A cone penetration test was carried out in normally consoli- dated sand, for which the results are summarized below: Depth (m) Cone resistance, q. (MN/m²) 2.0 3.12 3.5 4.25 5.0 5.14 6.5 9.23 8.0 12.2 The average unit weight of the sand is 16.5 kN/m'. Determine the friction angle at each depth using Eq. o' = tan 0.1 + 0.38 log

A cone penetration test was carried out in normally consoli- dated sand, for which the results are summarized below: Depth (m) Cone resistance, q. (MN/m²) 2.0 3.12 3.5 4.25 5.0 5.14 6.5 9.23 8.0 12.2 The average unit weight of the sand is 16.5 kN/m'. Determine the friction angle at each depth using Eq. o' = tan 0.1 + 0.38 log

Principles of Foundation Engineering (MindTap Course List)

9th Edition

ISBN:9781337705028

Author:Braja M. Das, Nagaratnam Sivakugan

Publisher:Braja M. Das, Nagaratnam Sivakugan

Chapter3: Natural Soil Deposits And Subsoil Exploration

Section: Chapter Questions

Problem 3.22P

See similar textbooks

Similar questions

In a site consisting entirely of clays, an electric friction conepenetrometer measures the cone resistance qc at a depth of8.0 m as 0.75 MN/m2. The water table is at 3.0 m below theground level. The unit weights of the clay above and belowthe water table are 16.5 kN/m3 and 19.0 kN/m3, respectively.Estimate the undrained shear strength, preconsolidationpressure, and overconsolidation ratio at this depth.
Following are the results of a standard penetration test in sand. Determine the corrected standard penetration number, (N1)60, at various depths. Note that the water table was not observed within a depth of 10.5 m below the ground surface. Assume that the average unit weight of sand is 17.3 kN/m3. Depth (m) N60 1.5 8 3.0 7 4.6 12 6.0 14 7.5 13
Following is the variation of the field standard penetration number (N60) in a sand deposit: The groundwater table is located at a depth of 6 m. Given: the dry unit weight of sand from 0 to a depth of 6 m is 18 kN/m3, and the saturated unit weight of sand for depth 6 to 12 m is 20.2 kN/m3. Use the relationship given in Eq. (3.13) to calculate the corrected penetration numbers.
In a deposit of normally consolidated dry sand a cone penetration test was conducted. Following are the result: Depth(m) Point resistance of cone, qc (MN/m²) 1.5 2.06 3.0 4.23 4.5 6.01 6.0 8.18 7.5 9.97 9.0 12.42 Assuming the dry unit weight of sand to be 16kN/m³, estimale the average peak friction angle, ф’, fo the sand. Use ф’=tan ¯1((0.38+0.27log(qc/ σ’o))
A standard penetration test was carried out in a normallyconsolidated sand at 25 ft depth where the N60 was determinedto be 28. The unit weight of the sand is 110 lb/ft3, andthe grain-size distribution suggests that D50 5 1.2 mm andCu 5 3.2. The age of the soil since deposition is approximately5000 years. Determine the relative density using thedifferent correlations discussed in Section 3.15