A rigid tank (a closed system with fixed boundaries) with a volume of 0.45677 m³ contains 10 kg of refrigerant-134a vapor at 600 kPa. The refrigerant is now cooled. A) Determine the pressure when the refrigerant first starts to condense.

Q: n in the figure below, a closed, rigid tank fitted with a fine-wire electric resistor is filled with…

A:

Q: Three-tenth of kg of saturated liquid water in a closed system consisting undergoes a polytropic…

A:

Q: One pound of an ideal gas undergoes an isentropic process from 95.3 psig and a volume of 0.9ft3 to a…

A: The process which is carried out reversibly and adiabatically is termed as isentropic process. This…

Q: A piston-cylinder assembly, which contains gas, undergoes an expansion process for which the…

A:

Q: The volume of a 2 yards by 4 yards tank is 339.3 cubic ft. It contains air (R = 53.3 lbf-ft/lbm - R)…

A:

Q: Two pound of an ideal gas undergoes an isentropic process from 93.5 psig and a volume of 0.65 cu. ft…

A:

Q: 3. A gas initially 103.4 kPa and 0.0566 m3 undergoes a process to 620.36 kPa and 0.017 m3 during…

A:

Q: Helium expands polytropically through a gas turbine according to the process PV1.42 = C. If the…

A:

Q: Three-tenth of kg of saturated liquid water in a closed system consisting undergoes a polytropic…

A:

Q: Determine the volume, in ft3, of 2 lb of a two-phase liquid–vapor mixture of Refrigerant 134A at…

A: As per given question  We have to determine volume and pressure

Q: Can a room be cooled by keeping the refrigerator door open?

A: We can simply say "NO" for the above question. What is the reason behind it? The reason is very…

Q: 2.36 Ammonia is heated in the evaporator of a refriger- ation system from inlet conditions of 10°F,…

A: Given data: T1=10°Fx1=10%=0.1 Need to determine the change in enthalpy and volume.

Q: Questions 56-60 are based on the information given here. Air, as an ideal gas, undergoes a…

A:

Q: 3. In a hot water heating system, water heated to 95°C and then is pumped at the rate of 4 L/min…

A: Given data: Q˙=4 L/min=4×10-3×60 m3/hr=0.24m3/hrT1=95°CTR=85°C Need to determine the heat released…

Q: Apply the first law to a constant-volume process.

A:

Q: 5. An ideal compressor compresses 12 kg/min of air isothermally from 99 kPa and a specific volume of…

A:

Q: Air in an internal-combustion engine has 440°F, 150 psia, with a volume of 3 ft. Combustion heats it…

A: As per our guidelines we are supposed to answer only first 3 sub-parts. Kindly re post other parts…

Q: There are 2.27 kg/min of steam undergoing an isothermal process from 27.5 bar, bar. Determine the…

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: During a steady flow process, the pressure of the working substance drops from 200 to 20 psia, the…

A: Since you have posted a question with multiple sub parts, we solve first three sub parts for you. to…

Q: Exercises: 1) A rigid tank contains 50 kg of saturated liquid water at 90 C Determine the pressure…

A:

Q: Water is contained in a closed, rigid, 0.25 m3 tank at an initial pressure of 500 kPa and a quality…

A:

Q: Patm = 1 bar Piston

A: Engineering Model: The refrigerant R 134a is the closed system. R134a is slowly heated and the…

Q: person heats up a can of soup on a stove. If they do 200 joules of work on the soup by stirring it…

A: Given information: The work done on the soup by stirring (W) = - 200 J (“-ve” since work is done on…

Q: 2) Water in a pressure cooker is observed to boil at 175°C. What is the absolute pressure in the…

A:

Q: 3-76 A system consisting of 2 kg of ammonia undergoes a cycle composed of the following processes:…

A: Given data as per question Mass of ammonia =2 kg Initial pressure =10 bar Dryness fraction =0.6…

Q: Q2(i) how the pollution is caused by the solid industrial waste, industrial influent and industrial…

A: The industrial manufacturing and operation process results in many solid wastages like coal ash, red…

Q: You do 10,000 J of work on a system of 3.00kg water by stirring it with a paddle wheel. During this…

