A force of 100 N is applied to the brake pedal, which acts on the cylinder—called the master—through a lever. A force of 500 N is exerted on the master cylinder. Pressure created in the master cylinder is transmitted to four so-called slave cylinders. The master cylinder has a diameter of 0.55 cm, and each slave cylinder has a diameter of 2.50 cm. How much pressure is transmitted in the hydraulic system? Express your answer in pascals and in atmospheres.

Q: The drawing shows a hydraulic chamber with a spring (spring constant = 1270 N/m) attached to the…

A:

Q: One end of a hydraulic lift is a car weighing 9000 N. The other end contains a block with mass m.…

A:

Q: An inverted differential manometer is connected to two pipes A and B which convey water. The fluid…

A:

Q: A hydraulic system has two pistons of different diameter and uses a liquid of density p=1260 kg/m3.…

A: pressure on side of smaller piston = F1/A1 = (1.3*9.8)/π(0.01)2  = 40552.68 Pascalspressure on side…

Q: A hydraulic press for compacting powdered samples has a large cylinder with a diameter of 10.0 cm…

A: Given Diameter of the large cylinder is d1=10.0 cm=0.100 m Diameter of the small cylinder is d2=2.0…

Q: In a hydraulic brake, a force of 100N is applied to a piston with area of 4 cm^2. a. What is the…

A: a) By the definition of the pressure we have P =F/A   = 100/4cm2 = 25N/cm2 P  = 25 N/cm2.(100cm/1m)2…

Q: Water flows through the S-shaped pipe shown in the figure below. At one end, the water in the pipe…

A:

Q: A hydraulic lift has two pistons: a small one of cross-sectional area 5.00 cm- and a large one of…

A: Given: area of small piston, a = 5 cm2  area of large piston, A = 300 cm2 mass on large piston, M =…

Q: A force, F of 1000 N is applied to the smaller cylinder of a hydraulic jack. The area a o of a small…

A:

Q: Consider the hydraulic lift shown in the figure. The small piston has an area Aj of 0.0330 m², and…

A: A) As per Pascal’s principle, Here, P1 and P2 are the pressures at the pistons of area A1 and A2,…

Q: HYDRAULIC LIFT. In the figure below, a hydraulic lift has one piston of diameter 8.0 cm and the…

A:

Q: What force (in N) must be exerted on the master cylinder of a hydraulic lift to support the weight…

A: Given Data: The mass of the car is m = 2100 kg The diameter of the master cylinder is dm = 2.40 cm…

Q: A force of 500 N is applied to a hydraulic jack piston that is 0.04 m in diameter. If the piston…

A: Given data: Force on hydraulic jack (F1) = 500 N Diameter of jack piston (d1) = 0.04 m Diameter of…

Q: Water flows in the horizontal pipe shown in the figure.  At A the diameter is 5.00 cm and at B the…

A: Diameter of the section A is d1 = 5 cm = 0.05 m Diameter of section B is d2 = 4 cm = 0.04 m Density…

Q: Area = 15 cm2 Area = 65 cm2 %3D %3D

A: Area of smaller side = 15 cm2area of larger side = 65 cm2mass of rock = 55 kg weight of rock = mg  =…

Q: The drawing shows a hydraulic chamber with a spring (spring constant = 1590 N/m) attached to the…

A: Given Area of smaller piston A1=15 cm2 Area of larger piston A2=65cm2 Spring constant K=1590N/m Mass…

Q: Consider the following hydraulic system. The car of mass 1000 kg is on the right hand side of the…

A:

Q: The cross-section area of Piston A1 is 0.000400m2 The cross-section area of Piston A2 is 0.000800m2…

A: Given data: Cross-section area of  Piston 1 (A1) = 0.000400 m2 Cross-section area of Piston 2 (A2) =…

Q: What is the total force on the bottom and each side of a full rectangular water tank that has length…

A: Given:- The  rectangular water tank  L=20 ft W=5 ft d=15 ft water weight Wwater =62.4 pound/ft3…

Q: A force of F1 = 373 N is applied to a hydraulic jack pump piston with a diameter of D1 = 0.0177 m.…

A: Given data:  Input force (F1) = 373 N Diameter of input piston (D1) = 0.0177 m Diameter of output…

Q: The smaller and larger pistons of a hydraulic press have radius of 3.5 cm and 13.5 cm. The input…

