A sample of Freon-12 (CF₂Cl₂) occupies 10.0 L at 322. K and 121.90 kPa. Find its volume at STP. Be sure your answer has the correct number of significant igures. Note: Reference the Conversion factors for non-SI units table for additional information. L 0 X

Q: The standard enthalpy change AH for the thermal decomposition of silver nitrate according to the…

A:

Q: A chemist dissolves 230. mg of pure barium hydroxide in enough water to make up 90. mL of solution.…

A:

Q: Problems 5.71.) How many moles of air are there in a bicycle tire with a volume of 2.36 L if it has…

A:

Q: The pH of a 0.30 M solution of a weak base B is 10.22. What is the K, of the base? Be sure your…

A:

Q: mixture of gaseous reactants is put into a cylinder, where a chemical reaction turns them into…

A: Given : Heat flows out of the system,Q = -266 KJ where negtive sign indicates heat is released by…

Q: The IR and NMR are for trans-p-anisalacetophenone, p-anisaldehyde, and acetophenone. What are the…

A: To Analyse the The IR and NMR are for trans-p-anisalacetophenone, p-anisaldehyde, and acetophenone.…

Q: 8. What volume (in mL) of 18.0 M H₂SO4 is needed to contain 2.45 g H₂SO4?

A:

Q: Order these chemical species by increasing pH of an 0.1 M aqueous solution of each. That is, imagine…

A: Answer: Stronger the acid weaker will be its conjugate base and vice versa. Also, stronger the acid…

Q: Draw the major organic product for the reaction shown. d Br 1. PPh3 2. n-butyllithium 3. H Select…

A: To solve this problem we have to complete the given organic chemical reaction.

Q: mist dissolves 744. mg of pure hydrochloric acid in enough water to make up 250. mL of solution.…

A: HCl is strong acid it dissociated fully in aqueous solution

Q: An argon ion laser puts out 4.8 W of continuous power at a of 532 nm. The diameter of the laser beam…

A: we have to calculate the number of photons that travel through the pinhole per second

Q: If the pH of a 0.05 M solution of an acid is 2.51, what does that tell you about the strength of the…

A: we have to determine the strength of the acid and determine its percent ionization

Q: If a solution has a [OH] of 2.6 x 10-2 M. what would be the [H3O+]? A B 1 x 10-7 M 2.6 x 10-¹2 M C)…

A:

Q: Express these non-exponentially, and choose the unit and prefix that works best: 1.9 x 10^-4 l 4 x…

A: Unit of volume in SI is liter(l) and CGS is ml Unit of time is Second (s) and mili second(ms) Unit…

Q: Enter your answer in the provided box. A 2.49-L container of vinegar contains 6.2% (w/v) of acetic…

A:

Q: Propose an efficient synthesis for the following transformation: 4 OH The transformation above can…

A:

Q: II. Rank the following compounds in order of increasing reactivity toward nucleophilic acyl…

A:

Q: The pH of a sodium acetate-acetic acid buffer is 4.40. Calculate the ratio CH₂COO [CH₂COOH] Note:…

A: Given, pH of the Sodium acetate acetic acid buffer = 4.40  [CH3COO-]/[CH3COOH] = ? Note:  Ka for…

Q: 4. How many grams of NaBr (molar mass = 102.9 g/mol)

A: Given data : Molar mass of NaBr=102.9 g/mol Volume = 700 mL = 0.7 Litres Since, 1 Litre = 1000mL…

Q: can you please provide the curved arrow mechanism for the first halogenation reaction of a positive…

A: The question is based on the concept of organic reactions. we need to write mechanism of Iodoform…

Q: SUBJECT : GENERAL CHEMISTRY TOPIC : THERMAL RUNAWAY 1. What are some of the ethical and social…

A: Since you have posted multiple question, we can solve only first question for you. If you want other…

Q: The ∆G° of vaporization for propane at 298 K and 1.00 atm is -6.602 kJ/mol. Calculate the pressure,…

A:

Q: How many moles of potassium hydroxide would have to be added to 125 mL of a 0.496 M nitrous acid…

A:

Q: Predict the product for the following reaction. NH₂ I NH₂ N=0 N=O + NH₂ IV II H₂SO4 N N NH₂ N III

A:

Q: uppose a 500. mL flask is filled with 1.9 mol of Cl₂, 1.5 mol of CHC13 and 0.60 mol of HC1. The…

A: Answer:- This question is answered by using the simple concept of calculation of equilibrium…

Q: Which of the following does not have DHof=0 at 25oC?          N2(g)         Cu(s)       Kr(g)…

A: Enthalpy of formation, also known as heat of formation, is the amount of heat energy released or…

Q: negative charge of it. What parameter is generally most important for determining its relative…

A: This question belongs to basic concept of chemistry.

