Engineering

Chemical EngineeringQ&A Library1. A closed stirred-tank reactor with two compartments is shown in Fig. El. The basic idea s to feed the reactants continuously into the first compartment where they will be preheated by energy liberated in the exothermic reaction, in the second compartment. The wall separating the two compartments is quite thin, thus allowing heat and a cooling coil is built into the second liberated in the reaction. Tests are to be component feed ie, no reaction) to evaluate the reactor's thermal Figure El (a) Develop a dynamic model for this process under the conditions of no reaction. Assume that q, Ti, and Te allStart your trial now! First week only $4.99!*arrow_forward*

Question

1 Rating

Tagged in

Engineering

Chemical Engineering

Find answers to questions asked by students like you.

Q: Formaldehyde is produced by catalytic oxidation of methanol by the following reaction: CH3OH + 1/2 O...

A: The basis of the process is taken as 100 mol CH3OH fed to the catalytic reactor.In the reactor, the ...

Q: Please answer parts (d), (e), and (f).

A: Part (d)For the input, U(s) = 4/s, the output Y(s) is written as shown below.

Q: 1:02 AM ll Verizon 99%- Done 4. The enthalpy of vaporization of water at 100 °C is 2256.9 kJ/Kg. Ass...

A: Watson equation is to be used as written below. Here, ΔH1 is enthalpy of vaporization at T1.ΔH2 is e...

Q: 2. Sugar cane can be assumed to consist of 15% sugars, 15% fiber (Solids) and 70% water (all based i...

A: Let the basis of the calculation be 1 kg of the sugarcane fed to produce non-crystallized sugar.Suga...

Q: Wet towels at the Biltmore Hotel are dried in a continuous dryer after washing for use by hotel gues...

A: Let the basis of the calculation for the given process be 850 kg/day of the dry towels. Water is rep...

Q: A typical column is shown in figure together with the known information for each stream. Calculate t...

A: Let the basis of the process be taken as 100 kg feed (F). Apply material balance on the overall proc...

Q: All details in question, please show all steps

A: Part (a)Michaelis-Menten equation to be used is written as equation (1).The reciprocal equation of (...

Q: Determine the kinetic energy in Btu/hr of 100 gallon/min of water flowing through a pipe with an ins...

A: The formula to calculate the kinetic energy of an object with constant mass in a rectilinear motion ...

Q: Acenapthalene has a normal boiling point of 277.5°C. At 197.5°C its vapor pressure is 100 mmHg. Esti...

A: At the given normal boiling point of 277.5°C, the heat of vaporization of Acenaphthylene is:

Q: A gas heater shown below in cross-section consists of a square sheet metal duct insulated on the out...

A: Part (a)The formula to calculate the equivalent diameter of the heater is:

Q: A new engineering graduate was putin charge of a reactor. The engineer quickly learned that the proc...

A: Note: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question...

Q: A continuous distillation column is operating at steady state to purify alcohol from a mixture of wa...

A: Since we are entitled to answer up to 3 sub-parts, we will answer the first 3 as you have not mentio...

Q: How should your lab notebook look like including title, purpose, and procedure?

A: There are few points we need to consider for lab notebook: Table of Contents:Leave several blank pag...

Q: This problem is (8.10) from a book "Thermodynamics and Statistical Mechanics An Integrated Approach...

A: For a system of variable composition (open system), the differential change in molar Gibbs free ener...

Q: In certain composition ranges of mixtures of ethylene tetrachloride (C2Cl4), isopropyl alcohol, and ...

A: Part (c)The basis of the calculation is taken as 100 lbs of feed mixture containing 40 mass% C2Cl4, ...

Q: Ethanol is produced by the hydration of ethylene. Some of the ethanol product is converted in an und...

A: Let the basis of the calculations be 100 moles of effluents from the reactor. Thus, the mole fractio...

Q: Cyclohexanol is a highly desired chemical precursor for the production of nylon (billions of kilogra...

A: Part (a):Since all the derivatives are zero and y=u=0 at the nominal steady state, Hence taking lapl...

Q: .Verizon 89% 5:33 PM Done 2. A liquid system consisting of 5 % mole ethanol and the rest being water...

A: Part (a) At constant pressure, the temperature at which the liquid mixture boils is determined as sh...

Q: This problem is (7.13) from a book "Thermodynamics and Statistical Mechanics An Integrated Approach...

A: Note that the given expression for the intensive Gibbs energy in a binary mixture of A and B is corr...

Q: This problem is (8.7) from a book "Thermodynamics and Statistical Mechanics An Integrated Approach ...

A: Part (a): On combining first and second law of thermodynamics, specific internal energy (u) is expre...

Q: 4.10 The contents of the stirred-tank heating system shown in Figure E4.10 are heated at a constant ...

A: Given thatQ(Btu/hr)= Constant rate of heat supply to the stirred tank heating systemW(lb/h)= flow ra...

Q: An open container is filled with water up to a depth of 3 meters and above water it is filled with o...

A: As per the given information, the tank is filled with oil and water as shown in Figure1.Density of O...

Q: The figure below represents a simple flow sheet for a single unit. Only the value of D is known. Wha...

A: Click to see the answer

Q: PLease show all steps

A: Part (a)Let the reaction taking place in the CSTR be, S→P According to the Michaelis-Menten equation...

