A projectile object reaches a height of 303 m, if it is fired straight up using a spring-loaded gun. Using the same gun, what is the maximum height (m) that can be reached by the projectile if it fired at an angle of 19 ° from the vertical?

A projectile object reaches a height of 303 m, if it is fired straight up using a spring-loaded gun. Using the same gun, what is the maximum height (m) that can be reached by the projectile if it fired at an angle of 19 ° from the vertical?

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter7: Dry Friction

Section: Chapter Questions

Problem 7.78P: The figure shows a steel bar being processed by a rolling mill. Given that P=80kN and r =0.016,...

See similar textbooks

Related questions

Q: 2. A shell leaves a mortar with a muzzle velocity of 150mis directed upward at 60° with the…

Q: What is the value of the potential energy of the system at Position 2 with the datum at the level of…

Q: Projectile motion Challenge 1 A ball is thrown from a 10 m high cliff at the velocity 20 ms-1 with…

A: As a given the velocity for projectile v=20 m/s and Angle of projection is θ=30°So the Range of…

Q: For a fixed initial speed, t range of a projectile is determined by the angle

A: The time of flight is directly proportional to the angle of projectile. The smaller angle is chosen…

Q: A hunter shoots his rifle at an angle of 27.2° above the horizontal. He is holding the rifle so that…

A: Given : Velocity of bullet, v = 412 m/s Angle of projection, θ = 27.2o Time of flight, T = ?

Q: A body is thrown vertically upward with an initial velocity of 9m/s. Assuming that it falls freely…

A: GivenU=9m/st=2.5s

Q: Find the total rebound distance of a ball that is dropped from height of 7 m,with each rebound…

A: Geometric series

Q: Starting from a standstill, Abi (mass = 55.00 kg) performs a vertical jump. c.) If the duration of…

Q: T. A shell leaves a mortar with a Muzzle velocity of 500 fps dire3cted upward at 60° with the…

Q: 2. A bullet firea from a gun with a velocity of 80 ms-1 strikes the ground at the same level as the…

Q: A nozzle inclined at an angle of 60° with the horizontal issues a 50-mm diameter water jet at the…

A: At highest point , vertical velocity will be zero. continuity equation A1V1=A2V2

Q: stone is thrown up with a velocity of 72 m/s from the ground. While coming down, it strikes a glass…

A: Data given- Initial velocity = 72 m/s At maximum height (h) velcoity would be zero Height of the…

Q: 2. A block weighing 96.6 lb is dropped from a height of 4 ft upon a spring whose modulus is 100 Ib…

A: Given data: W=96.6 lbh=4 ftx=4 ink=100 lb/in Need to determine the velocity of the block.

Q: A body is thrown vertically upward with an initial velocity of 9m/s. Assuming that it falls freely…

A: GivenU=9m/st=2.55s

Q: A body is released from a great height falls freely towards earth. Another body is released from the…

A: As per given question we have determine distance separation between Two body

Q: A boy seated in a rapidly moving railroad car tosses a ball up into the air. Will the ball come down…

A: The reason you don't notice this motion is because everything around you is also moving with the…

Q: 6. A 10-ton load is to be lifted through a height of 60 ft within 40 seconds. Determine the minimum…

A: Given Load = 10 ton = 10*2204.62 lb = 22046.2 lb height = 60 ft time = 40 s To determine Minimum…

Q: NOTE: This is a multi-part question. Once an answer is submitted, you will be unable to return to…

Q: A stone is falling vertically downward from a tall building of height 120m. (a) How much time it…

A: Given that the stone is falling from building of height =120 m in downward direction . So its…

Q: Required information NOTE: This is a multi-part question. Once an answer is submitted, you will be…

A: The calculated kinetic energy of stone and height from which stone was dropped in ft.