Q: 6. Rank the following compounds in order of most basic to least basic. ex M 11 III IV

A:

Q: 6. Determine the theoretical molar mass of butane based upon the compound's formula (look it up) and…

A: The molar mass of a compound can be calculated by adding the atomic masses of the atoms. In the…

Q: Be sure to answer all parts. Using data from a table of thermodynamic data at 1 atm and 25°C,…

A:

Q: 5.101.) The X-15 and Mach 6 On November 9, 1961, the Bell X-15 test aircraft exceeded Mach 6, or six…

A: Combustion of Ammonia

Q: A beaker with 115 mL of an acetic acid buffer with a pH of 5.000 is sitting on a benchtop. The total…

A: Answer:- This question is answered by using the simple concept of buffer solution which resists the…

Q: Suppose a 500. mL flask is filled with 1.4 mol of H₂ and 1.1 mol of HC1. The following reaction…

A:

Q: 4NH3(g) 6H₂0 (1) 4NH3(g) + 302(g) = 2N2(g) 6H₂0 (1) AH = -1530 kJ + 502(g) = 4 NO(g) AH = -1170 kJ +…

A:

Q: Spectrum #2: 3-bromopropene PPM

A: The question is based on the concepts of Organic spectroscopy. we need to assign the peaks to the…

Q: or each chemical reaction listed in the table below, decide whether the highlighted atom is being…

A:

Q: The following represents the effect of time on the concentration during a reaction. The upper line…

A: Answer: Chemical equilibrium is a dynamic equilibrium and given question is based on the properties…

Q: A chunk of zinc weighing 18.6 grams and originally at 98.82 °C is dropped into an insulated cup…

A: Answer: In this question we have to calculate the final temperature of the system when hot piece of…

Q: Which combination of reagents would be a good choice to make a buffer with pH = 8.00? Choose all…

A: A buffer is a solution which resist any change in pH on adding a small amount of acid or base .   it…

Q: (Free-response style) Select all products of the reaction shown. 1.03 2. H2O -ОН ОН ОН 0=c=0 ?

A: Alkynes on reaction ozone followed by hydrolysis give carboxylic acids.

Q: 5 2926 to 29 Questions and Problems 263 5.65 Temperature Effects on Bicycle Tires A bicycle racer…

A:

Q: data for DHof (KJ/mol) provided below, calculate DHoRxn  for: N2O(g)  + 3H2(g)  ---> N2H4 (l)   +…

A:

Q: Determine the pH change when 0.120 mol KOH is added to 1.00 L of a buffer solution that is 0.424 M…

A: Answer: Buffer solution is a type of solution that resists the change in its pH on adding small…

Q: Spectrum #5: >70 3-pentanone 200 150 100 0 PPM

A: The question is based on the concept of organic spectroscopy. we need to identify the peaks in the…

Q: Acetic acid,  CH3COOH , has a  Ka of  1.8×10−5. Calculate  Kb  for the acetate ion.

A: Given, Ka for Acetic acid = 1.8 × 10-5 Kb for acetate ion = ? Note:  Kw = 1.0 × 10-14

Q: alculate the pH and percent ionization of a 0.940 M HNO₂ solution. ote: Reference the K of acids at…

A:

Q: Suppose a 250. mL flask is filled with 0.60 mol of N₂ and 0.40 mol of O₂. The following reaction…

A:

Q: 15) A 0.1-M aqueous solution of NaOCI KCI NH4CI A) NaOCI B) KCI C) NH4CI D) Ca(OAc)2 E) KCI and…

A: A 0.1M aqueous solution of..... Will have a pH of 7 at 25°C  given below with explanation.

Q: Given the reaction below, draw out the reaction mechanism (using Lewis structures and curved…

A:

Q: Acetylene (C₂H₂) gas is often used in welding torches because of the very high heat produced when it…

A: Given, Acetylene gas (C2H2) is often used in welding torches because of very high heat produced it…

Kinetic-Theory of Gases

Kinetic theory of gases is the model or method which was developed in the 19th century by Maxwell and Boltzmann. This is possible as the interatomic force which is of short-range forces that are important for solids and liquids can be neglected for gases. This theory or gas law gives a molecular interpretation of the pressure and temperature of a gas and is consistent with gas laws and Avogadro’s hypothesis. This theory is very helpful to correctly explain the specific heat capacities of many gases, kinetic energy and it also explains the transport qualities such as viscosity, thermal conductivity, and diffusion with molecular parameters. As stated in the kinetic-molecular theory, the temperature of a substance or gas particle is related to the average kinetic energy of the particles of that substance. When a substance is heated, some of the absorbed energy is stored within the particles, while some of the energy increases the motion of the particles, called average kinetic energy.