A: Given data: Radius of the smaller piston r1=3.5cm Radius of the larger piston r2=13.5cm Input force…

Q: The drawing shows a hydraulic chamber with a spring (spring constant = 1190 N/m) attached to the…

A:

Q: A force of 343 N is applied to a hydraulic jack piston that is 0.0388 m in diameter. The second…

A:

Q: The mattress of a water bed is 2.5 m long by 2.5 m wide and 38 cm deep. a). Which of the following…

A: Given: The length of the water bed is 2.5 m. The width of the water bed is 2.5 m. The depth of the…

Q: The drawing shows a hydraulic chamber with a spring (spring constant = 1100 N/m) attached to the…

A:

Q: In a hydraulic garage lift, the small piston has a radius of 4.0 cm and the large piston has a…

A: Given:

Q: Consider the hydraulic lift shown in the figure. The small piston has an area Aj of 0.0330 m², and…

A: Given: F1=18N,  A1=0.033m2, y1=0.2m            A2=4m2  Find:   F2, y2, W1, W2…

Q: What force (in N) must be exerted on the master cylinder of a hydraulic lift to support the weight…

A:

Q: A water pipe having a 2.43 cm inside diameter carries water into the basement of a house at a speed…

A:

Q: A force of F1 = 374 N is applied to a hydraulic jack pump piston with a diameter of D1 = 0.0192 m.…

A:

Q: As shown in the figure below, a hydraulic system has two pistons of different diameter and uses a…

A:

Q: 1.) The small piston of a hydraulic lift as shown in the figure has a cross-sectional of 3.00 x 104…

A: Given :  area of cross-sectional of small piston(A1) =3×10-4m2 area of cross-sectional of outer…

Q: A force of F1 = 397 N is applied to a hydraulic jack pump piston with a diameter of D1 = 0.0183 m.…

A: In this question we have to find the magnitude of the output force F2. Please give positive feedback…

Q: A water pipe having a 2.34 cm inside diameter carries water into the basement of a house at a speed…

A: This question is based on Mechanical Properties of fluids topic. Bernoulli's Principle states that…

Q: In a car service station, a force of 130 N is required to raise the car on the hydraulic lift. If…

A: Given: The applied force is 130 N. The diameter of the hydraulic lift is 21 times as radius of…

Q: In a simple hydraulic system piston 1 has a cross section area of 0.000050 m2 , and piston 2 has a…

A: Given: The cross-section area of piston 1 is 0.00005 m2. The cross-section area of piston 2 is…

Q: A water pipe having a 2.34 cm inside diameter carries water into the basement of a house at a speed…

A:

Q: The diameters of the pistons on a hydraulic press are 5.0 cm and 40 cm. When a force of 50 N is…

A: Given data:  Diameter of smaller piston (d1) = 5.0 cm = 0.05 m Diameter of larger piston (d2) = 40…

Q: A hydraulic piston has two surfaces which can move when a force is applied to them. On the left…

A: a)The total force on the right side will be,

Q: Both a gage and a manometer are attached to a gas tank to measure its pressure. If the reading on…

A: Given:  P = 80 kPa d (mercury) = 13600 kg/m3 d (water) = 1000 kg/m3

Q: A water pipe having a 2.89 cm inside diameter carries water into the basement of a house at a speed…

A: Given data: Inside diameter at section 1, d1=2.89 cm=0.0289 m Speed pf water at section 1, v1=0.861…

Q: A 65 kg rock is 120 m deep in saltwater. Density of saltwater is 1030 kg/ m3. The pressure on the…

A:

Q: A schematic of a homemade hydraulic jack is shown in the figure below, with cylindrical tube ends of…

A: Pascal law:- Pressure exerted by any external agency will equally imparted to the all gaps or hole.…

Q: As shown in the figure below, a hydraulic system has two pistons of different diameter and uses a…

A:

Q: A force of F1 = 345 N is applied to a hydraulic jack pump piston with a diameter of D1 = 0.0168 m.…

A:

Q: A hydraulic jack has an input piston of area 0.0560 m2 and an output piston of area 0.750 m2. How…

A: input area, a = 0.056 m2  output area, A = 0.75 m2  Output force, F = 1.4 x 104 N

Q: A hollow ball with a diameter of 3.72 cm has an average density of 0.0843 g/cm. What force must be…

A: The needed buoyancy-(G)＝The force required＝(density of water) × gravity × (volume of T.T. ball) - mg…