Q: The figure below is an incomplete momentum bar chart for a collision that lasts 10 ms. What are the…

Q: bullet weighing 0.30N and moving at 660 m/sec. penetrates a 50N block and emerges with a velocity of…

Q: 2/72 With what minimum horizontal velocity u can a boy throw a rock at A and have it just clear the…

A: When an object is launched obliquely near the earth's surface, it follows a curving path with…

Q: 2- A pendulum is made by suspending a (7.00 kg) ball on a cord (5.00 m) long connected to the…

A: Given:Length of pendulum,L=5mMass of ball,m=7KgDistance pulled,s=1mNow,θ0=sL⇒θ0=15⇒θ0=0.2 radian

Q: A body of weight 370 N body moving to the left with a velocity of 14 m/s collides with another body…

A: Given data: v1i=14 m/sv2i=0v1f=0w1=370 Nw2=690 N Need to determine the final velocity of body after…

Q: A 3500 Ibm car moving at 25 mi/h is accelerated at a constant rate of 15ft/s^2^ up to a speed of 50…

Q: A stone is thrown up with a velocity of 70 m/s from the ground. While coming down, it strikes a…

A: Consider below figure for nomenclature of different positions of ball: From the data given in…

Q: A stone is thrown up with a velocity of 54 m/s from the ground. While coming down, it strikes a…

A: solved

Q: Question 3: A ball is thrown straight upward from ground level. Its initial velocity is 20 ft/s.…

A: Velocity V=20ft/s To Find Maximum height it would reach.

Q: Which of the following is TRUE for a stone released at a height of 30 m? The initial velocity of the…

A: When a stone is released from a height of 30 m then its velocity will change with respect to the…

Q: You have been chosen as the test subject for the newest attraction at Canada’s Wonderland. This…

A: Note - As per our company guidelines we are allowed to answer only the first three subparts in case…

Q: For figure as shown. A ball is thrown vertically upward. Determine 1- The height (h) 2- The time (t)…

Q: Blocks A, B, and C weigh 300, 150, and 50 N respectively. Neglecting Friction, the stiffness of the…

Q: A block weighing 96.6 lb is dropped from a height of 4 ft upon a spring whose modulus is 100 lb per…

Q: steel cable is used to pull an 800 kg car across the street. how much acceleration can the car have,…

A: Given , Mass of the car , M =800 Kg Maximum tension in the cable , T =2000 N

Q: You have been chosen as the test subject for the newest attraction at Canada’s Wonderland. This…

A: We will answer the first question since the exact on is not specified. Please resubmit the question…

Q: A small car of mass 2000-kg reared a stalled truck of mass 3000-kg on a straight road. The two…

A: Given Mass, M = 3000 kg m = 2000 kg Initial velocity, U = 0 u…

Q: Q2 A ball is thrown with a velocity of 30 m/sec at an angle of 30° above the horizontal. a. How long…

A: Given data: The velocity of the ball is v=30 ms The projection angle of the ball is θ=30°

Q: Activity 2. A hunter observed a bird flying overhead and estimated the height at 15m and its speed…

A: Write the given data with suitable variables. u=48 m/shmax=15 mub=20 m/s

Q: A projectile object reaches a height of 430 m, if it is fired straight up using a spring-loaded gun.…

A: given:hmax=430mangle fired θ=310

Q: A volleyball is hit when it is 4 ft above the groundand 12 ft from a 6-ft-high net. It leaves the…

A: Given:- h=4ft v=35 ft/sec angle = 27 net raised to 8 ft To find:- if the net is raised does this…

Q: A force F = (3X i + 4 j) N, X in meters, works on a particle Determine the effort by the force F in…

Concept explainers

Forming and Shaping

Metal forming is a category of metalworking process through which the material can be given the desired shape and size by subjecting it to plastic deformation, where the component undergoes bulk deformation process upon application of loads. Unlike the shearing and machining process, the material does not undergo up to a failure point as indicated in the stress-strain curve. Hence, the stresses induced during the forming process are greater than yield strength but less than the failure strength of the material. The process does not lead to the loss of material, so it can be said to be an economical process. During forming, the material is subjected to tensile forces, compressive forces, bending, and shearing loading conditions. The material should possess the property of ductility to undergo the forming process.