A:

Q: A 1-m3 rigid tank contains 10 kg of water (in any phase or phases) at 160°C. The pressure in the…

A: Given Data  Pressure P = ? Volume of rigid tank = 1m3 Temperature of water = 160 °C = 433K   Firstly…

Q: Refrigerant-134a initially at 8° C occupies a volume of 0.18 m³. Vapor occupies 58% of the volume.…

A: Given:R-134aT=8°CV=0.18 m3vg=0.58*V

Q: Water at 320C and 20bar undergoes a process within a rigid tank to a final pressure of 30bar.…

A:

Q: -1682 Btu. Determine (a) T2 and T3, (b) the work of the cycle, in Btu; (c) QA, (a) the thermal…

A: Given: !-2: Polytropic compression 2-3: Constant pressure heat addition 3-4: Constant volume heat…

Q: Q8) Consider the piston/cylinder arrangement shown. A frictionless piston is free to move between…

A:

Q: Two kg of helium operate on a three-process cycle where the processes are: constant volume (1-2);…

A: Given data:- Three process cycle P1 = 100 kpa T1 = (300 + x) X = 22 T1 = 322 k V1/V3 = 5   Find :-…

Q: 4.A quantity of air has a volume of 0.4 m3 at a pressure of 5 bar and a temperature of 80°C. It is…

A: given data-  volume of air = 0.4 m3  P1 = 5 bar T1  = 80 degree C P2 = 1 bar  to determine-…

Q: - There is argon in a piston-cylinder assembly with a volume of 0.065 m³ at a pressure of 560 kPa.…

A:

Q: If a piston-cylinder system has V = 0.8m^3 of saturated water vapor at P1 = 250 kPa, at which the…

A:

Q: 5-A 1.8-m3 rigid tank contains steam at 220°C. Onethird of the volume is in the liquid phase and the…

A: Given data The volume of the tank (V) = 1.8 m3 Temperature of steam (T) = 220oC Amount of volume…

Q: A 0.06 m³ piston-cylinder assembly with a pressure of 650 kPa contains argon. The piston is allowed…

A: Given: P1 = 650 kPa  V1 = 0.06 m3 V2 = 0.12 m3 T1 = T2 Answer:  Option B is correct.

Q: 6. Air in an internal-combustion engine has 440°F, 150 psia, with a volume of 3 ft. Combustion heats…

A: As per the policy i can answer only 3 subparts

Q: In the polytropic process pvn Constant if n = 1 the process is termed as

A:

Q: A container maintains a constant pressure of 40800 Pa while changing to a volume of 791 liters. If…

A:

Q: Determine the mass of cooling water in kg/s for a water cooled air-conditioning system that uses R22…

A:

Q: 3.1. A thin-walled metal container of volume V contains a gas at high pressure. Connected to the…

A: Given dataV = Volume of the containerTo prove a] W = -P0(V0-V)b] Calculate work done if the gas…

Q: Need help with these two homework problems 1) A tank contains a two-phase liquid–vapor mixture of…

A: Note: There are two question posted by the student and both question are different.we are bound to…

Q: Helium expands polytropically through a gas turbine according to the process PV^1.419 = C. If the…

A:

Q: Required information NOTE: This is a multi-part question. Once an answer is submitted, you will be…

A:

Q: A soup is set to boil. When the soup reaches 170°F, remove it from the heat and set it on the…

A: Initial soup temperature, Ti=170oFRoom Air temperature, T∞=80oFAfter time t=2min, soup temperature,…

Q: Water is contained in a closed, rigid, 0.25 m3 tank at an initial pressure of 500 kPa and a quality…

A: Since the water is saturated at the second state properties at that pressure should be calculated…

Free Body Diagram

The system of forces acting on a body tends to either rotate it or make the body undergo motion. In general, when an external agent exerts a force on a body, the body undergoes translational motion and rotational motion. The body has six degrees of freedom under the influence of that force. Here, three degrees of freedom are from the translational motion while the other three are from the rotation motion. However, sometimes the bodies are not allowed to undergo any motion and are fixed, under such conditions the body is said to be constrained.