the dependentvoltage source (Av in our model) to deliver 0.1 Wto the headphones. How much power is deliveredfrom dependent source? How much power is lost inthe output resistance?
a)Determine a numerical value for each current and voltage (i1, v1, etc.) in the circuit shown below.b)verify that the principle of conservation of power in indeed true
Using the following values for the circuit in the figure, find what is required in the questions? For the circuit in the figure, find the ones requested in the questions by using the following values? VDD= 30 V, IDSS=8 mA, VP=-6V, R1=110 MΩ, R2=18 MΩ RD=1.9 kΩ, RS=9.12 kΩ VG=? VGS=? ID=?
Design a 24v zener regulated power supply circuit that will power a 500 ohms load with 1A of of current. Determine the power rating of both bleeding resistor and load resistor. Note the computed power dissipation differ from the required power rating of the device.
Which of the figures is the DeMorgan equivalent of the Reference Circuit shown below? Fig A Fig B Fig D Fig C
For the circuit in the figure, find the ones requested in the questions by using the following values? VDD= 30 V, IDSS=8 mA, VP=-6V, R1=110 MΩ, R2=18 MΩ RD=1.9 kΩ, RS=3,68 kΩ VG=? VGS=? ID=? VD=? VS=? VDS=?
S3) Calculate the current IB, IC and voltage VCE in the circuit in the figure and examine whether it is conduction or not? (VBE=0,7V , β=80)
a) The power, P, consumed by a resistor of resistance R, is given by P = E^2R Given that E = 20 V and R = 1000ꭥ, using partial derivatives, find the approximate change inpower if E is decreased by 0.5 V and R is increased by 50ꭥ.b) Check and compare your findings using standard electrical principles.
With no load attached, the voltage at the terminalsof a particular power supply is 50.8 V. When a 10-Wload is attached, the voltage drops to 49 V.a. Determine vS and RS for this nonideal source.b. What voltage would be measured at the terminalsin the presence of a 15- load resistor?c. How much current could be drawn from this powersupply under short-circuit conditions?
Suppose a 8-V battery has an internal resistance of 0.3 ohm. What is the current that flows through the battery, if the battery terminals are momentarily shorted together? What is the terminal voltage if the battery delivers 0.25 amps to a circuit?