Q: 38. Following is a labeled flowchart for a steady-state two-unit process, with boundaries shown to d...

A: In the given flowchart, the outer boundary encompasses the entire process. Thus, it gives the overal...

Q: Homework #1 1.18 Nitrogen gas can be injected into oil wells to increase the recovery of crude oil (...

A: Part (a)Note: As the table 1.2 and 1.3 was not provided with the question so, conventional symbols a...

Q: Diesel exhaust fuel (DEF) is a mixture of Urea (CH4N2O) and water (H2O). Often the urea in DEF is ma...

A: Let the basis of the calculation be 1 gallon of DEF (urea + water). Density of DEF is given as 9.1 l...

Q: The density of a particular fluid is given by the following equation:where rho = 64e^((7.9x10^-7)P) ...

A: part (a)Since exponential term is dimensionless hence units of 7.9x10^-7 is in^2/lbf as shown below ...

Q: 100 moles/ hr of gas containing 70% methane and 30% ethane is burned completely with 25% excess air....

A: (a) To determine the Adiabatic Flame Temperature (AFT) for the complete combustion of feed gas mixtu...

Q: A consulting firm has designed a steam system for a new process unit at your plant. Super heated ste...

A: Part (a)The diagram representing the cross section of the insulated pipe containing steam is shown b...

Q: Please answer part (g) only.

A: Part g:The part can be solved in two ways:Apply final value theorem and find the ultimate value of t...

Q: 5.2. A friend suggests that the intensive pair (e,T) is enough information to determine the state of...

A: For a single phase, single component system, calculate the degree of freedom (F) from the Gibb’s pha...

Q: A rectangular fin 1.0 ft long, 1.0 ft wide, and 2in. thick loses heat to the atmosphere at70 F. The ...

A: Given thatThermal conductivity=k=24 Btu/h.ft.0FHeat transfer coefficient=h= 2 Btu/h.ft2.0fAtmospheri...

Q: A horizontal steam pipe has an outer diameter of 8.9 cm and passes through a large room whose walls ...

A: The formula used to calculate the heat loss by radiation is written below:

Q: 1.19 A mixture of ethylbenzene (EB) and the three isomers (ortho, meta, and para) of xylene are wide...

A: Part (a):The normal boiling points of given components in mixture in their increasing order is given...

Q: A petrochemical storage tank is cylindrical in shape with a diameter of 6 m and a height of 10 m. Th...

A: Calculate the characteristic length of the cylinder as shown below:

Q: details in photo, please show all steps

A: Part (a)Michaelis-Menten equation to be used is written as equation (1).The equation used to prepare...

Q: .19 A liquid storage facility can be modeled by where y is the liquid level (m) and u is an inlet fl...

A: Part (a):Since all the derivatives are zero and y=u=0 at the nominal steady state, hence taking Lapl...

Q: 6. The manufacture of such products as penicillin, tetracycline, vitamins, and other pharmaceuticals...

A: Part (a)The basis of the process is taken as 98 lb/hr of the feed. The symbol used for vitamins is ‘...

Q: A bottle of carbonated water contains a liquid and vapor in equilibrium. The liquid contains 0.01mol...

A: Let the ideal mixing of components in liquid and vapor phases, Raoult’s Law is used for the given qu...

Q: The oxidative coupling of methane to form ethylene (2 CH4 + O2 -> C2H4 + 2 H2O) is known as the “...

A: c) Density is defined as mass per unut volume. Thus, density of the inlet mixture may be determined ...

Q: The extraction of acetic acid from water is both industrially and environmentally significant. Methy...

A: Part (a)100 kg of the feed in stream 1 containing 75 wt% water (W) and 25% acetic acid (A). Stream 2...

Q: 5.8. Using the extensivity property of the entropy, find the fundamental equation for the intensive ...

A: For entropy ‘S’, the extensive property in its differential form of fundamental equation is:

Q: 5-36C The velocity of a fluid flowing in a pipe is to be measured by two different Pitot-type mercur...

A: Here in this setup we find the difference in stagnation pressure and static pressure heads of the fl...

Q: A liquid stream containing half n-hexane and half n-pentane at 80°C and 5 atm is fed at a rate of 10...

A: Part (a)The Antoine equation to be used is written below.Here, Pi* is the vapor pressure of the comp...

Q: A mixture of methanol (methyl alcohol) and water contains 70.00 % water by mass.The specific gravity...

A: It is given that a mixture of methanol (methyl alcohol) and water contains 70.00 % water by mass.Bas...

Q: Please show all steps, thank you

A: AnswerPart a:Multiple stAnswerPart a:Multiple states are possible if enzymatic reaction is mass tran...

Q: A process is carried out in which a mixture containing 25.0 wt% methanol, 42.5% ethanol, and the bal...

A: Part (a)The flowchart for the given process is drawn below.Let ‘M’ represent methanol, ‘E’ represent...

Q: Liquid oxygen is used in the steel industry, in the chemical industry, in hospitals, as rocket fuel ...

A: Answer:The following properties are given in the question,

Q: Uric acid (UA) is degraded by uricase enzyme immobilized in porous Ca-alginate beads. Experiments co...

A: a)From units of rate in the given data (mg/L*hr), the reaction is first order and for the first orde...