Question

A lightning bolt with 10 kA strikes an object for 15 ms. How much charge will is deposited on the object?

Expert Answer

Want to see the step-by-step answer?

Check out a sample Q&A here.

Want to see this answer and more?

Experts are waiting 24/7 to provide step-by-step solutions in as fast as 30 minutes!*

*Response times may vary by subject and question complexity. Median response time is 34 minutes for paid subscribers and may be longer for promotional offers.
Tagged in
Engineering
Electrical Engineering

Related Electrical Engineering Q&A

Find answers to questions asked by students like you.

Q: Convert the following numbers to scientific notation.Following these Question and answer.29) 5000 KΩ...

A: We need to convert the numbers given below into scientific notations.

Q: An odd-parity circuit with 2n2n inputs can be built with 2n−12n−1 XOR gates. Describe two different ...

A: There are two different structures of the odd parity circuit. The maximum delay case is designed in ...

Q: Exercise: A square-wave voltage with amplitude 2 V and frequency 500 Hz is applied across an ideal i...

A: Amplitude of a square wave is 2 V, frequency is 500 Hz, and inductance is 500 mH

Q: A discrete-time periodic signal x[n] has a fundamental period of N: N-1, n=0, 1, 2, …, N-1. Determin...

A: Discrete-Time Fourier Series is given as-  

Q: A Silicon sample with nao 1013 cm3 is illuminated with light and 1.5x1012 electron-hole pairs /cm3 a...

A: As per honor code we can answer only one question at a time. Solution of question 1 is given below. ...

Q: How would I sketch the output waveform and calculate the frequency of a op-amp / signal generator?

A: Operational amplifier is a device which is linear and is capable of ideal DC amplification and is th...

Q: Methodology about cctv surveillance system

A: Shut circuit TV (CCTV), otherwise called video observation is the utilization of camcorders to trans...

Q: When the waveform shown in fig. (1) is applied to true responding ac voltmeter, the output would be ...

A: The signal given is applied to average responding AC voltmeter. The indicate value, true value, true...

Q: s) We noded 0holgss to Solve the aitteisb end nd uR loop Umobtis to Solue the wrts ond find

A: a) Nodal Analysis:Let V1 is the node voltage at node. 

Q: Find the field strength at 1 km away from an isotopic station of 1 kW power.

A: Field strength at a point located a distance r away  from a isotropic transmitting antenna can be ex...

Q: Resistor Color CodeWhat Color Code would a 30Ω ±5% look like?

A: Use color code table to obtain the desired result of your problem: -Let us consider a resistor have ...

Q: Airframe Electrical How much of the conductor should be exposed past the end of properly crimped con...

A: Crimped contact is used to provide maximum reliability and safety to electrical equipment.There are ...

Q: 1012 112 100 V Figure 4.20 System diagram for Problem 4.2a 1 2 10 2 100 V Figure 4.21 System diagram...

A: a) For calculating the pick up current here we have to calculate the line to line current for bus A ...

Q: Let p(t) ut) u(t 1). Compute and plot the following functions: (a) p(t) (b) p(t) p(t) (c) p(t) p(t)*...

A: (a)  Graph of function p(t) = u(t) – u(t-1) is plotted as follows, 

Q: What is the main difference between thermal runaway and punch through in an npn bjt.

A: A BJT, which is Bipolar Junction Transistor is a solid -state device in which the current through on...

Q: Determine the value of the thermal voltage at the room temperature.

A: In science, 27o C is taken as room temperature. It is converted in absolute temperature that is in K...

Q: Figure 3.60 For Prob. 3.11. 3.12 Using nodal analysis, determine V, in the circuit in Fig. 3.61. 40 ...

A: Nodal analysis depends primarity on the application of Kirchoff's Voltage Law (KVL). The circuit men...

Q: 1. Service-drop conductors must have__. A. Aufficient ampacity to carry the current for the load B. ...

A: Service drop conductors are the wires generally connected from utility top to the service point in t...

Q: Airframe Electrical System Question: In general, what factors areconsidered when selecting the prope...

A: While manufacturing, the sizes of the wire are selected according to a known standard called as Amer...

Q: What is the actual velocity of EM energy in the cable used for cable TV that has a propagation facto...

A: Velocity of light can be calculated in the following way:

Q: An NMOS transistor is operating in the saturation region and is having a W/L ratio equal to 20. If t...

A: Drain current for an NMOS in saturation region can be expressed as

Q: For a given 50 MHZ clock what would be the range of count used to generate a 100 kHz clock?

A: Frequency is divided at output of counter.

