(a) Find the minimum bandwidth for an ASK signal transmitting at 7000 bps. The transmission mode is half- duplex.   (b) How mac address and IP address can be helpful to secure your device on a network or how can be it dangerous for yours overall network.

Q: Q10. The _____ associates the hardware address of a network adapter with an IP address

A: This is a fill in the blank type of question. Answer is in step 2 with explanation.

Q: 2. What, if anything, is wrong with the figure as shown with the assigned IP addresses to the router…

A: Router is a device which is used to send and receive data from one network to other. Data are send…

Q: From the router IP address ( 192.168.0.1) and the subnet mask (255.255.255.0), calculate the network…

A: Router IP address and subnet mask is given. With logical AND we can find out the network address.…

Q: Question 2. Subnet mask for a particular network is 255.255.31.0 then tell about Which pairs of IP…

A:

Q: Compute the subnet mask, subnet address, broadcast address and the IP host ranges of 192.168.3.55/24…

A: Solution: 192.168.3.55/24   Here /24 means number of network bits is 24 and number of host bits is…

Q: Differentiate between DSR and AODV with respect to

A: Actually, DSR (Dynamic Source Routing) and AODV (AdHoc On Demand Distance Vector Routing)

Q: c) What is the network address and the broadcast address of your network? How many host computers…

A: Answering Question c : - For network address we will be using the IP address . - For calculating…

Q: mpute the subnet mask, subnet address, broadcast address and the IP host ranges of 192.168.3.55/24…

A: 192.168.3.55/24 Here /24 means number of network bits is 24 and number of host bits is 8. Therefore…

Q: Identify the default subnet mask and CIDR value for the IP address 13.75.137.90

A: The IP addresses in Class A range from 1.0.0.0 to 127.0.0.0. There is only 127 class A networks that…

Q: A 2 km long broadcast LAN has 107 bps bandwidth and uses CSMA/CD. The signal travels along the wire…

A: Solution ;

Q: Why do we need to configure a layer 2 switch with a default gateway address, in addition, to…

A: Answer: Layer 2 switches are an essential part of network setup in LAN environments. The switch…

Q: Consider a class C network with the subnet mask 255.255.255.41. How many network id (NID) and host…

A: CLASS C network, represents the small network . The Class C network's starting address is 192.0.0.0…

Q: It's unclear what happens to packets' MAC addresses when they travel from one network to another. Is…

A: Introduction: MAC:  Media Access Control address(MAC address). A unique identity provided to a…

Q: What information is required to establish whether or not the target IP address is located on the…

A: Introduction: When the host process is on the local LAN, it may interact directly with the other…

Q: 200.210.56.76/28 find the subnet mask, subnet id broadcast address and also find total number of…

A: Answer is in next step.

Q: AMQP uses IP addressing and ports.   Question 46 options:   True   False

A: Answer: The Advanced Message Queuing Protocol (AMQP) is an open standard for passing business…

Q: Assume that your network has the minimum MTU of 810 in the data path. Also, assume that IPv4 packet…

A: The minimum MTU of network = 810 Bytes Scene IP packet header has no options , therfore IPv4 packet…

Q: "Ethernet (802.3) and WLAN (802.11) use different Media Access Protocols" – If you agree with this…

A: WLAN stands for wireless Local area network and Ethernet also a LAN technology. Given that Ethernet,…

Q: {{Only answer not explain }} 1. A connection that provides a dedicated link between two devices is…

A: ANSWERS :- 1) A connection that provides a dedicated link between two devices is known as…

Q: AT1 circuit provides a data rate of min 2.5Mbps and more. True or false?

A: According to the information given:- We have to find the correct option to verify the statement.

Q: An IEEE802.11g with 54 Mbps has 58 byte MAC header and 50 byte IP header, the antenna has…

A: Note- As per the guidelines, I am answering only the first question, please post the remaining…

Q: Identify the default subnet mask and CIDR value for the given IP address  IP: 134.164.60.16 .

