Answered: A high tension (HT) supply of, say, 6…

Science

Physics

A high tension (HT) supply of, say, 6 kV must have a very large internal resistance. Why?

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter10: Direct-current Circuits

Section: Chapter Questions

Problem 3CQ: Show that the power dissipated by the load resistor is maximum when the resistance of the load...

See similar textbooks

Related questions

Q: If the 0.100-mm diameter tungsten filament in a light bulb is to have a resistance of 0.200 Ω at…

A: The area is,

Q: Find the equivalent resistance of the combination of resistors shown in the figure below. (R, = 3.12…

A: Given R1 = 3.12 u-ohm R2 = 17.1 u-ohm

Q: 15.0 (2 10.0 Q 20.0 Q 40.0 V イ介介分 16.0 Q

A: Given Data : The voltage of the battery is given as V = 40V The above-shown circuit has 2 resistors…

Q: Suppose now you have two copper wires of the same length, one with a diameter of 0.10 mm and one…

A: We know that resistance of a wire from is R=ρlA…

Q: An experimenter accidentally touches a 240 V dc line. If his skin resistance is 10 000 Ω, what value…

A: Given data : Voltage (V) = 240 V Resistance (R) = 10000 Ohm

Q: If the 0.100-mm diameter tungsten filament in a light bulb is to have a resistance of 0.200Ω at…

A: Given

Q: You need a 45 W resistor, but the stockroom has only 20 W and 50 W How can the desired resistance be…

Q: A 15.5 V battery is connected to a 102 Ω resistor. Neglecting the internal resistance of the…

Q: what is the factor for a cabe at 5degree celcius when calculating resistance od a cable? option…

A: Solution: The resistance of wire increases with increasing temperature. The electrical resistance of…

Q: When a voltmeter is connected across the terminals of a resistor, what usually happens to the…

A: When voltmeter is connected across the resistor, then the potential difference across the resistor…

Q: Power packs should have substantial overcapacity both with regard to voltage as well as current.…

A: Power packs should have substantial overcapacity both with regard to voltage as well as current.…

Q: Should the resistance of an ammeter be high or low, why? Should the resistance of a voltmeter be…

A: Required Should the resistance of an ammeter be high or low, why? Should the resistance of a…

Q: Calculate the effective resistance (in kΩ) of a pocket calculator that has a 2.15 V battery and…

A: According to Ohm's lawV=IRR=VIHereV=voltageI=currentR=Resistance

Q: Calculate the Thevenin equivalent resistance for the network across R₁. Given that R₁ = 3, R₂ = 6,…

Q: Ritche The potential difference across a 100 ohm resistor is 4.0 volts . What is the power…

A: All three resistance connect in parallel

Q: An electronic device designed to operate at any temperature in the range from –10.0ºC to 55.0ºC…

A: Pure carbon resistors have temperature coefficient of resistivity of α=-0.5×10-3 /Co Given…

Q: suppose that each headlight of your car uses a 3 A and that you accidentally left the headlights on.…

Q: A person notices a mild shock if the current along apath through the thumb and index finger exceeds…

A: Maximum current to avoid the shock = 80 uADry skin resistance = 4×105 ΩWet skin resistance = 2 ×103…

Q: If the 0.100-mm diameter tungsten filament in a light bulb is to have a resistance of 0.200 Ω at…

A: Given - Diameter of tungsten filament ,d = 0.100 mm =0.100 x 10-3 m Resistance of tungsten…

Q: If each resistor is rated at 0.50 W (maximum without overheating), what is the maximum voltage that…

Q: A copper wire has a resistance of 0.500 Ω at 20.0oC ,and an iron wire has a resistance of 0.525 Ω at…

A: Given:- Copper wire resistance Rc = 0.5 ohm at 20 degrees. Iron wire resistance Ri = 0.525 ohm To…

Q: Find the equivalent resistance of the combination of resistors shown below: R2 3.5 N R3 - 2.5 N R,…

A: R1 = 5.0 ΩR2 = 3.5 ΩR3 = 2.5 ΩR4 = 24.0 ΩR5 = 3.2 Ω

Q: An aluminum wire has a diameter of 2.59 mm. How many meters of this wire is needed to give a…

Q: 7) Determine the internal resistance and the power dissipated by the internal resistance of the…

Q: 44. In FET, .......control the resistance of the channel. O a. Base. O b. Gate. O c. Source. d.…

A: FET is a device in which the output current is controlled by the applied electric field. It has high…

Q: Rank according to magnitude of đifference in potential between points N and M from largest to…

A: In 'n' identical resistors connected in series, Rnet = nR Vi = Vn In 'n' identical resistors…

Q: Can a tungsten wire and an aluminum wire of the same length have the same resistance? Explain.

