A man weighing 400N climbs up a ladder 5 meters long. The ladder initially rests against a frictionless vertical wall and is at 58° above a rough floor with static friction coefficient of 0.25. Determine the location of the man that will cause the ladder to slide down. What is the magnitude and direction of the net force acting on the ladder at the floor?

A man weighing 400N climbs up a ladder 5 meters long. The ladder initially rests against a frictionless vertical wall and is at 58° above a rough floor with static friction coefficient of 0.25. Determine the location of the man that will cause the ladder to slide down. What is the magnitude and direction of the net force acting on the ladder at the floor?

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter14: Static Equilibrium, Elasticity, And Fracture

Section: Chapter Questions

Problem 64PQ: A One end of a metal rod of weight Fg and length L presses against a corner between a wall and the...

See similar textbooks

Similar questions

In the figure, horizontal scaffold 2, with uniform mass m2 = 29 kg and length L2 = 2.3 m, hangs from horizontal scaffold 1, with uniform mass m1 = 54 kg. A 17 kg box of nails lies on scaffold 2, centered at distance d = 0.80 m from the left end. What is the tension T in the cable indicated?
A metal ring of weight 120 N can slide up or down a vertical rod. The ring is attached by a cable to the ceiling (at the angle of 65° with respect to the ceiling) as shown in the figure. Assuming the static friction coefficient of 0.600 between the ring and the rod, find the minimal tension in the cable that will prevent the ring from sliding down the rod and thus keep it in place, a. 128 N b. 114 N c. 103 N d. 96 N e. 91 N
A uniform plank of length 2.00 m and mass 31.5 kg is supported by three ropes, as indicated by the blue vectors in the figure below. Find the tension in each rope when a 715–N person is d = 0.500 m from the left end. magnitude of T1 N magnitude of T2 N magnitude of T3 N
A ladder of length L = 2.4 m and mass m = 14 kg rests on a floor with coefficient of static friction μs = 0.55. Assume the wall is frictionless. 1) What is the minimum angle the ladder must make with the floor to not slip? 2) A person with mass M = 61 kg now stands at the very top of the ladder. What is the minimum angle to keep the ladder from sliding?
There are four forces acting on a pole, A = 10i N, B = 20j N, C = -30j N, D = -40i N. What should be the magnitude of force E that must be exerted on the pole to maintain static equilibrium? Note: i and j are unit vectors a. 24.65 N b. 31.62 N c. 46.20 N d. 52.78 N e. No Answer
Suppose the tension in both of the cables is measured to be 50 N and that the angle that each cable makes with the horizontal is known to be 30 degrees. What is the weight of the sign? * a. 150 N b. 50 N c. 30 N d. 25 N
A block of mass M = 10 kg is sitting on a surface inclined at angle θ = 45°. Given that the coefficient of static friction is μs = 0.5 between block and surface, what is the minimum force F necessary to prevent slipping? What is the maximum force F that can be exerted without causing the block to slip?
A 15 kg monkey climbs a uniform ladder with weight 1.2 *10^2 N and length L=3.00 m. The ladder rests against the wall and makes an angle of theta= 60.0 degrees with the ground. The upper and lower ends of the ladder rest on frictionless surfaces. The lower end is connected to the wall by a horizontal rope. HInt : Draw a force diagram for the ladder and the normal forces from the ground and wall acting on the ladder. A) find the tension in the rope when the monkey is two-thirds of the way up the ladder. B) The rope is frayed and can support a maximum tension of only 80N. Find the maximum distance that the monkey can climb up the ladder before the rope breaks. C) If the horizontal surface were rough and the rope were removed, how would your analysis of the problem change? What other information would you need to answer parts (a) and (b)
A 20.0-kg horizontal plank 4.00 m long rests on two supports, one at the left end and a second 1.00 m from the right end. What is the magnitude of the force exerted on the plank by the support near the right end? (a) 32.0 N (b) 45.2 N (c) 112 N (d) 131 N (e) 98.2 N
A One end of a metal rod of weight Fg and length L presses against a corner between a wall and the floor (Fig. P14.64). A rope is attached to the other end of the rod. Find the magnitude of the tension in the rope if the angle between the rod and the rope is 90.
The static friction coefficient between the block and the inclined surface is 0.2. What is the minimum force that should be applied to the block perpendicular the surface in order to prevent the block from sliding down?
The support shown below is connected to a control cable at point B and has a joint at C. For the loads shown, determine the magnitude of the reaction at the support at point C when: d1 = 0.19 m d2 = 0.25 m d3 = 0.49 m d4 = 0.47 m F1 = 263 N