A: Class B addresses range from 128.0.0.0 to 191.255.255.255 Therefore, the given IP address is of…

Q: To what methods does the department resort in order to guarantee the availability of network access…

A: Switched and routed networks employ various strategies to ensure network access availability.

Q: Consider a class C network with the subnet mask 255.255.255.41. How many network id (NID) and host…

A: In class C 24 bit network bit and 8 bit are host bit. Subnet mask : 255.255.255.41 in binary:…

Q: Supposing

A: 11Mbps IEEE 802.11b: The 802.11b standard provides for a maximum transmission speed of 11Mbps.…

Q: What is the network address and subnet mask of the hidden subnet (xxx.XXXX.XXXX.XXx/x) subnet? The…

A: The Answer is

Q: Why have some of these packets been sent to a MAC address that is not the Access Switch/Router?…

A: There are a couple of justifications for why packets may be shipped off a MAC address that isn't the…

Q: An analog signal carries 5 bits in each signal unit. If 3000  signal units are sent per second, find…

A: Note : As per company guidelines, we can answer one question per post. Please repost other 2…

Q: Question Two: Which layer of the OSI Model handle flow control and error control.     Which layer…

A: The Fourth layer of the OSI model i.e TRANSPORT LAYER , it ensures and provide mechanism such as…

Q: Does protecting switches, routers, and cabling ensure the security of data transmission networks

A: Introduction: The Data Transmission Network: The exchange of information between electronic gadgets…

Q: 91. A _______ is a device that operates only in the physical layer. a. passive hub b. repeater c.…

A: A _______ is a device that operates only in the physical layer.

Q: Explain packet loss at output ports and its prevention.

A: To be determine: Explain packet loss at output ports and its prevention.

Q: The OSI model layer responsible for synchronizing and maintains the flow of messages back and forth…

A: Question from Networking, we have to tell on which layer we are maintaining flow of messages and do…

Q: Six Stations, A through F, communicate using the MACA protocol.  Is it possible for two…

A: Six stations in a straight line, A through F, communicate using the Multiple Access with Collision…

Q: resses; III - It can use both optical fiber and twisted pair as a physical medium; IV - This is a…

A: Analyze the characteristics and identify the communication protocol: I - It can be used both for…

Q: Compute the subnet mask, subnet address, broadcast address and the IP host ranges of 192.168.3.55/24…

A: Given 192.168.3.55/24 In this  /24 means number of network bits is 24 and number of host bits is 8.…

Q: What are the different characteristics between 802.11 b, a, g, and n? Choose three random people and…

A: 802.11a: Operates in the 5.15GHz to 5.35GHz radio spectrum. Speed: Up to 54Mbps (actual throughput…

Q: Match the following. Note that even though an answer may be valid for more than one answer, only one…

A: a. Cat 3 UTP                                 -     Voice grade phone network cable b. cat 6 UTP…

Q: On a single LAN, there are 200 workstations and four servers connected by a number of switches.…

A: Local Area Network: A local area network (LAN) is a collection of computers and related peripherals…

Q: An analog signal carries 5 bits in each signal unit. If 3000 signal units are sent per second, find…

A: An analog signal carries 5 bits in each signal unit. If 3000 signal units are sent per second, find…

Q: What is the network address and subnet mask of the hidden subnet (xxXx.xXxx.XXXX.XXXX/Xx) subnet?…

A: GIVEN DATA

Q: Identify the default subnet mask and CIDR value for the given IP address IP: 13.53.73.151

A: Hello Student, hope you are doing well, I will be trying my best to explain and fulfill your query.…

Q: With respect to a network interface card, the term 10/100 refers to A protocol speed Ba fiber speed…

A:

Network transmission cabling

A network is a collection of devices connected by communication links. A device can be a computer or any instrument capable of sending and receiving data or information formed by other nodes toward the network. A channel that connects people or things is known as a network. It sends the data from one place to another. It is the basic concept of a computer, network, and data communications.