Q: Two parallel plates, connected to a 40- V power supply, are separated by an air gap. How small can…

Q: Find the equivalent resistance of the combination of resistors shown in the figure below. (R, - 2.12…

A: Given: R1=2.12 μΩR3=22.1 μΩ

Q: A device (such as a light bulb) experiences a voltage drop of 4.0 V across it while a DC current of…

A: The power dissipated by the device will be the product of the voltage drop across it and the current…

Q: How much power is dissipated by a 60 W (120 V) lightbulb when operated, using a dimmer switch, at…

A: P1=60 WV1=120 VV2=100 V

Q: What happens to the current when a 10-V battery is used to power a 10-ohms resistor? Why will this…

A: Given: Potential, V=10 V Resistance, R=10 ohms Formula: OHM'S LAW: V=IR Current can be found using…

Q: A 100-W lightbulb connected to a 120-V source experiences a voltage surge that produces 140 V for a…

Q: Find the equivalent resistance of the combination of resistors shown below R2 = 3.5 0 R3 = 2.5 0 R,…

A: Series Combination: When resistors R1, R2, R3, . . . , Rn are connected in series. The equivalent…

Q: +4.75 4.141, determine the value of For the circuit in Fig. Rsuch that the maximum power delivered…

A: Given : (Load) PMax = 3mW Now, firstly we will find out RTH As per the figure, 1RTH=1R+1R+1R…

Q: Are household circuits normally wired in series or in parallel? Why?

Q: Consider 3 resistors with resistances 1.15 × 102 Ω, 2.1 kΩ, and 3.8 kΩ. What would be their…

Q: Two different 12-V automobile batteries on a store shelf are rated at 600 and 850 “cold cranking…

A: When a cell is connected across a circuit then the current starts flowing from one point to another…

Q: Suppose a parachutist lands on a high-voltage wire and grabs the wire as she prepares to be rescued.…

A: For a circuit to have a potential difference, it should be closed. Any open circuit will have no…

Q: Determine the current I in each of the circuits below. a 2.0 A 0.5 A 4.0 A 1.0 A 2.0 A 0.7 A [1] 0.5…

A: The answers are below

Q: As the load resistance in parallel connection is increased, what happens to current? How about the…

A: Concept:- The given problem can be resolved using the concept of Ohm's law. According to Ohm's law,…

Q: If aluminum and copper wires of the same length have the same resistance, which has the larger…

Question

A high tension (HT) supply of, say, 6 kV must have a very large internal resistance. Why?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

The ignition circuit of an automobile is powered by a 12-V battery. How are we able generate large voltages with this power source?
Check Your Understanding Digital meters are able to detect smaller currents than analog meters employing galvanometers. How does this explain their ability to measure voltage and current more accurately than analog meters?
(a) What advantage does 120-V operation offer over 240 V? (b) What disadvantages does it have?
Consider the circuit below. The battery has an emf of = 30.00 V and an internal resistance of r = 1,00 . (a) Find the equivalent resistance of the circuit and the current out of the battery. (b) Find the current through each resistor, (c) Find die potential drop across each resistor, (d) Find the power dissipated by each resistor, (e) Find the total power supplied by the batteries.
Why is it possible for a bird to sit on a high-voltage wire without being electrocuted?
When working with high-power electric circuits, it is advised that whenever possible, you work "one-handed” or “keep one hand in your pocket." Why is this a sensible suggestion?
Check Your Understanding If you place a wire directly across the two terminal of a battery, effectively shorting out the terminals, the battery will begin to get hot. Wiry do you suppose this happens?
The power dissipated in a resistor is given by P = V2/R, which means power decreases if resistance increases. Yet this power is also given by P = I2R, which means power increases if resistance increases. Explain why there is no contradiction here.
A 0.50-W, 220- resistor carries the maximumcurrent possible without damaging the resistor. If the current were reduced to half the value, what would be the power consumed?
What determines the severity of a shock? Can you say that a certain voltage is hazardous without further information?
Use the atomic theory of matter to explain why the resistance of a material should increase as its temperature increases.
Power P0 = I0 V0 is delivered to a resistor of resistance R0. If the resistance is doubled (Rnew = 2R0) while the voltage is adjusted such that the current is constant, what are the ratios (a) Pnew/P0 and (b) Vnew/V0? If, instead, the resistance is held constant while Pnew = 2P0, what are the ratios (c) Vnew/V0, and (d) Inew/I0?