Q: 8- In the following circuit find i() 2Ω 0

A: From the circuit, write the expression for io(t) as follows:

Q: Exercise: For the circuit of Figure 4, using the resistor values of Table 1, calculate v2 (the volta...

A: The superposition theorem for any linear circuit states that the total current or voltage in any par...

Q: why 3-phase power has replaced 2-phase power.

A: Three phase system has phase difference of 120 degrees.Phasor diagram of 3 phase system is –

Q: Please help with B,C, and D. Also, please make it legiable sometimes it's too small so it's blurry.

A: The internal circuit diagram for an inverting OP-amp (pratical OP-amp) is  drawn in the figure.

Q: what will be the output of the following meters, if the input signal is the waveform show in fig

A: The output reading of each meter should be determined.

Q: UF cable used with a 24V landscape lighting system is permitted to have a minimum cover of___. a. 6i...

A: The table number 300.5 in the NEC (National Electrical Code) book of Unites States provides the mini...

Q: A charge of 0.05 C moves past a given point every 0.1 s. How much is the current?

A: If Q is the charge in coulomb (C), t is the time in seconds (s) and I is the current in amperes (A) ...

Q: What is current

A: Current: It is defined as the flow of negative charge carriers (electrons) from one region to anothe...

Q: Q3. By using the method of images, prove that the capacitance between conductor and earth, taking in...

A: From the diagram shown below, we can say that:

Q: If we want to have a Q+ state of 0, which of the following input combinations would work for a DFF w...

A: The table which gives input combinations with knowing the present and next state is called as excita...

Q: 2 A 8Ω 4Ω 12 V 6Ω 6Ω HI- Figure 3.46 For Review Questions 3.1 and 3.2. 3.2 In the circuit of Fig. 3....

A: The purely resistive circuit provided in the question can be solved by applying Kirchoff's Voltage L...

Q: 5.1 Dependent Sources 5.1 In the circuit of Figure P5.1 find the two values of kr (in S) for which p...

A: Given circuit is –

Q: i1 = 7 A, i2 = 6 A, i3 = 10 A, and i4 = -7 A. I need to find Vx using nodal analysis

A:  Values of currents given in the questions are-i1=7A, i2=6A, i3=10A and i4=-7AMark all the node-

Q: How does current generally flow in a complete electric circuit with more than one current source

A: Consider the circuit shown in Figure 1 consisting of two current sources of 250 mA and 150 mA  conne...

Q: Find out the expression of the output voltage.  Refer to the following diagram for the same.

A:  Given circuit diagram is shown below,

Q: 2Ω 4Ω 1H3%(t)に0 - 2A

A: When t < 0, the inductor acts as a short circuit. Let us say that current through the inductor is...

Q: Nt

A: To find the thevenin resistance or equivalent resistance:Thevenin resistance is determined by open  ...

Q: Airframe Electrical System Question: What is the recommended shield coverage area for wires and cabl...

A: The recommended shield coverage area for wires and cables that are susceptible to EMI is 85% coverag...

Q: Please read carefully. Assume that the resistor R equals 100 ohms. Also assume that where the resist...

A: Mark all the branches with their currents as shown below-

Q: Please answer all questions , and give me a sample answers 1- What is done to prevent a plan from be...

A: 1.The working plans of an architect are commonly complex due to the inclusion of more information.To...

Q: For the circuit of participation activity 2.3.7, compute the power of each element in the circuit an...

A: According to law of conservation of energy, it can neither be created nor be destroyed. For a circui...

Q: A 69-kV, three phase short transmission line is 16km long. The line has a per phase series impedance...

A: We need to determine the sending end voltage, voltage regulation, the sending end power, and transmi...

Q: In the following circuit, use either differential equation approach or the step by step method to fi...

A: STEP BY STEP METHOD:From the given circuit, the switch opens at t =0. That is, switch is in closed c...

Q: 3 Suppose that SS-1000H, DS-2000H, BP-1000, BX 0300H, and DI=04F0H Determine the memory address acce...

A: Question 3 and 5 are posted.  In that, first question (3) is solved as per rules. Repost the questio...

Q: CompressionLet’s take a look at compression.Take the file Fig 05-15 which can be found on the author...

A: 1. Right click on file and go to properties to get  the type of file format.Answer: a) Chapter 5.doc...

Q: Find voltage and currents across each resistor

A: Name the nodes of the circuit as shown in the figure and consider the branch currents as shown in fi...

Q: The minimum clearance for service drops not exceeding 600 V that pass over commercial area subject t...

A: To find the minimum clearance for service drop not exceeding 600 V that pass over commercial area su...

Q: Electrical Engineering Question

A: (a)Any system is BIBO stable if its poles lie in left side of s-plane or its pole having negative re...