A link in a mechanism for an automated packag-ing machine is subjected to a direct tensile force of1720 lb, repeated many times. The link is square,0.40 in. on a side. Specify a suitable steel for the3-3.link.

Given data as per question Force = 1720 lb Side of link = 0.40 in

Answered: A link in a mechanism for an automated…

Mechanics of Materials (MindTap Course List)

9th Edition

ISBN:9781337093347

Author:Barry J. Goodno, James M. Gere

Publisher:Barry J. Goodno, James M. Gere

Chapter11: Columns

Section: Chapter Questions

Problem 11.2.4P: Repeat Problem 11.2-3 assuming that R= 10 kN · m/rad and L = 2 m.

See similar textbooks

Similar questions

For the Problem-1, determine the critical load if its length is 700 mm
If I have a singular roller joint, in which total different directions can it provide a force in?
10000 lb is applied at G, pin C can have 5000 max horizontal load and 6000 vertical load, determine max angle of bed
An aluminum rod, made from alloy 6061-T6, is made in the form of a hollow square tube, 2.25 in outside with a wall thickness of 0.125 in. Its length is 16.0 in. It carries an axial compressive force of 12 600 lb. Compute the resulting design factor. Assume that the tube does not buckle.
A leafs spring contains 4 full-length and 8 graduated leafs. The eyebolts at the support are 20 inches apart and the system should carry a load of 400 lbs. If the thickness of the available bronze plate is 1“ and Sy = 80 ksi, what leaf width is required at FOS = 8?
In a bolted joint two members are connected with an axial tightening force of 2200 N. If the bolt used has metric threads of 4 mm pitch, the torque required for achieving the tightening force is
Solve the effective normal force on the rod CD Use units [N,mm] The mass of the load is: mk=21904 kg
Find magnitude and nature (tensile or compressive) of force in the members BD, BE, CE, HF, HG & IG . by using method of section
1.1.7.5 Hint: Determined as the lowest load considering all of the allowable compressive load of spar, shear stress of pin, and pressure stress of pin and connecting plate.
Find the maximum load that the system can support before buckling. Material steel and diameter 1 cm
The figure below is a schematic drawing of a shaft that supports two V-belt pulleys. The loose belt tension on the pulley at A is 15% of the tension on the tight side. The shaft material has a yield strength of 300 MPa and an ultimate tensile strength of 520 MPa. Calculate the shaft diameter.
Design a turnbuckle subjected to a load of 50 kN with permissiblestresses are in 166.67 Mpa in tension , 83.33MPa in shear and 166.67 MPa incrushing.

SEE MORE QUESTIONS

Recommended textbooks for you

Mechanics of Materials (MindTap Course List)

Mechanical Engineering

ISBN:

9781337093347

Author:

Barry J. Goodno, James M. Gere

Publisher:

Cengage Learning

Mechanics of Materials (MindTap Course List)

Mechanical Engineering

ISBN:

9781337093347

Author:

Barry J. Goodno, James M. Gere

Publisher:

Cengage Learning

SEE MORE TEXTBOOKS

A link in a mechanism for an automated packag- ing machine is subjected to a direct tensile force of 1720 lb, repeated many times. The link is square, 0.40 in. on a side. Specify a suitable steel for the 3-3. link.