Question

A projectile object reaches a height of 303 m, if it is fired straight
up using a spring-loaded gun. Using the same gun, what is the
maximum height (m) that can be reached by the projectile if it
fired at an angle of 19 ° from the vertical?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A boy seated in a rapidly moving railroad car tosses a ball up intothe air. Will the ball come down in front of him; behind him; into his hand?What will happen when the car is accelerating in the forward direction? Goinground a curve?
5. A projectile is fired with an initial velocity of 60 m/s upward at an angle of 30 degrees to the horizontal from a point 80m above a level path. What horizontal distance will nit cover before it strikes the plain? a. 371 m b. 406 m c. 395 m d. 422 m (Solution Needed)
A motor is attached to a pulley of radius 10 cm and mass 1 kg. A belt passes through the pulley that connects to a hollow sphere with a radius of 40 cm and a mass of 2 kg (see figure below). If the final speed of the first round, the angular speed of the SPHERE is 3πrad/s:a) What is the final energy consumption of the motor? b) If the torque is constant, what is the magnitude of the motor's torque? that there is no friction in the axes of the sphere and that all energy consumed by the motor is transformed into work.
A volleyball is hit when it is 4 ft above the groundand 12 ft from a 6-ft-high net. It leaves the point of impact withan initial velocity of 35 ft / sec at an angle of 27 and slips by theopposing team untouched. Suppose that the net is raised to 8 ft. Does this change things? Explain.
Students are given two spherical balls made of different materials, but of identical mass and diameter to experiment with. Each ball is dropped from an initial height, h0. The “sad ball” comes to rest without visibly bouncing when it strikes the tabletop. The “happy ball” bounces up to a final height h, where h< h0 A fellow student wants to use one of the balls in a carnival game where cups are knocked over by a thrown ball. Which ball should they use, happy or sad? Why?
A. Estimate the typical maximum horizontal distance that a person can throw a baseball. (Answer: 40m) B. Based on your estimate from part A. What is the speed of the baseball as it leaves the hand? v0= ? (m/s) C. If you could throw the baseball straight up at the same speed as in part B, how high would it go? hmax = ? D. The value of g on Venus is 8.9 m/s2. What horizontal distance can you throw a baseball on Venus if you throw it with the same initial speed as in part B? Rmax=?
4. A concrete weight of 125 kg is released from standstill and a log of mass 200 kg is moved along an inclined area of 30° to the horizontal.When the concrete weight is moved down 5 m, find that 1. What is the speed of the log? 2. What is the movement time of the concrete drum?
As seen in the figure, it has mass m1 and v isa bullet passes through a pendulum of mass m2 and its velocity v / 2exit with. Pendulum "L" long and mass negligibleIt is suspended on the end of a rope that can be carried. Your pendulum is a verticalminimum velocity v to move on the circlewhat should be min V?
Ballistic Pendulum To apply conservation of energy and momentum. As shown, an object of mass m is fired with an initial speed v0 at a ballistic pendulum’s bob. The bob has mass M and is suspended by a massless rod of length L. After the collision, the pendulum’s bob and object stick together and swing to a maximum angular displacement θ. Find an expression for v0, the initial speed of the object fired. Express your answer in terms of some or all of the variables m, M, L, and θ and g, the acceleration due to gravity.
Pile drivers are heavy, metal hammer used to drive posts into the ground when constructing a building. One such pile driver with a mass of 200 kg was lifted 3 meters above the ground then released, driving a beam 8 cm into the ground. What is the speed and exerted force of the pile driver if a 60-N frictional force is exerted by the guide rails on the pile driver.
A shotputter can put a 7.26 kg shot q distance of 22 m. Assume that the shot is constantly accelerated over a distance of 2 m at an angle of 45 degrees nd is released atq height of 2 m above the ground. Estimate the weight that this athlete can lift with one hand.
Blocks A, B, and C are placed as in Fig. and connected by ropes of negligible mass. Both A and B weigh 25.0 N each, and the coefficient of kinetic friction between each block and the surface is 0.35. Block C descends with constant velocity. (a) Draw separate free-body diagrams showing the forces acting on A and on B. (b) Find the tension in the rope connecting blocks A and B. (c) What is the weight of block C? (d) If the rope connecting A and B were cut, what would be the acceleration of C?